Power Acoustik OVN4-1600 - Manuals

Page 3 - INTRODUCTION; WARNING

- 2 - INTRODUCTION Power Acoustik amplifiers provide high-performance sound reinforcement for yourmobile audio equipment. Its versatility enables compatibility with optional Equalizers,Frequency Dividing Crossover Networks, and other audio processors in a customizedsystem. The Multi-Mode bridging ca...

Page 5 - Ground

- 4 - CONNECTING THE POWER (Fig.1) CAUTION: AS A PRECAUTION, DISCONNECT THE POWER WIRE FROM THE BATTERY WHILE MAKING THE POWER AND GROUND CONNECTIONS TO THE AMPLIFIER. 4/8 GAUGE (Thicker if planning for additional Amplifiers) wire is recommended for both the power and ground wires. 12 Gauge, for the...

Page 9 - MASTER MODE CONFIGURATION

- 8 - MASTER MODE CONFIGURATION OVN1-1800D / OVN1-3000D / OVN1-4000D / OVN1-5500D 1.Lowest Recommended Impedance is 1ohm mono.2.RCA Inputs are connected to both Left and Right channels3.Gain controls to be set match input source4.Line Output configured for stereo operation

Page 10 - STRAPPED CONFIGURATION

- 9 - STRAPPED CONFIGURATION OVN1-1800D / 3000D / OVN1-4000D / OVN1-5500D 1.Lowest Recommended Impedance is 2ohm Stereo2.RCA Inputs are connected to both Left and Right channels3.Gain controls to be set match input source4.Line Output is configured summed bridged which is ideal for subwoofer applica...

Page 12 - CHANNEL TRI MODE CONFIGURATION

- 11 - 2 CHANNEL TRI MODE CONFIGURATION OVN2-600 / OVN2-800 / OVN2-1250 / OVN2-1800 / OVN2-2200 HEAD UNIT FRONT PANEL 1.Lowest Recommended Impedance is 4ohm Stereo2.RCA Inputs are connected to both Left and Right channels3.Output configured for stereo operation

Page 13 - CHANNEL STEREO CONFIGURATION

- 12 - 4 CHANNEL STEREO CONFIGURATION OVN4-840 / OVN4-1200 / OVN4-1600 HEAD UNIT 1.Lowest Recommended Impedance is 2ohm Stereo2.RCA Inputs are connected to both Left and Right channels3.Gain controls to be set match input source4.Line Output configured for stereo operation

Page 14 - CHANNEL BRIDGED CONFIGURATION

- 13 - 4 CHANNEL BRIDGED CONFIGURATION OVN4-840 / OVN4-1200 / OVN4-1600 3CH4-8 Ohms 4CH 4-8 Ohms WOOFER 1CH4-8 Ohms WOOFER 2CH 4-8 Ohms HEAD UNIT 1.Lowest recommended impedance is 4ohm bridged mono2.RCA Inputs are connected to both Left &Right channels3.Line Output configured forstereo operation

Page 15 - CHANNEL TRI MODE CONFIGURATION

- 14 - 4 CHANNEL TRI MODE CONFIGURATION OVN4-840 / OVN4-1200 / OVN4-1600 HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo2.RCA Inputs are connected to both Left and Right channels3.Output configured for stereo operation

Page 16 - TROUBLE SHOOTING GUIDE

- 15 - TROUBLE SHOOTING GUIDE Check fuses in amplifier.Be sure Turn-on lead is connected Repair power wire or connections Check connections to radio Check fuse Inspect for short circuit or anopen connection. Reverse Left and Right RCA inputs to determine if it isoccurring before the amp.Check Tuner/...

Page 17 - SPECIFICATIONS

- 16 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) OVN2-600 600W 2 X 95W 2 X 120W 1 X210W 0.02% 10Hz-30kHz 4...

Page 19 - WARNINGS; the event of an accident. Don't mount this system so that the wire

- 18 - WARNINGS Investigate the layout of your automobile throughly before drilling or cutting any holes. Take care when to work near the gas tanks, lines, or hydraulic lines, and electrical wiring. Don't use power amplifier unmounted. Attach this system securely to the automobile to prevent damage,...