Power Acoustik PDR-654/PDR-654T - Manual

5 Installation/Un-installation Note Before starting installation of the unit, make sure the wiring is connected properly. Use only the parts provided with the unit to ensure proper installation. The use of unauthorized parts may cause malfunction. Install the unit where it does not get in the driver...

6 Wiring Connections NOTE: Never connect cable to the system while it is connected to the battery power. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. Note: To watch video the parking wire should be connected t...

7 Note: - Only use groundless loudspeakers. - Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loudspeakers at higher volumes. - Use 4~8 Ω (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit. - Do not use 3-cable loudspeakers ...

8 Panel Control 1. POWER/MUTE Button Press it to turn on the unit. When turned on, press it to mute the volume output, press and hold for 2 seconds to turn the unit off when the unit is on. (* Press any button on panel to turn on the unit) 2. VOL Knob Adjust the volume level by turning the knob cloc...

9 Remote control Remove Battery Note: „ The distance may vary according to the brightness of ambient light. „ If the remote is not used for an extended period of time, remove the battery to prevent possible damage from battery leakage and corrosion. „ Do not place any objects between the remote cont...

10 Main Menu The best way to discover the program is to explore each screen in detail, and to find out how to move from one to another. Read this chapter for a guided tour. Unit starts by displaying the Main menu. This is the root of the screen hierarchy, and you can simply access all features by ta...

12 ◆ TV Model (only for PDR-654T) To start TV mode, tap on TV button from main menu screen. Connect a TV antenna to the TV antenna jack of the unit. Select TV mode; press on the center of the touch screen, and following interface will be display: 1. In TV mode, press the play/ pause button on the RC...

13 z System Select this menu item is to set TV system: SECAM => NTSC =>PAL, press NTER button on the remote or tap the screen to select. z Audio Select this menu item is to set the TV sound system: When system setting PAL, press ENTER on remote or tap the screen button to select TV sound syste...

15 CALIBRATION procedure of the touch screen is described as below: When the target moves to another position, tap and hold at the center of the new target. Repeat each time to complete the calibration process. When the calibration has been completed, the device switches back to the previous operati...

16 Troubleshooting guide Symptom Cause Solution General No power The car ignition is not on. The fuse is blown. If the power supply is properly connected to the car accessory switch the ignition key to “ACC”. Replace the fuse. No sound Volume is in minimum. Wiring is not properly connected. Adjust v...

17 Specification General Power supply: 12 V DC Current consumption: Max. 10 A Maximum power output: 35W x 4 channels (Max.) Compatible formats: MP3/MP4/WMA/ JPEG/RMVB Dimensions (W x D x H) / weight: 178 x 165 x 100 mm / 1.6 kg Working temperature range: -10 ℃ - +60 ℃ TFT display Screen size: 6.5 in...