Philips RFX9200/37 - Manuals

6 How to Use the Extender 1.1 Taking a Closer Look Power led Front blaster Busy led Channel switch Extender ID dial Power input 4 IR outputs 4 dipswitches for IR outputs

EN G LI SH 7 How to Install the Extender 2 How to Install the Extender Make sure you have the following components: Extender, power adapter, Single IR emitters and optionally screws.The installation of the Extender consists of 4 main steps : • Configuring the Extender;• Connecting the Extender;• Pos...

8 How to Install the Extender Once you have found the best position, you can optionally mount the Extender onto a piece of furniture using screws. 1 Drive the screws into a rack, closet or another piece of furniture. Provide sufficient space to connect the power adapter and to slide the Extender in ...

EN G LI SH 9 How to Install the Extender 2.4 How to Install the Single IR Emitters The Single IR emitters can be used in combination with, or as an alternative to the front blaster. Plug the Single IR emitters into the Extender. Attach the Single IR emitters to a neighboring surface facing the IR re...

10 How to Do More 3 How to Do More 3.1 How to Set the Extender IDs The Extender can be used in several situations: out of sight or inside a closet.Since the Extender ‘communicates’ with the Remote Control, you must set the same Extender ID (identity) on both appliances. The settings depend on whethe...

3.4 How to Adjust the Power Level of the IR Outputs At the back of the Extender, there are 4 dipswitches, one for each IR Output. Use these dipswitches to configure the power level of the Single IR emitters. • Raise the power levels if there is a device near that might cause IR interference such as ...

5 Specifications The specifications and design of this product are subject to change without notice. EN G LI SH 13 Specifications Hardware Extender • 802.15.4 compliant RF technology• 2 LED indications for Power and Busy• Up to 16 extenders in a system• 4 addressable outputs for IR emitters• Positio...

14 Approbation & safety content RFX9200a Approbation & safety content RFX9200 FCC Compliancy This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:• This device may not cause harmful interference.• This device must accept any interference re...

15 Approbation & safety content RFX9200 Regulations According to R&TTE Declaration of Conformity: Hereby, Philips Consumer Electronics, BL Home Control declares under his responsibility that the product RFX9200 is in compliance with the essential requirements and other relevant provisions of...