Philips DCB2020/05 - Manuals

4 EN 2 Your Micro Music System Congratulations on your purchase, and welcome to Philips! To fully benefit from the suppor t that Philips offers, register your product at www.philips.com/welcome. Introduction With this product, you can: • enjoy audio from discs, USB storage devices, iPod, iPhone, iPa...

6 EN Overview of the main unit a Dock for iPod/iPhone/iPad b Disc compartment c • USB socket. d MP3-LINK • Connect an external audio device. e • Headphone socket. f • Turn on the product. • Switch to eco-power standby mode or normal standby mode. g IR sensor • Receive signals from the remote control...

8 EN 3 Before use Place the product Place the speakers at an angle of approximately 45 degrees from the listening position. Note • To avoid magnetic interference or unwanted noise, never place this product too close to any radiation devices. Connect speakers Note • Make sure that the colors of the s...

9 EN 1 Open the batter y compar tment. 2 Inser t 2 AAA batteries with correct polarity (+/-) as indicated. 3 Close the batter y compar tment. Note • If you are not going to use the remote control for a long time, remove the batteries. • Do not use old and new or different types of batteries in combi...

10 EN Set clock1 In standby mode, press and hold PROG / CLOCK SET to activate clock setting. » [CLOCK SET] (set clock) scrolls on the display, and then [CLOCK 24] (24-hour time format) is displayed with "24" blinking. 2 Press / or VOL +/- to select [CLOCK 24] or [CLOCK 12] (12- hour time for...

11 EN Make sure that the USB storage device contains playable audio contents. 1 Inser t the USB storage device into the ( USB ) socket. 2 Press USB to select the USB source. » Play star ts automatically. If the play does not start automatically, 1 Press PRESET/ALBUM / to select a folder. 2 Press / t...

12 EN 6 Play from iPod/ iPhone/iPad You can enjoy audio from iPod/iPhone/iPad through this product. Note • No audio output from the headphone socket in this situation. Compatible iPod/iPhone/iPad This product suppor ts the following iPod, iPhone and iPad models. • iPad 2 • iPad • iPhone 4 • iPhone 3...

13 EN Charge the iPod/iPhone/iPad When the product is connected to power, the docked iPod/iPhone/iPad star ts charging automatically. Tip • For cer tain iPod models, it may take up to a minute before the charging indication appears. Listen to the iPod/iPhone/ iPad1 Press DOCK to select the iPod/iPho...

14 EN Tune to the next FM radio station with sufficient signal strength at the lower/higher frequency : Press and hold / to star t the auto search. Tune to the FM radio station at a specific frequency : Press / repeatedly until the frequency digitals are displayed. Program FM radio stations automati...

15 EN 8 Other features Set sleep timer In working mode, press SLEEP / TIMER repeatedly to select a set period (in minutes). » When sleep timer is activated, is displayed. • To deactivate sleep timer, press SLEEP / TIMER again until disappears. Set alarm timer This product can be used as an alarm clo...

16 EN 9 Upgrade the firmware Note • Power supply must not be interrupted during the upgrade. • The firmware upgrade can only be available through the mini-USB por t on the back plate. • When the firmware upgrade succeeds, all settings are restored to the factor y default status. Register your produc...

17 EN 10 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 x 10 W RMS Frequency Response 40 Hz-20 kHZ, ±3 dB Signal to Noise Ratio > 77 dB MP3-Link Input 600 mV RMS 22 kohm Disc Laser Type Semiconductor Disc Dia...

18 EN USB playability information Compatible USB devices: • USB flash memor y (USB 2.0 or USB1.1) • USB flash players (USB 2.0 or USB1.1) • memor y cards (requires an additional card reader to work with this product) Supported formats: • USB or memor y file format FAT12, FAT16, FAT32 (sector size: 5...

19 EN 11 Troubleshooting Warning • Never remove the casing of this apparatus. To keep the warranty valid, never tr y to repair the product yourself. If you encounter problems when using this product, check the following points before requesting ser vice. If the problem remains unsolved, go to the Ph...