Peerless UST-WallArm3 - Manuals

Page 2 - WARNING; Tools Needed for Assembly

2 of 14 ISSUED:07-25-11 SHEET #: 125-9225-1 • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US customers please call Pee...

Page 3 - PARTS LIST

3 of 14 ISSUED:07-25-11 SHEET #: 125-9225-1 Some parts may appear slightly different than illustrated. Before you start make sure all parts listed are included with your product. F A E G H I J K B D C N L M PARTS LIST Description Qty. Part # A adapter plate assembly 1 056-2051 B extension bracket 1 ...

Page 4 - Wall Plate Location

4 of 14 ISSUED:07-25-11 SHEET #: 125-9225-1 Wall Plate Location Determine and mark the top edge of the screen active image. NOTE: Make sure to leave adequate space above the top edge of the active image for the wall arm and projector to be installed. Approximate dimension (23.0") Using your mark...

Page 5 - Installation to Single Wood Stud Wall; attached hardware and components.

5 of 14 ISSUED:07-25-11 SHEET #: 125-9225-1 Using wall plate ( D ) as a template, drill four 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach wall plate ( D ) to centers of wood studs using four #14 x 2.5" wood screws ( J ) shown in figure 1.1. Fasten wall arm bracket (...

Page 6 - Installation to Solid Concrete or Cinder Block; CUT

6 of 14 ISSUED:07-25-11 SHEET #: 125-9225-1 J K fig 1.4 CINDER BLOCK SOLID CONCRETE C Installation to Solid Concrete or Cinder Block • When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" (35 mm) of actual concrete thickness in the hole to be used for th...

Page 9 - DETAIL 1; NOTE; Installation using Wall Arm Bracket

9 of 14 ISSUED:07-25-11 SHEET #: 125-9225-1 DETAIL 1 Secure wall arm cap ( S ) into wall arm bracket ( C ) using two #8 x 3/8" sheet metal screws ( N ). Route projector cables as shown. Use two cable management brackets ( G ) as needed. NOTE : #8 x 3/8" sheet metal screws ( N ) will be short...

Page 12 - Pitch Adjustment; Loosen knobs on front of projector, and tighten; Roll Adjustment; Loosen knobs on left side of projector, and tighten; DETAIL 5

12 of 14 ISSUED:07-25-11 SHEET #: 125-9225-1 Pitch Adjustment Loosen knobs on front of projector, and tighten knobs on back of projector to pitch projector forward. Reverse for projector to pitch backward. SUPPORTING SURFACE NOT SHOWN FOR CLARITY Roll Adjustment Loosen knobs on left side of projecto...

Page 14 - Secure wall plate cover (; SUPPORTING SURFACE NOT

14 of 14 ISSUED:07-25-11 SHEET #: 125-9225-1 © 2009 Peerless Industries, Inc. All rights reserved. Peerless is a registered trademark of Peerless Industries, Inc. All other brand and product names are trademarks or registered trademarks of their respective owners. Secure wall plate cover ( E ) to wa...