Peerless PLA 60-S - Manuals

Page 2 - • Never exceed the Maximum UL Load Capacity of 175 lb (79 kg).; WARNING; Tools Needed for Assembly; • drill; Accessories

2 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-2 06-21-06 Read instruction sheet before you start installation and assembly. Installations: To Wood Stud Walls ...................................................................................................... page 4 To Concrete Walls .....................

Page 3 - Parts List

3 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-3 12-05-06 P D Before you start make sure all partslisted are included with your product. Parts List K M S C A E F H B J N R L Q Some parts may appear slightly different than illustrated. G O PLA 60 PLA 60-S PLAV 60 PLAV 60-S DESCRIPTION QTY. PART # PART # P...

Page 4 - Installation to Wood Stud Wall; Skip to step 2 on page 6.

4 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-2 06-21-06 • Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightenin...

Page 5 - Installation to Concrete Wall

5 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-3 12-05-06 IMPORTANT! Concrete must be 2000 psi densityminimum. Use wall plate (A), making sure that it is level, as atemplate to mark holes. The top mounting slots shouldbe located .36" above the desired screen center for PLA60 and PLA 60-S and .43"...

Page 6 - DETAIL 2

6 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-2 06-21-06 Snap four cable management clips (R) into top or bottom of arm assembly (C) as shown. Cable ties (S) are usedwith clips for cord management. Slide one mesh sleeve (T) over each cable. Use cable ties (S) to tighten mesh sleeves to cables. R S C 3 T...

Page 7 - • Do not overtighten screws! Overtightening may hinder; CAUTION

7 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-3 12-05-06 B I F GENERICADAPTER BRACKET Insert and tape carriage bolt (I) into top hole of pitch-roll assembly (B). Attach tilt-roll assembly to adapterbracket with four M10 socket screws (F). Tighten screws using 6 mm allen wrench (U). Note: Adapter bracket...

Page 8 - • After tilt is adjusted, all fasteners must be tightened.

8 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-2 06-21-06 Insert two M10 screws (F) into swivel box on arm assembly (C) as shown. Leave approx. 1/4" of exposedthread. .25" F • Use an assistant or mechanical lifting equipment to safely lift and position the plasma TV. WARNING • After tilt is adjus...

Page 9 - • To raise screen, turn socket screw shown in figure

9 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-3 12-05-06 FOR PLAV 60 ONLY: 7 7-1 ARTICULATING ARM PLASMA 8 Depending on the specific size & weight of the plasma,articulating swing arm may be angled at differentpositions, causing plasma to appear to lean sidewaysat different articulating positions. T...