ParaBody 848101 - Manuals

6 STEP 5: FIGURE 5 0 1 2 3 4 5 6 1/2 1/2 1/2 1/2 1/2 1/2 • Slide the CARRIAGE (5) over the UPRIGHT (2) as shown in FIGURE 5. • Assemble the STAND (3) to the UPRIGHT (2) as shown in FIGURE 5. 1 3 5 2 • Assemble the BASE (1) to the UPRIGHT (2) as shown in FIGURE 5.

STEP 6: FIGURE 6 • SECURELY assemble the BASE (1) to the UPRIGHT (2) using one 1/2 X 3” BOLT (27), two 1/2” WASHERS (21) (slide front washer INSIDE of tube) , and one 1/2” LOCK NUT (22). See FIGURE 6. • Insert one 3 X 2” END CAP (15) and one 2” SQ. END CAP (13) into the ends of the UPRIGHT (2) as sh...

8 STEP 7: FIGURE 7 0 1 2 3 4 5 6 1/2 1/2 1/2 1/2 1/2 1/2 • Route the CABLE (9) through the UPRIGHT (2) as shown in FIGURE 7. • SECURELY assemble three 3-1/2” PULLEYS (11) into the slots of the UPRIGHT (2) using three 3/8 X 2-3/4” BOLTS (25), six 3/8” FLANGE SPACERS (31), and three 3/8” LOCK NUTS (20...

9 STEP 8: FIGURE 8 23 3/8 X 2” 19 19 20 9 8 29 2 5 • Place one 3-1/2” PULLEY (11) into the loop of the CABLE (9) below the second and third PULLEY of the UPRIGHT (2) as shown in FIGURE 8. • LOOSELY assemble two 3/16 X 1-3/4 X 5-1/4” PLATES (8) to each side of the 3-1/2” PULLEY (11) using one 3/8 X 2...

10 STEP 9: FIGURE 9 23 3/8 X 2” 19 19 20 9 11 2 • Route the end of the second CABLE (9) through the slot on the UPRIGHT (2) then SECURELY assemble one 3-1/2” PULLEY (11) to the UPRIGHT (2) using two 3/8 X 2-1/2” BOLTS (24), two 3/8 X 3/8” SPACERS (30), four 3/8” WASHERS (19), and two 3/8” LOCK NUTS(...