Panasonic UB-5838C - Manuals

5 Trademarks • Microsoft, Windows and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. • IBM and AT are trademarks of International Business Machines Corporation in the United States, other countries, or both. • SD Log...

6 Features The UB-5838C / UB-5338C is a color electronic board. It is possible to output scanned hand-written text/diagrams as follows: ■ Storing on a USB Flash Memory Device Allows scanned hand-written text/diagrams to be stored onto a USB flash memory device. *1 *1 Not all USB flash memory devices...

7 Usin g Ins tal lation Before Y ou S ta rt Help Table of Contents Page Before You Start For Your Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12Part Names ...

8 For Your Safety To prevent severe injury and loss of life, read this section carefully before using the unit to ensure proper and safe operation of your unit. The following graphic symbols are used in this Operating Instructions manual. Power and Ground Connection CLASS 1 LED PRODUCT Denotes a pot...

For Your Safety 9 Before Y ou S ta rt Installation and Relocation Operating Safeguards Battery Do not attempt to repair the power cord or plug. If the power cord or plug is damaged or frayed, contact an authorized service representative for a replacement. Ensure that the plug connection is free of d...

For Your Safety 10 Power Installation and Relocation Operating Safeguards Battery When the unit is not used over an extended period of time, switch it Off and unplug it. If an unused unit is left connected to a power source for a long period, degraded insulation may cause electric shock, current lea...

For Your Safety 11 Before Y ou S ta rt This appliance is supplied with a moulded three pin mains plug for your safety and convenience.A 5 amp. fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5 amps. and that it is approved by A...

12 Precautions Installation • Do not install the unit where it may be exposed to direct sunlight, near heating equipment, or near air-conditioning vents as this may cause discoloration of the screen. • Do not install the unit in strong sunlight or strong lighting. Proper copying may become impossibl...

14 Part Names and Functions OFF ON Screen Film Frame Tray Stand Caster Caster with Lock Scanner Control Box Stand Control Panel Power Cord Battery Holder AC Inlet Power Switch SD Memory Card Cover SD Memory Card Slot USB Connector-A for USB Flash Memory Device Caster with Lock Caster USB Connector-B...

Part Names and Functions 15 Before Y ou S ta rt Control Panel Name Description Display When in standby mode, the display shows the current status of the unit as follows: • The time is shown on the top left corner of the display. • The scanning mode is shown on the icons on the left side of the displ...

16 Before Using This unit has the following functions concerning information security. Please use them properly. ■ Operation Password function It is possible to set a password in order to prevent a third party from operating the electronic board when the power turns on or after a certain period of t...

17 Usin g Scanning It is possible to output scanned images to a USB flash memory device, SD memory card, external printer, or computer.If multiple output devices are connected to this unit at the same time, the output destination will be selected in the following priority: 1. Computer2. USB flash me...

Scanning 21 Usin g 6 Press the Start/Stop Key. • The unit starts scanning and the image is printed. • The copying status is shown on the display. • After printing is finished, the Screen Erase Announce will be shown on the display. 7 After erasing the written text/diagrams on the screen, press the M...

23 Usin g Moving the Electronic Board 1 Make sure that the power switch is set to off ( ), and disconnect the power cord on both ends. • Make sure if there are any other devices connected to the unit. If so, disconnect them. 2 Release the lock A and fold back the fall- prevention extension legs B as...

24 Setting the Unit The following settings can be made using the control panel. Note • The item “Setting the number of copies” is displayed at the top of the set-up menu only when the printer is connected. It is possible to set the number of copies (1 to 9) when making multiple copies with a printer...

Setting the Unit 26 When images are scanned in full size mode, they are stretched and enlarged in order to utilize the entire space of a page. 1 Press the Set-up Key . • The set-up screen is displayed. 2 Press the Set-up Key ( ) repeatedly to select the following item. 3 Press the Advance Key ( ) re...

Setting the Unit 27 Usin g To prevent third parties from operating the unit, it is possible to set the unit to require a password to be entered when the power is turned on or after a certain period of time has passed. 1 Press the Set-up Key . • The set-up screen is displayed. 2 Press the Set-up Key ...

Setting the Unit 28 By performing the Test Print feature, it is possible to clean the printer head from this unit when scanned images are not printed correctly (ex. certain areas appear blank).Once the printer head is cleaned, the following pattern will be printed.If the pattern is printed as shown ...

29 Help Daily Care and Maintenance Always turn off the power switch and unplug the power plug when cleaning the unit. Gently wipe the screen film and unit with a water-dampened cloth that has been thoroughly wrung. Note • Use a neutral kitchen cleaner diluted with water for hard-to-clean stains. (If...

31 Help Troubleshooting To identify error message that are displayed on the control panel, refer to “Error Codes” on page 33.The following table lists solutions to problems that you may have concerning this unit as well as tips in avoiding these problems in the future.If problems still persist, call...

Troubleshooting 33 Help The following table describes the meaning of each error code which may appear on the display. Error Codes Error Code Cause Remedy See Page U103021~ U103025U403021~ U403025 The scanner or screen is in strong sunlight or strong lighting. Change the location of the unit or block...

36 Specifications Model No. UB-5838C UB-5338C General Power supply Refer to the name plate underside of the left lower frame Power consumption Refer to the name plate underside of the left lower frame External dimensions without stand(Height × Width × Depth) 1,125 mm × 1,998 mm × 224 mm (3 ' 8 19 / ...

Specifications 37 Help The printers are not included in the above specifications. For information regarding available USB flash memory devices, SD memory cards, and printers, refer to the following site: http://panasonic.co.jp/pcc/products/en/eboard/ub-5838c_info.htm *1 Letter size is for U.S.A. and...

38 Installation Manual (for qualified service personnel) Table of Contents page For Your Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Assembling the unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 ● Accessories for assembling. ...

40 Assembling the unit ■ Accessories for assembling The package includes the parts for setting up the unit shown below. Make sure that all of these parts are included in the package before proceeding. Note • Be sure to deliver the following accessories to the users. 1. Markers (Black, Red, Blue) . ....

Assembling the unit 41 Ins tal lation ■ Assembly 1 Assemble the wall-mounting fixture or optional stand. • If you are using a wall-mounting fixture, refer to “Wall-Mounting Construction” on page 48. • If you are using a stand, refer to “Optional Stand Assembly (UE-608035)” on page 53. 2 Remove the j...

45 Ins tal lation Electronic Board Operations Check ■ Before Operation Check 1 Wipe the screen film surface. • Soak a soft cloth with water, wring well, and wipe the screen film surface. Note • Do not wipe the screen film surface with paint thinner, benzene, or cleaners that contain abrasives. Doing...

47 Ins tal lation Repacking Perform Assembly Steps 2 through 13 on pages 41 - 44 in reverse to repack the unit and accessories. Use the joints to fasten the shipping box. Note • When handling the screen unit, grasp the side cover on either side of screen. Do not grasp the screen film surface, as thi...

48 Wall-Mounting Construction ■ Checking the Wall When mounting on a wall, consult with your building’s owner, caretaker or construction manager to determine if the wall strength is sufficient to install this unit. For safety, install this unit only after thoroughly understanding the type of walls, ...

Wall-Mounting Construction 49 Ins tal lation ■ Installing the Wall-Mounting Fixtures 1 Ensure that the wall is strong enough to support the unit. For UB-5838C: 1,373 N [140 k g f (309 lbf)] For UB-5338C: 1,275 N [130 k g f (287 lbf)] 2 Using the measuring tape and level, mark the 8 locations to inse...

Wall-Mounting Construction 51 Ins tal lation ■ Wall Types and Installation Procedures The method for attaching the wall-mounting fixtures to the wall will vary depending on the nature of the wall’s structure.Three available options are listed below.Other methods may be necessary depending on the wal...

Wall-Mounting Construction 52 ● Plasterboard walls Split-wing toggles (sold in stores) are needed. ● Wooden walls Wood screws (sold in stores) are needed. Insert the bolt through the hole in the wall-mounting fixture and attach the split-wing toggle. Then insert the split-wing toggle into the hole w...

53 Ins tal lation Optional Stand Assembly (UE-608035) ■ Included Parts Check that the following parts are included with the optional stand (UE-608035). *1 Use four screws and rivets when installing the electronic board. *2 The included wrench is necessary for tightening and loosening the screws, so ...

Optional Stand Assembly (UE-608035) 54 ■ Assembly Instructions 1 Assemble the fall-prevention extension legs. 2 Assembling the stand Locking casters side (rear) UB5838C-PJQXC0259ZA_mst.book 54 ページ ２００９年５月２６日　火曜日　午後２時５９分

Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste.For proper treatment, recovery...