Palsonic 3498 - Manuals - manualsarea.com

Page 3 - INSIDE THE PRESET DOOR

INSIDE THE PRESET DOOR STAND BY CHANNEL SELECTOR PREVIOUS CALL PICTURE/TIME MUTE CHANNEL SELECTOR VOLUME CONTROL TIME PICTURE SLEEP TV/AV TIMER 2 PRESET DOOR POWER SWITCH SPEAKER REMOTE SENSOR LED INDICATOR AUDIO INVIDEO INANTENNA - VOL + - CH + SKIP - MT + PRESET AUTO

Page 4 - INSTALLING BATTERIES:; OPERATING INSTRUCTIONS:

INSTALLING BATTERIES: 1. Remove the battery cover of Remote Control Unit.2. Insert two "AA" 1.5V batteries making sure the polarity (+ or -) of the batteries matches the polarity marks inside the unit.3. Close the battery cover. * When the Remote Control Unit is not used for a long time or t...

Page 6 - MANUAL TUNING; CHANNEL PRESET; AUTO PRESET; UHF; llllllllllllll; MFT

5 1. Press the PSET (PRESET ON/OFF) button on the front panel. The current band and channel position will be displayed on screen (in green).2. Press AUTO (AUTO PRESET) button, the appliance will search the signal of TV station in the order of VHFL, VHFH and UHF, as shown in the following, and memori...

Page 7 - VOLUME CONTROL

6 SKIP BUTTON: FUNCTION: When CHANNEL SELECTOR button is used to select channels, the channel will be skippedif they are set to "SKIP" mode. For example: Set 2~7 channels to "SKIP" mode, theprocedure of channel position increasing or decreasing. OPERATION: 1. Press PSET (PRESET ON/OF...

Page 8 - STAND BY BUTTON

Press STAND BY button, the appliance is set to stand by mode, the power indicatoris lightened.Press STAND BY button again, the appliance is turned on and the indicator is turned off. 7 AM 6 : 00 Press the PICTURE CONTROL button on the Remote Control Unit.The FUNCTION to be adjusted is selected in se...

Page 9 - CLOCK

SLEEP BUTTON (REMOTE CONTROL UNIT) Using SLEEP button allows you to have the appliance automatically turned off apredetermined time, and set the appliance to stand by mode. After the SLEEP function is set, the remaining time will be automatically displayed for 4seconds every ten minutes.* If you pre...

Page 10 - TIME; TIME

5. Press TIME button, the CLOCK indicator is green instead of red ON TIME function starts operating. Then press STAND BY button to set stand by mode.6. The appliance will be turned on automatically when the clock reaches your setting time. * The ON TIME operation will be cancelled if you switch off ...

Page 11 - TROUBLE SHOOTING GUIDE

TROUBLE SHOOTING GUIDE Many apparent malfunctions may be caused by slight misadjustment of regular controls orsome other equally similar simple causes. If any problem arises in the operation of your set, firstcheck through this list of symptoms and correction. Should the problem be unsettled, unplug...

Page 13 - PALSONIC CUSTOMER SERVICE

PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL:(02)9313 7111 FAX:(02)9313 7555 www.palsonic.com.au PALSONIC CUSTOMER SERVICE TELEPHONE AUSTRALIA: 1300 657 888 604-37823-10