Palmgren 9681061 - Manuals - manualsarea.com

Page 2 - GETTING STARTED; STRUCTURAL REQUIREMENTS; UNPACKING; SEE GENERAL SAFETY INSTRUCTIONS, CAUTIONS AND; SAFETY RULES; PROPOSITION 65 WARNING:; BE PREPARED FOR JOB; NOT; PREPARE WORK AREA FOR JOB

2 Palmgren Operating Manual & Parts List 9681061C GETTING STARTED STRUCTURAL REQUIREMENTS Make sure all supporting structures and load attaching devices arestrong enough to hold your intended loads. If in doubt, consult aqualified structural engineer. ELECTRICAL REQUIREMENTS The power supply to ...

Page 3 - SPECIFICATIONS; ATTACH ABRASIVE DISC TO ALUMINUM DISC; Figure 1 - Assemble and adjust disc table.

3 Palmgren Operating Manual & Parts List 9681061C SAFETY RULES (CONTINUED) TOOL SHOULD BE MAINTAINED • Always unplug tool prior to inspection. • Consult manual for specific maintaining and adjusting proce- dures. • Keep tool lubricated and clean for safest operation. • Remove adjusting tools. Fo...

Page 4 - ASSEMBLE BELT TABLE; INSTALLATION; POWER SOURCE; Figure 4 – 3-Prong receptacle

4 Palmgren Operating Manual & Parts List 9681061C ASSEMBLY (CONTINUED) ASSEMBLE BELT TABLE Refer to Figure 2. 1. Mount belt table to left side of belt housing using hex socket head screw and flat washer. 2. Set the belt table at right angle to the belt 3. Be sure gap between table and belt is 1/...

Page 5 - Wire Size; OPERATION; BELT INSTALLATION; Figure 5 – 2-Prong receptacle with adapter

5 Palmgren Operating Manual & Parts List 9681061C INSTALLATION (CONTINUED) WARNING: This work should be performed by a qualified electrician. A temporary 3-prong to 2-prong grounding adapter (See Figure 5)is available for connecting plugs to a two pole outlet if it is properlygrounded. Do not us...

Page 6 - MAINTENANCE

6 Palmgren Operating Manual & Parts List 9681061C OPERATION (CONTINUED) ADJUST BELT ASSEMBLY POSITION Refer to Figure 6, page 5. The sanding belt assembly can be adjusted from vertical to hori-zontal position. 1. Loosen the belt housing bolt that clamps belt housing to motor assembly. 2. Tilt be...

Page 7 - TROUBLESHOOTING; SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION

TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Motor will not start Motor will not start; fuses blown or circuit breakers tripped Motor fails to develop full power(power output of motor decreasesrapidly with decrease in voltage atmotor terminals) Motor overheats Motor stalls (resulting ...

Page 10 - NOTES

NOTES 10 Palmgren Operating Manual & Parts List 9681061C

Page 12 - WARRANTY; Failure to follow these

WARRANTY Palmgren warrants their products to be free of defects in material or workmanship. This warranty does not cover defects due directly orindirectly to misuse, abuse, normal wear and tear, failure to properly maintain the product, heated, ground or otherwise altered, or used for apurpose other...

Palmgren 9681061 - Manuals

Manuals:

User Manual Palmgren 9681061

Summary