Omron M3- Manuals

4 2. Preparation 2.1 Installing/Replacing the Batteries 1. Remove the battery cover. 2. Insert four “AA” batteries as indicated in the battery compartment and then replace the battery cover. Notes: • If the battery low symbol ( ) appears on the display, turn the unit off then replace all batteries a...

5 2. Preparation EN 2.2 Setting the Buzzer/ Date and Time 1. Press the button. 2. Set the Buzzer. 3. Set the monitor to the correct date and time before taking a measurement for the first time. 4. Press the O/I START button to store the setting. Notes: • If the batteries have been removed for 30 sec...

6 3. Using the Unit 3.1 Applying the Arm Cuff Remove tight-fitting clothing or tight rolled up sleeve from your upper arm.Do not place the cuff over thick clothes. 1. Insert the air plug into the air jack. 2. Put your arm through the cuff loop. 3. Position the arm correctly. The bottom edge of the c...

7 3. Using the Unit EN 3.2 How to Sit Correctly To take a measurement, you need to be relaxed and comfortably seated, under comfortable room temperature. No eating, smoking or exercising 30 minutes before taking a measurement. • Sit on a chair with your feet flat on the floor.• Sit upright with your...

8 3. Using the Unit 3.3 Taking a Reading Notes: • To cancel a measurement, press the O/I START button to turn off the unit and to release the air in the arm cuff.• Remain still while taking a measurement. 1. Press the O/I START button. The cuff will start to inflate automatically.The buzzer will sou...

9 3. Using the Unit EN 2. Remove the arm cuff. 3. Press the O/I START button to turn off the monitor. The monitor automatically stores the measurement in its memory.It will automatically turn off after five minutes. Important: • Recent research suggests that the following values can be used as a gui...

10 3. Using the Unit 3.4 Using the Memory Function The monitor automatically stores the result up to 60 sets. It can also calculate an average reading based on the measurements from the last three readings taken within 10 minutes. If there are only two readings in memory for that period, the average...

11 3. Using the Unit EN To delete all the values stored in memory When the memory symbol ( ) appears, first press the Memory button. Then while holding it down, press the O/I START button simultaneously for about 2-3 seconds. Note: You cannot partially delete the stored readings. HEM-7200-E(V)_A_M_m...

12 4. Troubleshooting and Maintenance 4.1 The Icons and Error Messages Error Display Cause Remedy Irregular or weak pulses are detected. Remove the arm cuff. Wait 2-3 minutes and then take another measurement. Repeat the steps in section 3.3. If this error continues to appear, contact your doctor. M...

13 4. Troubleshooting and Maintenance EN Note: The irregular heartbeat symbol ( ) may also be displayed with error messages. Cuff is under inflated. Carefully read and repeat the steps listed under section 3.3. Movement during measurement. Repeat measurement. Remain still and do not talk during meas...

14 4. Troubleshooting and Maintenance 4.2 Troubleshooting Problem Cause Remedy The reading is extremely low (or high). Arm cuff not applied correctly. Apply the arm cuff correctly. Refer to section 3.1. Movement or talking during measurement. Remain still and do not talk during measurement.Refer to ...

16 4. Troubleshooting and Maintenance 4.3 Maintenance To protect your unit from damage, please observe the following: • Do not subject the main unit and the cuff to extreme temperatures, humidity, moisture or direct sunlight.• Do not fold the cuff or tubing tightly.• Do not inflate the arm cuff over...

17 4. Troubleshooting and Maintenance EN 4.4 Storage Keep the unit in its storage case when not in use. 1. Unplug the air tube from the air connector. 2. Gently fold the air tube into the arm cuff. Note: Do not bend the air tube excessively. 3. Place the arm cuff and main unit in the storage case. D...

18 5. Optional Parts Using the Optional AC Adapter 1. Insert the AC adapter plug into the AC adapter jack on the rear side of the main unit. 2. Plug the AC adapter into an electrical outlet. To disconnect the AC adapter, unplug the AC adapter from the electrical outlet first and then remove the AC a...

19 EN 6. Technical Data Note: Subject to technical modification without prior notice. Product Description Digital Automatic Blood Pressure Monitor Model OMRON M3 (HEM-7200-E(V)/ HEM-7200-E8(V)) Display LCD Digital Display Measurement Method Oscillometric method Measurement Range Pressure: 0 mmHg to ...

22 7. Some Useful Information about Blood Pressure What is Blood Pressure? Blood pressure is a measure of the force of blood flowing against the walls of the arteries. Arterial blood pressure is constantly changing during the course of the heart’s cycle. The highest pressure in the cycle is called t...

24 7. Some Useful Information about Blood Pressure Classification of Blood Pressure by the World Health Organization The World Health Organization (WHO) and the International Society of Hypertension (ISH) developed the Blood Pressure Classification shown in this figure.This classification is based o...

5 1.Overview EN 1. Overview Main unit A. Display B. O/I START button C. MEMORY button D. SET button E. Battery compartment F. Air jack G. AC adapter jack (for optional AC adapter) B D A C E G F 7051_E.book Page 5 Friday, July 15, 2005 4:36 PM

6 1.Overview Arm Cuff If air starts to leak from the arm cuff, please replace with a new one. (Refer to Chapter 7 “Optional Parts”.) H. Arm cuff (Medium cuff: arm circumference 22-32 cm) I. Air Tube J. Air Plug I H J 7051_E.book Page 6 Friday, July 15, 2005 4:36 PM

8 2.Preparation 2. Preparation 2.1 Installing/Replacing the Batteries 1. Turn the main unit upside down. 2. Slide the battery cover in the direction of the arrow while pressing the ribbed part of the cover. 3. Install or replace four “ AA ” size batteries so that the + (positive) and - (negative) po...

9 2.Preparation EN Battery Life & Replacement If the battery low symbol ( ) appears on the display, replace all four batteries at the same time. - When the battery low symbol ( ) starts to blink, you will still be able to use the unit for a short while. You should replace the batteries with new ...

10 2.Preparation 2.2 Setting the Date and Time Your blood pressure monitor automatically stores up to 42 measurements values in its memory and calculates an average value based on the three most recent measurements taken within 10 minutes of the last reading. (If there are only two readings in memor...

13 2.Preparation EN 2.3 Adjusting the Settings Modes You can modify the options for the various settings of your unit. This is done by pressing the SET button to select a setting, then pressing the MEMORY button to select the options for that setting. After selecting a setting, press the O/I START b...

14 3.Using the Unit 3. Using the Unit 3.1 How to Sit Correctly When Taking a Measurement You can take a measurement on either your left or right arm. Notes: • Measurements should be taken in a quiet place and you should be in a relaxed, seated position. Make sure that the room is not too hot or cold...

15 3.Using the Unit EN Notes: • Correct posture during measurement is necessary to get accurate results. • You should also try to measure your blood pressure at the same time each day. (Within 1 hour after waking up is recommended.) Incorrect Posture These situations could lead to higher blood press...

16 3.Using the Unit 3.2 Applying the Arm Cuff Be sure to wrap the arm cuff correctly so that you get accurate results.Measurements can be taken in light clothing. However, please remove thick clothes, such as sweaters, before taking a reading. 1. Insert the air plug into the air jack on the left sid...

17 3.Using the Unit EN 3. Position the arm correctly. Taking measurements on the right arm Apply the cuff so that the air tube is at the side of your elbow.• Be careful not to rest your arm on the air tube, or otherwise restrict the flow of air to the cuff. • The cuff should be 1 to 2 cm above the e...

18 3.Using the Unit 3.3 Taking a Reading 1. Press the O/I START button to turn on the unit. Sit in a chair with your feet flat on the floor and place your arm on a table so that the cuff will be at the same level as your heart. Keep still and do not talk during measurement. During measurement, the b...

20 3.Using the Unit • Your blood pressure monitor includes an irregular heartbeat feature. Irregular heartbeats can influence the results of the measurement. The irregular heartbeat algorithm automatically determines if the measurement is usable or needs to be repeated. If the measurement results ar...

22 3.Using the Unit 3.4 Instructions for special conditions If your systolic pressure is known to be more than 220 mmHg, press and hold the O/I START button until the arm cuff inflates 30 to 40 mmHg higher than your suspected systolic pressure. 1. Press the O/I START button to turn the unit on. Meas...

23 3.Using the Unit EN 3.5 Using the Memory Function This unit has a memory capable of storing 42 sets of readings. Every time you complete the measurement, the unit automatically stores the blood pressure and pulse rate. If there are three readings within 10 minutes of the last reading, the average...

25 3.Using the Unit EN To Delete All the Values Stored in Memory You cannot delete individual stored readings, all the readings in the unit will be deleted. 1. To delete stored readings, first press the MEMORY button. Then while holding it down, press the O/I START button simultaneously for about 2-...

26 4.Quick Reference Guide 4. Quick Reference Guide If you are using this device for the first time, please read carefully chapter 3 of this instruction manual. To help ensure a reliable reading, avoid eating, smoking, or exercising for at least 30 minutes before taking a measurement. Note: Remove a...

27 5.Handling Errors and Problems EN 5. Handling Errors and Problems 5.1 Error Messages Error Display Cause Remedy Cuff is under inflated. Carefully read and repeat the steps listed under section 3.4. Movement during measurement Repeat measurement. Remain still and do not talk during measurement.Ref...

29 5.Handling Errors and Problems EN 5.2 Troubleshooting Problem Cause Remedy The reading is extremely low (or high). Arm cuff not applied correctly. Apply the arm cuff correctly. Refer to section 3.2. Movement or talking during measurement. Remain still and do not talk during measurement.Refer to s...

31 6.Maintenance and Storage EN 6. Maintenance and Storage Maintenance To protect your unit from damage, please observe the following: • Do not subject the main unit and cuff to extreme temperatures, humidity, moisture or direct sunlight. • Do not fold the cuff or tubing tightly. • Do not inflate th...

32 6.Maintenance and Storage Calibration and Service • The accuracy of this blood pressure monitor has been carefully tested and is designed for a long service life. • It is generally recommended to have the unit inspected every two years to ensure correct functioning and accuracy. Please consult yo...

33 6.Maintenance and Storage EN Storage Keep the unit in its storage case when not in use. 1. Unplug the air tube from the air jack. 2. Gently fold the air tube into the arm cuff. Note: Do not bend the air tube excessively. 3. Place the arm cuff and main unit in the storage case. Do not store the un...

34 7.Optional Parts 7. Optional Parts Using the Optional AC Adapter Insert batteries into the battery compartment even when using the AC adapter. Notes: • Never unplug the power cord with wet hands.• Use only the original AC adapter designed for this unit. Use of unsupported adapters may damage the ...

35 8.Technical Data EN 8. Technical Data Note: Subject to technical modification without prior notice • Disposal of this product and used batteries should be carried out in accordance with the national regulations for the disposal of electronic products. This device fulfils the previsions of EC dire...

36 8.Technical Data Subsidiary OMRON HEALTHCARE UK LTD. Opal Drive Fox Milne, Milton Keynes MK 15 0DG, United Kingdom Subsidiary OMRON Medizintechnik Handelsgesellschaft m.b.H. Windeckstraße 81a D-68163 Mannheim, Germany www.omron-medizintechnik.de Subsidiary OMRON SANTÉ FRANCE 14, rue de Lisbonne, ...

37 9.Some Useful Information about Blood Pressure EN 9. Some Useful Information about Blood Pressure What is Blood Pressure? Blood pressure is a measure of the force of blood flowing against the walls of the arteries. Arterial blood pressure is constantly changing during the course of the heart's cy...