Page 2 - Injury by dropping onto the body from a height.; WARNING
E-2 E-1 Disclaimer ● Unauthorised copying of this manual in part or in full, except for privateuse, is prohibited. Unauthorised reproduction is strictly prohibited. ● OLYMPUS CORPORATION shall not be responsible in any wayfor lost profits or any claims by third parties in case of any damageoccurring...
Page 3 - Examples for foreign matter sticking to the O-ring
E-4 E-3 Batteries ● To supply power to the electronic flash, we recommend you uset w o L R 6 a l k a l i n e b a t t e r i e s , t w o l i t h i u m b a t t e r i e s , t w o N i - M nbatteries, two Ni-Mh batteries or two Ni-Cd batteries. ● Keep the batteries’ contacts away from damp and humidity to...
Page 4 - Handling the Product; Chemicals which cannot be used Explanation
E-6 E-5 Handling the Product ● Use or storage of the product at the following locations may caused e f e c t i v e o p e r a t i o n , d e f e c t s , t r o u b l e , d a m a g e , f i r e , i n t e r n a lclouding, or water leakage. Always avoid these locations. Places where high temperatures exist...
Page 5 - Contents
E-8 E-7 Disclaimer ⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯ E-1 Please read the following before using the product ⋯⋯⋯⋯⋯ E-1 For safe use ⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯ E-1 Batteries ⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯ E-3 For Prevention of Water Leakage Accidents ⋯⋯⋯⋯⋯⋯⋯⋯ E-4 Handling the Product ⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯ E-5 Contents ⋯⋯⋯⋯⋯⋯...
Page 9 - Advance Check of the Case; CAUTION
E-15 2. Advance Check of the Case Advance test before use This Case has been the subject of thorough quality control for theparts during the manufacturing process and thorough functioninspections during the assembly. In addition, a water pressure testis performed with a water pressure tester for all...
Page 11 - • Hairs, fibers, and other narrow items are not very apparent,; • After inserting the flash into the case, confirm that the mode; • Seal the Case by turning both buckle lock levers down in; Has the O-ring at the Case opening part been installed properly?
E-19 E-20 Perform the final checks. Visual Inspection After sealing the Case, check the sealing part of front and rear lidvisually to confirm that the O-ring is not twisted or out of the grooveand that no foreign matter has been caught. : • Hairs, fibers, and other narrow items are not very apparent...
Page 12 - Taking photos underwater; Setting the flash mode; This case enables underwater TTL AUTO shooting.; Underwater TTL AUTO shooting; • When this case is used, the AUTO mode of the electronic; • For the camera’s iris setting and standard shooting range,
E-22 4. Taking photos underwater Setting the flash mode This case enables underwater TTL AUTO shooting. Underwater TTL AUTO shooting Turn the case’s mode dial knob to set theelectronic flash to the TTL AUTO mode.For details including the digital cameras e t u p , r e f e r t o t h e c a m e r a a n ...
Page 13 - Handling After Shooting; Wipe off any waterdrop.
E-24 Removing the electronic flash Carefully open the case, loosen theshoe lock dial of the flash and, whileholding the mode dial knob on thecase firmly, slide the flash out of thecase’s hot shoe. : • After opening the case, always put it down it with the O-ring side face-up. Otherwise, dirt or othe...
Page 14 - Maintaining the Waterproof Function; • Be sure to attach the cap to the TTL cable connector after
E-26 6. Maintaining the Waterproof Function Remove the O-ring. Open the Case and remove the O-ring from the Case.Removal of the O-ring Insert the O-ring removal pick between the O-ring and the wall ofthe O-ring groove. Move the tip of the inserted pick under the O-ring. (Take care notto damage the O...
Page 19 - Specifications; MEMO; Diver's Insurance Guide
E-36 Olympus digital camera andElectronic Flash (FL-20) Available models Dimensions E-35 Specifications ❈ We reserve the right to change the external appearance and thespecifications without notice. Pressureresistance Depth of up to 40 m Main materials Main body : Transparent polycarbonate Buckle : ...