Napoleon GDI-30P - Manuals - manualsarea.com

Page 2 - TABLE of CONTENTS; PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE

2 W415-0384 / D / 09.13.05 WARNING • The fireplace insert is a vented gas-fired heater. Do not burn wood or other materials in this fireplace insert.• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition...

Page 4 - stallation in a mobile home that is permanently positioned; GENERAL INSTRUCTIONS

4 W415-0384 / D / 09.13.05 cle. The grounding prong must not be removed from thecord plug. FOR YOUR SATISFACTION, THIS FIREPLACE INSERTHAS BEEN TEST-FIRED TO ASSURE ITS OPERATIONAND QUALITY! Minimum inlet gas supply pressure is 4.5 inches watercolumn for natural gas and 11 inches water column forpro...

Page 5 - Provide adequate ventilation air.; Ensure that existing chimney cleanouts fit properly.; INSTALLATION

5 W415-0384 / D / 09.13.05 WHEN HOT! If the glass is not kept clean permanentdiscolouration and / or blemishes may result. Provide adequate ventilation air. Provide adequate accessibility clearance forser vicing and operating the fireplace inser t. Never obstruct the front opening of the fire-place ...

Page 6 - FIGURE 2; FIGURE 4; WIRE SIZE; INSERT VENT CONNECTION; FIGURE 3; ensuring that the marked exhaust liner is

6 W415-0384 / D / 09.13.05 FIGURE 2 Move the insert close to its final position inside the wood-burning fireplace. This unit is equipped with 4 levellingscrews located in the four inside corners beneath the logsupport. Level using the levelling screws to eliminate rock-ing or excessive noise when th...

Page 7 - TABS; FINISHING; Fine; logs glow; logs available from your Napo-; OPTIONAL CHARCOAL EMBERS; PHAZER; logs and glowing embers exclusive to Napoleon Fire-; LOG PLACEMENT; Position the notch located on the end of the center log

7 W415-0384 / D / 09.13.05 TABS FINISHING Randomly place the charcoal embers along the front andsides of the log support tray in a realistic manner. Fine dust found in the bottom of the bag should not be used. Tear the embers into pieces and place along the front rowof ports covering all of the burn...

Page 8 - PURGE THE GAS LINE WITH THE GLASS DOOR OPEN.; OPERATION / MAINTENANCE; OPERATING INSTRUCTIONS; FIGURE 7; MANTLE WIDTH; This can vary according to the mantle depth.; FIGURE 6; DOOR OPERATION; DOOR LATCH

8 W415-0384 / D / 09.13.05 Purge all gas lines with the glass door open. Assurethat a continuous gas flow is at the burner before clos-ing the door. Allow several minutes (5-15) for the flameto stabilize after ignition. Do not operate the main burner of the in-sert with the door opened. When lit for...

Page 9 - MAINTENANCE

9 W415-0384 / D / 09.13.05 7. Depress slightly and hold gas knob while lighting the pilot with the push button ignitor. Keep knob depressed for oneminute, then release. If pilot does not continue to burn, re-peat steps 3 through 7. 8. With pilot lit, depress and turn gas knob counter-clock- wise to ...

Page 10 - FIGURE 9; NOTE: Check the blower gasket for damage. Replace if; Air shutter adjustment must only be done by a qualified; ADJUSTMENTS; PILOT BURNER ADJUSTMENT; BLOWER REPLACEMENT INSTALLATION; FIGURE 8

10 W415-0384 / D / 09.13.05 FIGURE 9 BLOWER ACCESS COVER 1. Turn off the electri- cal power and the gassupply to the fireplaceinsert. 2. Open the glass door and remove the logsand fibre bricks, if in-stalled. 3. Remove the blower access cover held on with 4 screws. 4. Remove the blower mounting plat...

Page 11 - REPLACEMENTS; REPLACEMENT PARTS

11 W415-0384 / D / 09.13.05 # PART # DESCRIPTION 1 GZ552 REPLACEMENT BLOWER 2 W725-0035 NATURAL GAS VALVE 2 W725-0026 PROPANE GAS VALVE 3 W455-0019 #43 NATURAL GAS BURNER ORIFICE 3 W455-0003 #54 PROPANE GAS BURNER ORIFICE 4 W357-0001 PIEZO IGNITER 5 W680-0004 THERMOPILE 6 W680-0005 THERMOCOUPLE 7 W0...

Page 12 - a fast acting thermocouple supplied by Wolf Steel Ltd.

12 W415-0384 / D / 09.13.05 * WARNING: This is a fast acting thermocouple. It is an integral safety component. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.

Page 13 - TROUBLE SHOOTING GUIDE; SYMPTOM

13 W415-0384 / D / 09.13.05 Main burner goes out;pilot stays on. Pilot flame is not large enoughor not engulfing the thermopile. Thermopile shorting Remote wall switch wire is toolong, too much resistance inthe system Faulty thermostat or switch - turn up pilot flame.- replace pilot assembly. - clea...

Page 15 - This fireplace must be serviced annually depending on usage.

15 W415-0384 / D / 09.13.05 W olf Steel Fir eplace Ser vice Histor y This fireplace must be serviced annually depending on usage. Date Service T e chnician Name Service Performed Special Concerns Dealer Name

Page 16 - NOTES