Napoleon GD82NT - Manuals - manualsarea.com

Page 2 - WHAT TO DO IF YOU SMELL GAS; WARNINGS & SAFETY PRECAUTIONS

W45-0536 / C / 09.06.06 WHAT TO DO IF YOU SMELL GAS Do not touch any electrical switch. If you cannot reach your gas supplier, call the fire department. Do not try to light any appliance. Do not use any phone in your building. Immediately call your gas supplier from a neighbor's phone. Follow the ga...

Page 3 - TABLE of CONTENTS; PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE

3 W45-0536 / C / 09.06.06 PG2-6 INTRODUCTION Warnings and Safety Precautions Warranty Dimensions General Instructions General Information Care of Glass & Plated Parts 6-10 vENTING Vent lengths Venting Specifications Air Terminal Locations 11-16 INSTALLATION/FRAMING Wall & Ceiling Protection ...

Page 4 - NAPOLEON GAS FIREPLACE PRESIDENT’S LIFETIME LIMITED WARRANTY; napoleon will; CONDITIONS AND LIMITATIONS

4 W45-0536 / C / 09.06.06 ALL SPECIFICATIONS AND DESIGNS ARE SUBjECT TO CHANGE WITHOUT PRIOR NOTICE DUE TO ON-GOING PRODUCT IMPROVEMENTS. NAPOLEON® IS A REGISTERED TRADEMARK OF WOLF STEEL LTD. PATENTS U.S. 5.303.693.80 - CAN. .073.4, .08.95. © WOLF STEEL LTD. napoleon products are manufactured under...

Page 5 - inches; FOR YOUR SATISFACTION, THIS FIREPLACE HAS BEEN; figure 1; THIS gAS FIREPLACE SHOULD BE INSTALLED AND SER; GENERAL INSTRUCTIONS

5 W45-0536 / C / 09.06.06 Objects placed in front of the fireplace must be kept a minimum of 48” from the front face of the unit. Minimum clearance to combustible construction from fireplace and vent surfaces: f ireplace framing - 0” to stand-offs (top, rear and sides) fireplace finishing - 4” from ...

Page 6 - figure 3; CARE OF GLASS, AND PLATED PARTS; or napoleon rigid; vENTING; vENTING LENGTHS & AIR TERMINAL; or a

6 W45-0536 / C / 09.06.06 24" 16" 8" Expansion / contraction nosies during heating up and cooling down cycles are normal and are to be expected. Change in flame appearance from “HI” to “Lo” is more evident in natural gas than in propane. Do not use abrasive cleaners to clean plated parts...

Page 7 - figure 4; when; figure 5; horizontal vent run Plus offset in feet; DEFINITIONS; TOP EXIT / HORIzONTAL TERMINATION

7 W45-0536 / C / 09.06.06 vertical rise in feet v T figure 4 when (H T ) < (v T ) Simple venting configuration (only one 90° elbow) See graph to determine the required vertical rise v T for the required horizontal run H T . For vent configurations requiring more than one 90° elbow, the following ...

Page 8 - figure 6; required; figure 8; and V

8 W45-0536 / C / 09.06.06 H 2 H 1 v 1 90° See graph to determine the required verti-cal rise V T for the required horizontal run H T . v 1 = v T = 6 ft H 1 = 3 ft H 2 = 5 ft H R = H 1 + H 2 = 3 + 5 = 8 ft H O = .03(two 90° elbows - 90°) = .03(80° - 90°) = .7 ft H T = H R + H O = 8 + .7 = 0.7 ft H T ...

Page 9 - figure 9; TOP EXIT vERTICAL TERMINATION; un; TOP vERTICAL TERMINATION

9 W45-0536 / C / 09.06.06 required vertical rise in feet v T horizontal vent run Plus offset in feet H T when (H T ) < (v T ) figure 9 For vent configurations requiring more than zero 90° elbow (top exit) or one 90° elbow (rear exit), the following formulas apply: Formula 1: H T < v T Formula ...

Page 11 - vERTICAL INSTALLATION; imPOrTANT: For optimum performance, The stove pipe; HORIzONTAL INSTALLATION; Horizontal termination:

W45-0536 / C / 09.06.06 This application occurs when venting through a roof. Installation kits for various roof pitches are available from your Napoleon dealer. See Accessories to order the specific kit required. 1. Determine the air t e r m i n a l l o c a t i o n , c u t and frame 9½ or ½ inch ope...

Page 12 - if the attic space is; USING FLEXIBLE vENT COMPONENTS; HORIzONTAL AIR TERMINAL INSTALLATION

W45-0536 / C / 09.06.06 Spacers are attached to the inner flex liner at predetermined intervals to maintain a 1-1/4” air gap to the outer flex liner. These spacers must not be removed. 1. Fasten the roof support to the roof using the screws provided. The roof support is optional. In this case the ve...

Page 13 - tapping screws. Repeat using 7” piping.; FIREPLACE vENT CONNECTION; USING RIGID vENT COMPONENTS

3 W45-0536 / C / 09.06.06 The vent system must be supported approximately every 3 feet for both vertical and horizontal runs. Use Wolf Steel vent spacers or equivalent every 3 feet and either side of each elbow to maintain the minimum ¼” clearance between the outer and inner vent pipes. Use Wolf Ste...

Page 14 - Proceed once the vent installation is complete.; vERTICAL vENTING INSTALLATION

4 W45-0536 / C / 09.06.06 flue collar restrictor plate top of tHe firebox Proceed once the vent installation is complete. Note : All gas connections must be contained within the fireplace when complete. 1. The fireplace is designed to accept a ½” gas supply line. The fireplace is equipped with a ½” ...

Page 15 - WARNING; FRAMING; CLEARANCE TO COMBUSTIBLES; MAINTAIN THESE MINIMUM CLEARANCES TO COM

15 W415-0536 / C / 09.06.06 WARNING Facing and/or ﬁnishing material must never overhang into the ﬁreplace opening. Do not distort or force the frame kit components. When using a rough ﬁnish materi - al (i.e.; stone), maintain a ¼” - ½” border from the framing components. NON-COMBUSTIBLE FINISHING MA...

Page 16 - MANTLE CLEARANCES; do NOT use the fireplace if any part has been under; Permanently framing the fireplace with an enclosure, requires; ELECTRICAL CONNECTION; HARD WIRING CONNECTION; AUXILIARY

6 W45-0536 / C / 09.06.06 figure 32 MANTLE CLEARANCES 0 3 4 7 8 9 11 13 1 2 5 6 7 10 12 H E I G H T M A N T L E MANTLE WIDTH Combustible mantle clearance can vary according to the man-tle depth. Use the graph to help evaluate the clearance needed. do NOT use the fireplace if any part has been under ...

Page 17 - The glass door is secured to the top front edge of the firebox.; Before installing the logs, you must first remove the log ship; LOG SHIPPING BRACKET; FINISHING; decorative brick panels must be installed before the logs.; LOG PLACEMENT; GLOWING EMBERS

7 W45-0536 / C / 09.06.06 4. Place log #4 with the charred branch facing inward. Position the pin in log #4 into the hole on the right of log #. 5 . P l a c e l o g # 5 s o the locating hole on the botttom of the log sits on the screw and spacer. 6. F i n a l l y, a l i g n t h e rectangular peg on ...

Page 18 - BLOWER REPLACEMENT; Turn off the power to the fireplace.; NIGHT LIGHT REPLACEMENT; protect with a clean dry cloth.; THe FireBOx mUST Be SeAled.

8 W45-0536 / C / 09.06.06 BLOWER MOUNTING PLATE REMOVE 4 SCREWS BLOWER REPLACEMENT The Napoleon PARK AVENUE comes equipped with a heat circulating blower. The blower is pre-wired and is controlled by the remote control supplied with the unit. For control details, see operation. Pg. . drywall dust wi...

Page 19 - Rest the bottom edge of the rear panel on top; STEP; DECORATIvE BRICK PANEL INSTALLATION

9 W45-0536 / C / 09.06.06 . Carefully remove the glass door and all logs. (Refer to the installation manual) . Remove the two screws holding the front portion of the rear air deflector . Remove the pilot shield by removing the two screws as illustrated. (Fig. 4) 3. Remove the 3 screws holding the bu...

Page 20 - NOTE: A 1/4” gap must be maintained between; AFK / WI FACE KIT INSTALLATION

0 W45-0536 / C / 09.06.06 . Attach screw and spacer as illustrated in Fig. 46 to the bottom of both sides of the front housing. . Attach the face plate bracket provided to the top edge of the front housing using #8 - /” truss head screws as illustrated in Fig. 47. 3. Lift and hook the faceplate over...

Page 21 - REMOTE, RECEIvER AND vALvE ACCESS; Pull on the top of the optional front away from the fireplace until; BURNER ASSEMBLY REMOvAL

W45-0536 / C / 09.06.06 REMOTE, RECEIvER AND vALvE ACCESS 1a. Rectangular Front Removal Pull on the top of the optional front away from the fireplace until the male portion of the latch disengages. Tilt forward slightly and lift from the shoulder screws near the bottom. 1b. Heritage and Wrought Iron...

Page 22 - OPERATION / MAINTENANCE; FIREPLACE OPERATION

W45-0536 / C / 09.06.06 To operate this firplace using the remote, the pilot must be running and the gas valve turned to the “ON” position. Ensure that the receiver has power and the backup switch is in the auto position. 1. Install the batteries (AAA) into the remote control transmitter. The “HOUSE...

Page 26 - OPERATING INSTRUCTIONS; FOR YOUR SAFETY READ BEFORE; Purge all gas lines with the glass door of the fireplace

6 W45-0536 / C / 09.06.06 A. T his fireplace is equipped with a pilot which must be lit by hand while following these instructions exactly. B. B efore operating smell all around the fireplace area for gas and next to the floor because some gas is heavier than air and will settle on the floor. C. Use...

Page 27 - lead to carboning. Opening the air shutter will cause a more; ADjUSTMENTS; PILOT BURNER ADjUSTMENT; Air Shutter Openings; turn off tHe gas and electrical poWer; at least once a year; MAINTENANCE

7 W45-0536 / C / 09.06.06 AIRSHUTTER OPENING Closing the air shutter will cause a more yellow flame, but can lead to carboning. Opening the air shutter will cause a more blue flame, but can cause flame lifting from the burner ports. The flame may not appear yellow immediately; allow 15 to 30 minutes...

Page 28 - REPLACEMENTS; REPLACEMENT PARTS

8 W45-0536 / C / 09.06.06 ** WArNiNg: This is a fast acting thermocouple. It is an integral safety component. Replace only with a fast acting ther- mocouple supplied by Wolf Steel Ltd. # PART NO. DESCRIPTION W35-067 # - REAR LOG W35-068 # - MIDDLE LOG 3 W35-069 #3 - RIGHT LOG 4 W35-070 #4 - LEFT LOG...

Page 30 - s e c o n d s f o r t h e; Pilot flame is not engulfing the; TROUBLE SHOOTING GUIDE; SYMPTOM

30 W45-0536 / C / 09.06.06 W h i t e / g r e y f i l m forms. Sulphur from fuel is being deposited on glass, logs or c o m b u s t i o n c h a m b e r s u r - - clean the glass with a gas fireplace glass cleaner. Do NoT CLeAN GLASS WHEN HOT. If deposits are not cleaned off regularly, the glass may b...

Page 32 - Fireplace Service History; This fireplace must be serviced annually depending on usage

3 W45-0536 / C / 09.06.06 Fireplace Service History This fireplace must be serviced annually depending on usage DA TE DEALER NAME SER VICE TECHNICIAN NAME SER VICE PERFORMANCE SPECIAL CONCERNS

Page 33 - NOTES