Napoleon EF30 - Manuals - manualsarea.com

Page 2 - WARNING; TABLE of CONTENTS

W415-0675 / A / 03.28.08 2 • Do not burn wood or other materials in this fireplace.• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the f...

Page 3 - NAPOLEON®; ELECTRIC FIREPLACE PRESIDENT’S LIFETIME LIMITED WARRANTY

3 W415-0675 / A / 03.28.08 Electrical components and wearable parts such as fan/heater, motors, switches, nylon bearing components and remote controls are covered and NAPOLEON® will provide replacement parts free of charge during the first year of limited warranty.Light bulbs and fuses are NOT cover...

Page 4 - SAVE THESE INSTRUCTIONS.; IMPORTANT INSTRUCTIONS

W415-0675 / A / 03.28.08 4 When using electric appliances, basic precautions shouldalways be followed to reduce the risk of ﬁ re, electric shock,and injury to persons, including the following: 1. Read all instructions before using this ﬁ replace. 2. This ﬁ replace is hot when in use. To avoid burns,...

Page 6 - LOCATING FIREPLACE; UNPACKING AND TESTING FIREPLACE; GROUNDING FIREPLACE

W415-0675 / A / 03.28.08 6 LOCATING FIREPLACE ! WARNING Due to high temperatures, this electric ﬁ replace should be located out of trafﬁ c. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the ﬁ replace. Never locat...

Page 7 - CLEARANCES TO COMBUSTIBLES; INSTALLATION

7 W415-0675 / A / 03.28.08 ! WARNING RISK OF FIRE! The power cord must not be pinched against a sharp edge. Secure cord to avoid tripping or snag-ging to reduce the risk of ﬁ re, electric shock or personal injury. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the lik...

Page 8 - THERMOSTAT AND THERMAL SENSOR INSTALLATION

W415-0675 / A / 03.28.08 8 THERMOSTAT AND THERMAL SENSOR INSTALLATION This ﬁ replace has two options for heat control. First is a thermal controlled sensor, which comes plugged into the ﬁ replace beside the main power cord. Figure 4 . This sensor has no user temperature set points, it will turn off ...

Page 9 - HARDWIRE INSTALLATION

9 W415-0675 / A / 03.28.08 HARDWIRE INSTALLATION HARD WIRING CONNECTION If it is necessary to hard wire this ﬁ replace, a qualiﬁ ed electrician may remove the cord connection, and wire the unit directly to the house hold wiring. This ﬁ replace must be electrically connected and grounded in ac-cordan...

Page 10 - HEARTH; COLD CLIMATE INSTALLATION; FINISHING CHECKLIST; FINISHING; FRAMING AND FINISHING

W415-0675 / A / 03.28.08 10 NOTE: In order to avoid the possibility of exposed insulation or vapour barrier coming in contact with the ﬁ replace body, it is recommended that the walls of the ﬁ replace enclosure be “ﬁ nished” (ie: drywall/sheetrock), as you would ﬁ nish any other outside wall of a ho...

Page 12 - MAINTENANCE

W415-0675 / A / 03.28.08 12 ! WARNING PREPARATION FOR MAINTENANCE Always disconnect the power and allow the electric ﬁ replace to cool before performing any cleaning, maintenance or relocation of this electric ﬁ replace. Turn controls to OFF and remove plug from outlet or turn off the house circuit ...

Page 14 - REPLACEMENT PARTS; REPLACEMENT PARTS; ACCESSORIES

W415-0675 / A / 03.28.08 14 # PART NO. DESCRIPTION 1 DQ017-002 LIGHT BULBS 2 RC3 DQ002-006 CIRCUIT BOARDS 3 Q/T FRT01-000-00B HEATER (HEATER WITH BLOWER) 4 DQ006-003 SWITCHES 5 R-14 REMOTE CONTROL Contact your dealer for questions concerning prices and availability of replacement parts. Normally all...

Page 15 - OBSERVED PROBLEM; TROUBLESHOOTING

15 W415-0675 / A / 03.28.08 ! WARNING Turn off the ﬁ replace completely and let cool before servicing. Only a qualiﬁ ed service person should service and repair this electric ﬁ replace. OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Dim or no ﬂ ame 1. Bulb(s) are burnt out 1. Inspect the bulbs inside the ﬂ ...

Page 16 - NOTES