Murphy CDV300R - Manuals - manualsarea.com

Page 3 - Table of Contents

Table of Contents General Information ................................................................................................................ 1 Introduction ..................................................................................................................1 Installation Instr...

Page 5 - General Information; Introduction; As part of the MurphyLink; Murphy CANdrive; offers a cost effective instrument; Standard Model Options; Stock Code; CAN drive J1939 to electric gage interface. 1 x CAN

Section 78 00-02-0618 04-10-07 - 1 - General Information Introduction As part of the MurphyLink ® family, the Murphy CANdrive ™ offers a cost effective instrument solution for modern electronic engines. CANdrive acts as an interface between ECU CANbus/J1939 transmitted data and standard electric ind...

Page 6 - Installation Instructions; Configuration; Link; CANbus 120 Ohm resistor

Section 78 00-02-0618 04-10-07 - 2 - Installation Instructions Configuration CANdrive modules are supplied with 5 circuit board links soldered in place. These wire links, labeled L1 through L5, are located on the back side of the unit. The links allow configuration of operating options by snipping t...

Page 8 - Terminal Functions

Section 78 00-02-0618 04-10-07 - 4 - Terminal Functions PIN Function 1 Negative DC, power supply 2 Positive DC, power supply 3 Negative DC, gage common return CANdrive modules are supplied for use with 12V (7 to 16V) DC operation. If 24V (19 to 30V) DC operation is required, remove (cut) rear link L...

Page 9 - Panel Mounting; Before mounting, ensure that the final position allows access for:

Section 78 00-02-0618 04-10-07 - 5 - Panel Mounting WARNING: Do not install the CANdrive module near exhaust manifolds, turbochargers or other engine locations that might exceed the maximum allowable operating temperature of 185 ° F (85 ° C). CANdrive modules are surface-mounted with four no.4 screw...

Page 10 - Operation and Maintenance; Gage Driver Outputs

Section 78 00-02-0618 04-10-07 - 6 - Operation and Maintenance Gage Driver Outputs Gage outputs operate when CANdrive module reads valid J1939 data for engine speed, oil pressure and coolant temperature. If CANdrive module stops receiving valid data, the gage outputs are maintained at the last known...

Page 11 - Maintenance; Check that electrical connections are secure.

Section 78 00-02-0618 04-10-07 - 7 - Maintenance CANdrive modules have no user-serviceable parts. Maintenance is therefore limited to the following preventative checks: • Check that electrical connections are secure. • Check that the CANdrive module is securely mounted and kept free from exposure to...

Page 12 - Specifications

Section 78 00-02-0618 04-10-07 - 8 - Specifications Power Supply • Operating voltage: • 12V range (link L2-in place) 7-16 VDC • 24V range (link L2-cut) 19-30 VDC • Current consumption: • CDV100F: 25mA typical • CDV300R: 50mA, typical (2 LEDs lit) Inputs • CANbus: • SAE J1939 protocol, Input fitted w...