Mitsubishi MZ360360EX- Manuals

- 8 -   C. INSTALLING THE ANTENNA UNIT 1) Cut the urethane sheet ④ into the following dimensions.   A: 35 x 140 mm (2 pieces)   B: 70 x 20 mm (4 pieces) C: 70 x 70 mm (1 piece)   D: 70 x 10 mm (1 piece) 2) Wrap the two pieces of urethane sheet A ④ around the cable of the antenna unit ② . 3) Pass the...

- 11 -   G. ROUTING THE HARNESS AROUND THE ETACS-ECU       1) Connect the 1-pin connector (female) of the harness ③ to the 1-pin connector of the front harness taped with the black tape on the front harness at the front of the ETACS-ECU. 2) Connect the three quick splice connectors of the harness ③ ...

- 14 -         J. REGISTRATION AND OPERATION CHECK 1) Perform the registration and operation check in accordance with “REGISTRATION AND OPERATION CHECK PROCEDURES” (Page 37). K. REINSTALLATION 1) Reinstall the removed parts to the vehicle in accordance with the workshop manual. 2) Reprogram the radi...

- 21 -   G. ROUTING THE HARNESS AROUND THE ETACS-ECU   1) Route the 1-pin connector (female) of the harness ③ along the front harness and connect it to the 1-pin connector of the front harness which is taped with the black tape on the front harness. 2) Route the three quick splice connectors and the...

- 22 -     4) Connect the quick splice connector with blue/red wire to the blue/red wire from the No. 18 terminal of the 24-pin white connector connected to the ETACS-ECU. 5a) On vehicles with theft alarm system, connect the quick splice connector with blue/white wire to the blue/white wire from the...

- 24 -     H. INSTALLING THE HOOD SWITCH (vehicles without theft alarm system)   In order to install this system on a vehicle without the theft alarm system, the hood switch (sold separately) and the sub harness for hood switch ⑧ must be installed. 1) Release the 2-pin connector (female) fixed with ...

- 26 -         K. REGISTRATION AND OPERATION CHECK 1) Perform the registration and operation check in accordance with “REGISTRATION AND OPERATION CHECK PROCEDURES” (Page 37). L. REINSTALLATION 1) Reinstall the removed parts to the vehicle in accordance with the workshop manual. 2) Reprogram the radi...

- 37 - REGISTRATION AND OPERATION CHECK PROCEDURES (1) Operation check of remote controller Perform the operation check in the following procedure. 1) Perform the engine start operation. ① Push Function SW short once. . ② While Start Mark is blinking, push Start SW until sounding Buzzer. Go to Troub...

- 39 - 3) Within 10 seconds after the sound of the buzzer in the above step 2), push three switches (Function Switch, Start Switch, and Stop Switch) on the right side of the remote controller at the same time for 1 second or more. The buzzer of the remote controller sounds when pushing for 1 second ...

- 51 - 1. Checking connector terminals Check that the battery voltage is 10 V or higher. Then, while referring to the circuit diagram, check each connector of the connector ① (13-pin, natural) and the connector ② (12-pin, black) connected to the ECU in accordance with the following table using a mul...