McCulloch D340/34cc - Manuals

1) ENGINE 2) SHAFT 3) THROTTLE TRIGGER 4) THROTTLE ADVANCE 5) RIGHT CONTROL HANDLE 6) BLADE 7) NYLON STRING HEAD 8) STOP SWITCH 9) CHOKE LEVER 10) STARTER HANDLE 11) HARNESS RING 12) SPARK PLUG 13) AIR FILTER COVER 14) FUEL TANK CAP 15) MUFFLER SHIELD 16) ENGINE SHAFT JOINT 17) FRONT HANDLE 18) REAR...

DANGER. Do not run engine without shaft attached as clutch could fly off. 1) Assemble the engine onto the shaft. Make surethe shaft is fully and correctly engaged up tothe shank, then tighten the 2 screws ( A ) in a criss-cross sequence. 2) Fit the end of the trigger cable connector ( B ) into the s...

From time to time ensure all screws are tight.Replace damaged, worn, cracked or warpedblades. Always make sure nylon string head orblade have been assembled correctly (seesections NYLON STRING HEAD and BLADEASSEMBLY) and blade fastener is tightened. 1) AIR FILTER CLEANING (at least every 25 working ...

11 A FAULT FINDING TABLE Engine will Engine runs badly The machine not start or looses power runs but does when cutting not cut well •• • • • • • •• • • Engine still gives trouble: contact your dealer. Check STOP switch is in theposition I. Control fuel level min. 25%tankcapacity. Check air filter i...