Page 2 - IDENTIFICATION OF SYMBOLS
2 IDENTIFICATION (WHAT IS WHAT?) Primer Bulb Fuel tank Assist handle Starter handle ON/OFF switch Throttle Choke Spark plug Shield Trimmer head Shaft Muffler Manual Wrench Assist handle adjustment IDENTIFICATION OF SYMBOLS A. WARNING! This trimmer can be dangerous! Careless or improper use can cause...
Page 3 - SAFETY RULES; OPERATOR SAFETY
3 SAFETY RULES WARNING: When using gardening appliances, basic safety precautions should al- ways be followed to reduce the risk of fire and serious injury. Read and follow all instructions. This power unit can be dangerous! Operator is responsible for following instructions and warn- ings on unit a...
Page 4 - ASSEMBLY; ADJUSTING THE HANDLE
4 CUTTING SAFETY WARNING: Inspect the area before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by or become entangled in line. Hard objects can damage the trimmer head and be thrown causing serious injury. S Use only for trimming, scalping, mowing and sweepin...
Page 5 - OPERATION
5 OPERATION WARNING: Be sure to read the fuel information in the safety rules before you be- gin. If you do not understand the safety rules, do not attempt to fuel your unit. Contact an authorized service dealer. FUELING ENGINE WARNING: Remove fuel cap slowly when refueling. This engine is certified...
Page 6 - STARTING A FLOODED ENGINE; OPERATING INSTRUCTIONS; OPERATING POSITION
6 NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded. STARTING A FLOODED ENGINE Flooded engines can be started by placing the choke lever in the RUN position; then, pull the rope to clear the engine of excess fuel. This could require...
Page 7 - MAINTENANCE
7 Mowing SWEEPING -- The fanning action of the rotat- ing line can be used for a quick and easy clean up. Keep the line parallel to and above the surfaces being swept and move the tool from side to side. Sweeping MAINTENANCE WARNING: Disconnect the spark plug before performing maintenance except for...
Page 8 - STORAGE; SEASONAL STORAGE
8 SmallHoles Spool Hub Line in Notch Line in Notch Line exit holes 5. Wind the line evenly and tightly onto the spool. Wind in the direction of the arrows found on the spool. 6. Push the line into the notches, leaving 7 -- 12 cm unwound. 7. Insert the line into the the exit holes in the hub as shown...
Page 9 - DECLARATION OF CONFORMITY
9 TROUBLE CAUSE REMEDY Engine will not start. 1. ON/OFF switch in OFF position. 2. Engine flooded. 3. Fuel tank empty. 4. Spark plug not firing. 5. Fuel not reaching carburetor. 6. Carburetor requires adjustment. 1. Move ON/OFF switch to ON position. 2. See “Starting a Flooded Engine” in Operation S...