McCulloch 4700X PRO /46cc - Manuals

1) ENGINE 2) SHAFT 3) THROTTLE TRIGGER 4) DECOMPRESSION VALVE 5) RIGHT CONTROL HANDLE 6) BLADE 7) NYLON STRING HEAD 8) STOP SWITCH 9) CHOKE LEVER 10) STARTER HANDLE 11) HARNESS RING 12) SPARK PLUG 13) AIR FILTER 14) FUEL TANK CAP 15) MUFFLER SHIELD 16) ENGINE SHAFT JOINT 17) FRONT HANDLE 18) REAR CO...

9 A BACK-PACK BRUSHCUTTER See page 88. DANGER. Do not run engine without shaft attached as clutch could fly off. 1) Assemble the engine onto the shaft. Make surethe shaft is fully and correctly engaged up tothe shank, then tighten the 2 screws ( A ) in a criss-cross sequence. 2) Fit the end of the t...

From time to time ensure all screws are tight.Replace damaged, worn, cracked or warpedblades. Always make sure nylon string head orblade have been assembled correctly (seesections NYLON STRING HEAD and BLADEASSEMBLY) and blade fastener is tightened. 1) AIR FILTER CLEANING (at least every 25 working ...

11 A N. REPLACING NYLON LINE 1) Loosen the locking nut on the base of thenylon head by turning it clockwise. 2) Remove the base cover assembly. Remove the empty spool from the housing anddiscard any remaining line. REWINDING NEW LINE 3) Prepare 2 lengths (8ft each) of 2.4 mm nylonline. Thread 1 end ...

1 Kytke taipuva akseli moottorin ( G ) liitokseen. Varmista että akselin suo- rakulmainen ulkoinen päätekappale kytkeytyy liitoksen suorakulmaiseensisäkappaleeseen. Aseta kaasuvaijeri ja sähköjohto ( A ) kaapelikiinnikkeeseen. Niin, että ne ylettyvät hyvin moottorissa oleviin kiinnityspisteisiin ( k...