McCulloch 115249726 - Manuals

Page 2 - TABLE OF CONTENTS

2 TABLE OF CONTENTS Identification (What is What?) 2 Identification of Symbols 3 Safety Rules 3 Assembly 5 Operation 9 Maintenance 16 Service & Adjustments 16 Storage 18 Troubleshooting Table 19 Declaration of Conformity 20 Technical Data 21 IDENTIFICATION (WHAT IS WHAT?) 3 10 1 4 16 14 20 19 7 ...

Page 5 - ASSEMBLY; CARTON CONTENTS

5 FUEL SAFETY S Mix and pour fuel outdoors. S Keep away from sparks or flames. S Use a container approved for fuel. S Do not smoke or allow smoking near fuel or the unit. S Avoid spilling fuel or oil. Wipe up all fuel spills. S Move at least 3 meters away from fueling site before starting engine. S ...

Page 7 - CONFIGURING YOUR UNIT

7 Upper shoulder strap clamp Screws Lower shoulder strap clamp 4. Insert two screws into the screw holes. 5. Secure shoulder strap clamp by tighten- ing screws with a hex wrench. 76 cm HARNESS ADJUSTMENT FOR BALANCE 10 -- 30 cm above ground 15 cm below waist 76 cm CONFIGURING YOUR UNIT You can confi...

Page 9 - OPERATION; FUELING ENGINE

9 1. Remove the retaining washer from the threaded shaft of the gearbox. Leave the dust cup on the shaft. 2. Install the blade and the retaining washer over the threaded shaft. 3. Make sure the raised part of the retaining washer is facing the gearbox and the raised area fits into the hole in the ce...

Page 13 - ADDITIONAL SAFETY RULES; FOR OPTIONAL ATTACHMENTS; EDGER SAFETY

13 S Cut only from your left to your right. Cutting on right side of the shield will throw debris away from the operator. S Use the shoulder strap and keep a firm grip on the unit with both hands. A properly adjusted shoulder strap will support the weight of the unit, freeing your arms and hands to ...

Page 14 - HANDS AWAY FROM BLADE; POLE PRUNER SAFETY

14 through discharge opening, damaging unit, property, or causing serious injury to bystanders or operator. S Never place objects inside the blower tubes, vacuum tubes or blower outlet. Always direct the blowing debris away from people, animals, glass, and solid objects such as trees, automobiles, w...

Page 15 - SNOW THROWER SAFETY

15 WARNING: Falling objects can cause severe head injury. Wear head protec- tion when operating this unit with a pole prun- er attachment. WARNING: To prevent serious injury, do not use more than one boom extension with a pole pruner attachment. WARNING: Keep the pruner away from power lines or elec...

Page 18 - STORAGE

18 BLADE REPLACEMENT Refer to the ASSEMBLY section for blade re- placement instructions and illustrations. CARBURETOR ADJUSTMENT WARNING: Keep others away when making idle speed adjustments. The trimmer head will be spinning during most of this pro- cedure. Wear your protective equipment and observe...

Page 20 - DECLARATION OF CONFORMITY

20 DECLARATION OF CONFORMITY EC Declaration of Conformity (Only applies to Europe) We, Husqvarna AB , SE-- 561 82 Huskvarna, Sweden, Tel: +46--36--146000, as authorised representative in the Community, declare that the brushcutter model McCulloch Cabrio 433L from serial numbers 2009-- 031N00001 and ...

Page 21 - TECHNICAL DATA

21 TECHNICAL DATA M ODEL: Cabrio 433L Trimmer Blade ENGINE Displacement, cm 3 33 33 Maximum engine power, measured in accordance with ISO 8893, kW 0,9 0,9 Catalytic converter muffler No No ENGINE ROTATIONAL SPEEDS At maximum engine power, rpm 7000 7000 Maximum rotational frequency of the spindle 100...