Majestic ODSHR42 - Manuals

Majestic ODSHR42 – Manual in PDF format online.

Manuals:

Manual

Manual Majestic ODSHR42

Summary

Page 2 - ODSHR Series; Safety Information; PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING FIREPLACE.; Burn only solid wood fuel or gas logs.; Drafts; or SK chimney systems. The unit; Listed; Standard for Factory Built Fireplaces; Table Of Contents

2 ODSHR Series 20002264 Safety Information PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING FIREPLACE. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure tofollow these instructions may result in a possible fire hazard and will void the warranty. Descrip...

Page 3 - ODSHR42 Series Woodburning Fireplace

3 ODSHR Series 20002264 Rough Opening Height 42" 52 ¹⁄₄ " 44" ³⁄₄ " ³⁄₄ " 24 " 7⁷⁄₁₆ " 13 ³⁄₈ " Dia. Rough Opening Width 53 ³⁄₄ " Rough Opening Depth 62 ¹⁄₈ " 62 ¹⁄₈ " 87⁷⁄₈ " 10³⁄₈ " 26³⁄₄ " 35 " 48 ¹⁄₄ " 44⁹⁄₁₆ " ³⁄₄ " ³⁄₄ ...

Page 4 - Chase Installation

4 ODSHR Series 20002264 NOTE: If the fireplace is afreestanding unit, it must belocated a minimum of 10'from the opening of thefirebox to a combustiblestructure.A minimum height of 6'- 4"measured from the base ofthe firebox to the bottom ofthe termination cap ispermitted. 10' Min. 6'4" Min. ...

Page 5 - Chimney Requirements - Offset Installations; 0 ̊ Elbow Offsets; Illustration Key; OFFSET

5 ODSHR Series 20002264 Chimney Requirements - Offset Installations 0 0 0 0 0 3" 11" 1 0 0 0 0 8 ¹⁄₄ " 20" 0 1 0 0 0 11 ¹⁄₄ " 25 ¹⁄₄ " 2 0 0 0 0 13 ¹⁄₂ " 29 ¹⁄₄ " 1 1 0 0 0 16 ¹⁄₂ " 34 ¹⁄₄ " 0 0 1 0 0 20 ¹⁄₄ " 40 ³⁄₄ " 2 1 0 0 0 21 ³⁄₄ " 43 ¹⁄₂ ...

Page 6 - Planning Information; The Ten Foot Rule

6 ODSHR Series 20002264 Planning Information The Ten Foot Rule Major U.S. building codes specify a minimum chimneyheight above the roof top. The “Ten Foot Rule” is a firesafety rule and not a draft rule. To ensure proper draft,it is recommended that you always meet or exceed the“Ten Foot Rule,” espe...

Page 7 - Chimney Supports; Installation

7 ODSHR Series 20002264 Chimney Supports The chimney system is supported by the fireplace forvertical chimney heights less than 30 feet above thehearth. Chimney supports are required if the verticalheight exceeds 30 feet with 11CF chimneys. Locatechimney supports at ceiling holes or other structural...

Page 8 - Ceiling Chimney Hole/ Possible Obstructions; Straight-Up Chimney Installation

8 ODSHR Series 20002264 Locate center point of the chimney on ceiling as thougha straight up chimney arrangement is to be used.Measure your offset dimension from straight up chim-ney center point on ceiling. Ceiling Chimney Hole/ Possible Obstructions The size of the hole in ceiling will vary with t...

Page 9 - Cutting the Hole; CHIMNEY HOLE SIZE

9 ODSHR Series 20002264 Cutting the Hole Cover fireplace collar opening and cut proper sizedchimney hole in chimney. (Fig. 10 & 11) Framing the Ceiling Hole Frame the ceiling chimney hole as shown in Figure 11.It is good practice to use framing lumber that is thesame size as the ceiling joists; ...

Page 10 - Securing the Fireplace; Installing Outside Air Kit; An outside air damper assembly is installed in all

10 ODSHR Series 20002264 4. Positioning, Safety Strips, Securing the Fireplace Slide fireplace into position. Lift the fireplace front slightly and slide the metal safetystrips under front bottom edge about 1 ¹⁄₂ inches, allowing the remainder to extend in front of firebox.Overlap strips at least 1/...

Page 11 - Installing the Chimney System; Attic Installation

11 ODSHR Series 20002264 5. Installing the Chimney System Start by attaching the first chimney section to the collaron top of the fireplace. Install the pipe as pictured in Figure 14. When you geta good lock, you will hear the pipe clearly snap to-gether. Once sections are snap-locked in place, it i...

Page 14 - Side Wall Protection; Examples of wall shield insulation:

14 ODSHR Series 20002264 Stud 2 x 4 FinishedHeader Covered Wall Ledge Bracket Finished Wall NoncombustibleDecorative Facing Must be Sealed withNoncombustibleMaterial Surround FP1167 Fig. 20 Facing on fireplace surround flush with finished wall. Side Wall Protection Adjacent combustible side walls th...

Page 15 - Hearth Installation; Example for Common Brick; Minimum Wall Clearances

15 ODSHR Series 20002264 8. Hearth Installation A hearth extension is required to protect a combustiblefloor in front of the fireplace. See Figure 24 for mini-mum dimensions and mounting detail. NOTE: Hearth Extension must not cover the airinlet opening of a fireplace. The hearth extension described...

Page 16 - COMMON MATERIALS AND FACTORS; Installing Line for Gas Logs

16 ODSHR Series 20002264 COMMON MATERIALS AND FACTORS MATERIAL K* R MINIMUM THICKNESS EH2416 Common Brick 0.458 5.0 1.09 0.50 in.** 0.10 5.46 in.** (Majestic Products Company) R Value is for ¹⁄₂ inch. * Units of K = BTU/SQ FT/HR/˚F/IN** Thickness of Listed Material FP533ADD Fig. 25 Hearth extension ...

Page 17 - If installing an unvented gas log set, refer to statement below:

17 ODSHR Series 20002264 From inside the fireplace, locate the knockout on thefirebrick -- be sure you are on the appropriate or "gasline" side of the fireplace. Using a flat bladed screw-driver or small chisel and hammer, carefully tap aroundthe knockout until it loosens and falls out. Inst...

Page 18 - Description; ODSHR Outdoor Woodburning Fireplace

18 ODSHR Series 20002264 2264 * Two (2) required ** Four (4) required Vermont Castings, Majestic Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors andproducts at any time, without notice. 1 2 5 7 6 4 3 12 11 8 10 9a,b 13 Ref. Description ...

Page 19 - Accessories

19 ODSHR Series 20002264 The following accessories for this appliance are available from your local Vermont Castings, Majestic Productsproducts distributor. Should you need additional information beyond what your distributor can furnish, contact:Vermont Castings, Majestic Products, 410 Admiral Blvd....

Page 20 - Accessory

20 ODSHR Series 20002264 Accessory Description Model No. Extended Round Top Chimney Sections Chimney Elbows Top HousingwithUpper Baffle Chimney Reducer Kit For use with Majestic Type "11CF" Chim-ney Systems.Used to terminate chimney at top ofchase. Adapter kit included. Flashing notincluded....

Page 21 - LIMITED WARRANTY & 30 YEAR PROTECTION PLAN

21 ODSHR Series 20002264 LIMITED WARRANTY & 30 YEAR PROTECTION PLAN For Vermont Castings, Majestic Products PRE-ENGINEERED Fireplace Systems Vermont Castings, Majestic Products warrants its Pre-Engineered Fireplace (“Fireplace”) and the Vermont Castings, Majestic Products-supplied firegrate, gla...

Page 22 - Vermont Castings, Majestic Products

22 ODSHR Series 20002264 © Vermont Castings, Majestic Products 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777 www.majesticproducts.com • www.vermontcastings.com Vermont Castings, Majestic Products