Majestic HE32EF - Manuals

Majestic HE32EF – Manual in PDF format online.

Manuals:

Manual

Manual Majestic HE32EF

Summary

Page 2 - TABLE OF CONTENTS

- 2 - TABLE OF CONTENTS Please read the Installation & Operating Instructions before using this appliance. Thank you and congratulations on your purchase of a Vermont Castings Majestic Products Company fireplace. IMPORTANT: Read all instructions and warnings carefully before starting installatio...

Page 3 - INSTALLATION INSTRUCTIONS; SAVE THESE INSTRUCTIONS.; GENERAL

- 3 - LOCATING YOUR VERMONT CASTINGS MAJESTIC PRODUCTS COMPANY ELECTRIC FIREPLACE INSTALLATION INSTRUCTIONS 15. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces,like a bed, where openings may become blocked. 16. This appliance has hot and arc...

Page 4 - FIREPLACE DIMENSIONS

- 4 - M I N I M U M O PE N I NG Fig. 1 1= SS or SSD Trim2= SL or SLD Trim3= SXL Trim4= BSL Trim5= BXL Trim HE32EF T R I M A1 26 5/8" 676 mm B1 38 3/8" 975 mm A2 29" 737 mm B2 41 15/16" 1065 mm A3 33" 838 mm B3 44" 1118 mm A4 28" 712 mm B4 40 7/8" 1041 mm A5 30 1/2"...

Page 5 - insulated exterior wall or chase, it is; HEARTH; RAISED; MANTELS; The underside of the mantel will get quite; The use of wall paper adjacent to this fireplace; MANTEL CHART

- 5 - CLEARANCE TO COMBUSTIBLES Non-combustible materials such as brick and tile can beextended over the face of the unit (Do not cover louvresor glass door). If a Trim Kit is going to be installed, brickand tile will have to be installed flush with the side of thisappliance. FINAL FINISHING Cold cl...

Page 6 - ELECTRICAL CONNECTION; Do not use this fireplace if any part of it has; INSTALLATION OF LOGS

- 6 - Fig. 4 Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electricalshock and injury to persons. ELECTRICAL CONNECTION A 15 AMP, 120 Volt, 60 Hz circuit with a properly groundedoutlet is required. Preferably, the fireplac...

Page 7 - LOUVRE REMOVAL; SERVICE INSTRUCTIONS; Disconnect power before attempting any; GLASS INFORMATION; LOUVRE; GLASS FRAME REMOVAL; Before remounting glass frame, brass trim

- 7 - LOUVRE REMOVAL SERVICE INSTRUCTIONS To remove top louvre pull louvre up and then lift out.See Figure 5. Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury. GLASS INFORMATION 1. Under no circumstances should this produc...

Page 8 - MAINTENANCE OF MOTORS; Make sure that the power is turned off; CLEANING BRASS TRIM; ELECTRICAL DIAGRAM; and securing locations must be followed.

- 8 - MAINTENANCE OF MOTORS The motors used on the fan and the drum assembly areprelubricated for extended bearing life and require nofurther lubrication. However, periodic cleaning/vacuumingof the fan/heater is recommended. Make sure that the power is turned off before proceeding. CLEANING BRASS TR...

Page 9 - OPERATING INSTRUCTIONS; LOG ILLUMINATION CONTROL; CONTROL PANEL

- 9 - OPERATING INSTRUCTIONS 1. MAIN ON/OFF SWITCH The On/Off switch supplies power to all of the functions ofthe fireplace. This is an illuminated switch which normallywill light up when in the "On/Off" position. The control compartment is located behind the lower louvrepanel. To access the...

Page 10 - REPLACEMENT PARTS - ELECTRIC FIREPLACE

- 10 - REPLACEMENT PARTS - ELECTRIC FIREPLACE #2 COMPLETE LOG SET 2 3 4 / 5 7 6 8 9 17 15 18 19 21 22 20 14 13 305mm [12"] 216mm [8 1/2"] (DISTANCE BETWEEN TWO SOCKETS} 216mm [8 1/2"] (DISTANCE BETWEEN TWO SOCKETS) 23 HE32EF #1 COMPLETE LOG SET

Page 11 - REPLACEMENT PARTS LIST - ELECTRIC FIREPLACE; ESCRIPTION

- 11 - REPLACEMENT PARTS LIST - ELECTRIC FIREPLACE D ESCRIPTION HE32EF 1. Log Set Complete 10003628 1a. Log Top Left N/A 1b. Log Top Right N/A 1c. Log Bottom N/A 2. Fan/Heater Assembly w/Bracket 10001815 3. Motor 12VDC (Flame generator) 10001978 4. Switch Rocker 53606 5. On/Off Switch (Illuminated) ...

Page 12 - INSTALLATION; Let fireplace cool if it has been operating.; FAN HEATER INSTALLATION

- 12 - INSTALLATION WARNING: UNPLUG OR TURN THE POWER TO THE APPLIANCE OFF PRIOR TO BEGIN-NING THE INSTALLATION. IT IS NOT ACCEPTABLE TO USE THE “ON/OFF” SWITCH TOMEET THIS REQUIREMENT. 1. Turn the power to the appliance off, or unplug it from the power supply. 2. Let fireplace cool if it has been o...

Page 13 - FRAME ASSEMBLY; TRIM ASSEMBLY; screws to assemble each piece.; A flat louvre kit OR a bay window kit; TRIM OPTIONS FOR HE32EF

- 13 - FRAME ASSEMBLY 1. Lay Trim Top Facing and Trim Side Facings, face downon to an even surface such as a table or floor. Be surenot to scratch the painted surfaces. 2. Install the nuts and bolts (Fig. 8). Fig. 8 1) RHESS, RHESL, RHESSD, RHESLD & RHESXL TRIMS RHESS, RHESL, RHESSD, RHESLD and ...

Page 14 - FRAME MOUNTING; GENERAL INFORMATION

- 14 - 1. Fit Decorative Frame to the fireplace and fasten (Fig. 12) Plastic on the trim must be removed beforemounting onto the fireplace. Glass must be tightly pressed against thefront of the frame in order to preventscrews from damaging glass edges. Fig. 12 AS SHOWN FROM FRONT SCREWS FRAME MOUNTI...

Page 15 - TRIM REPLACEMENT PARTS LIST; Specify Finish (Antique or Polished Brass); SS and SSD trim dimensions are for openings smaller than 26; ALL repair parts will be available from your local dealer.

- 15 - KEY DESCRIPTION RHESS (2) RHESL (3) RHESSD (3) RHESLD (3) RHESXL (4) 1 Trim Frame Top, Flat Black 57929 57932 57929 57932 57935 2 Trim Frame Left, Flat Black 57927 57930 57927 57930 57933 3 Trim Frame Right, Flat Black 57928 57931 57928 57931 57934 4 Trim Top Deflector (1) 17634 17634 17634 1...

Page 16 - RHEBSL; Remove the two screws that hold the top brass trim.; RHEBXL; RHEBXLP or RHEBXLA to be used with RHEBSSLP or

- 16 - TRIM ASSEMBLY 1. Install trim channels (left and right sides). Use twoscrews to assemble each piece. 2. Slide on the trim top channel and fasten it from the backside. 3. Install the trim top deflector and use two screws tofasten it. (Fig. 13) 4. Remove ALL plastic protective covering from bra...

Page 17 - ) RHEFA and RHEFP TRIMS; Glass; Install bottom decorative plate by simply sliding it

- 17 - 3) RHEFA and RHEFP TRIMS Glass Frame Louvre Note:Position brass trim top as shown (small end up) to prevent heat discolouration Fig. 14 Fig. 15 1. Remove the front glass (see "Glass Frame Re- moval" section). 2. Install support window trim channel, top and bottom brass trim by using t...

Page 18 - HECBTKP, HECBTKMB and HESBTKP Trim Assembly; DO NOT REMOVE EXISTING GLASS WITH FRAME

- 18 - 4) HEBTKP, HESBTKP, HECBTK, HECBTKMB & HEBTA TRIMS HECBTK - Cast bay window and grills in classic black trim kit HECBKMB - Cast bay window and grills in midnight black porcelain enamel trim kit HESBTKP - Steel bay window with polished brass and cast grills in classic black trim kit HEBTKP...

Page 19 - HEBTKP Trim Assembly; Fig. 23. Attach magnets and brass trim to the steel

- 19 - HEBTKP Trim Assembly 1) Install the hanging brackets, as per Fig. 202) Install bracket on each side of the cabinet as per Fig. 24.3) Install the two ceramic pieces inside the bay window, as per Fig. 19.4) Install the bay window by hanging it onto the lower tabs of the hanging brackets, as per...

Page 21 - ) CAST TRIM OPTIONS; CAST SURROUND AND FLAT FACE; ACCESSORIES OPTIONS; DESCRIPTION

- 21 - 5) CAST TRIM OPTIONS CAST SURROUND AND FLAT FACE HECBL Cast Surround Black HECBLUE Cast Surround Blue HECCG Cast Surround Charcoal Grey HECGR Cast Surround Green CSSP Polished Brass Small Trim for Cast Surround CSLP Polished Brass Large Trim for Cast Surround (to be used with CSSP) ACCESSORIE...