M-Audio Audiophile - Manuals

M-Audio Audiophile – Manual in PDF format online.

Manuals:

Manual

Manual M-Audio Audiophile

Summary

Page 2 - Introduction; Congratulations on your purchase of the Audiophile USB by M-Audio.; Panel software for Windows and Macintosh OS 9 or X; About the Audiophile USB

Introduction Congratulations on your purchase of the Audiophile USB by M-Audio. The Audiophile USB is your audio and MIDI upgrade for any PC orMacintosh computer*, utilizing the convenience of your computer’s USBport—no tools or computer disassembly is required.The Audiophile bringsyou true 24-bit 9...

Page 3 - Features & Specifications; Headphone output with level control.; Minimum System Requirements; 28 MB of RAM for 96kHz operation. 64MB RAM for 48kHz or less.

jacks. Alternatively, you can connect the record outputs of your stereoreceiver into the Audiophile’s RCA jacks located on the back panel. Recorda digital audio signal from your DAT, MiniDisc, CD, or external A/Dconverter via the Audiophile’s coaxial S/PDIF input. Control all hardwaresettings with t...

Page 5 - Guide to Getting Started Quickly; Here is what is required to get your Audiophile USB up and running:; Insert the included Drivers CD into your CD drive and locate the

2. Left Input and Right Input (RCA Analog Inputs): These jacks input analog audio from a variety of external sources. Each jack is femaleRCA, compatible with common male RCA cables. When plugs areinserted into the 1/4” jacks, these RCA inputs are defeated. 3. Left Output and Right Output (RCA Analog...

Page 6 - Windows Installation; Insert the Drivers CD into your CD ROM drive. Locate and open the

Hardware Installation Find a convenient spot near your computer for the Audiophile USB.With theAudiophile’s power switched “Off,” plug the included power supply into yourwall socket, and plug its 2.5mm plug into the Audiophile’s 9V AC 1000 mAPower Jack.Then, simply connect the USB cable to your comp...

Page 7 - Click “Finish”. Your Audiophile USB is ready for action.; Macintosh OS 9 Installation; OMS Configuration

4. The Wizard reports that Windows has finished installing the software. Click “Finish”. Your Audiophile USB is ready for action. After completion of the driver installation, Windows may require you torestart Windows. If it does request a restart, remove the Drivers CD fromthe CD drive and respond b...

Page 8 - Macintosh OS X Installation; Insert the Audiophile USB Driver CD into your CD-ROM Drive and

(this is recommended, although OMS will sense that it is on and promptyou to turn it off). If you are configuring OMS for the first time, followthese instructions to configure OMS. 1. In the Opcode folder, which you will find on your hard drive, locate the OMS Applications folder,“then OMS Setup.” D...

Page 10 - The Audiophile USB Control Panel

On Macintosh: During the driver installation, a dialog box will ask you ifyou wish to place a shortcut to the control panel on your desktop. Clickingthis checkbox will, upon completion of the driver software installation,place a shortcut to the Audiophile USB Control Panel on your computer’sdesktop....

Page 13 - Audiophile USB Inputs & Outputs

Windows Sound System and the Audiophile USB Windows may be set up to use the Audiophile as its default audio device,allowing system sounds to be played through the Audiophile. This alsoenables you to use the Audiophile with the sound applets included withWindows. To set this up, go to Control Panel ...

Page 14 - Audiophile USB with Your Music Software

microphone is not recommended. Instead, pass the microphone signalthrough a microphone pre-amp (such as the M-Audio TAMPA™,DMP3™, or Audio Buddy™), and then connect the pre-amp outputto the input of the Audiophile USB. Some additional cable and/orcable adaptors may also be needed to ensure proper co...

Page 17 - Audiophile USB MIDI Setup; Connect the MIDI out port of your controller keyboard to the

Audiophile USB MIDI Setup The Audiophile’s MIDI input and output ports may be connected toexternal MIDI devices. The following diagram shows connection to a MIDIkeyboard instrument, which is also being used as a sound module.The MIDIoutput of the Audiophile USB may be used with just a sound module, ...

Page 18 - Troubleshooting; • Possible Cause 2: Improper connections to audio accessories.

Troubleshooting Problem: No sound output. Possible Cause 1:The Audiophile USB hardware or software device drivers are notproperly installed. See the installation sections of this manual for further information. Possible Cause 2: There is a resource conflict between your computer’s USBcontroller and ...

Page 19 - • Problem: I’m getting some pops and clicks in my audio recording.

Problem: Repetitious Sound. Possible Cause: An IRQ resource conflict with the USB controller andanother device (PC only). Often this will result in a small segment of sound(0.5 to 1 second) repeating itself over and over, sometimes completelylocking up the computer. See the general troubleshooting s...

Page 21 - Contact Information

Contact Information For additional help, contact M-Audio Technical Support by telephone(626-445-8495, 9-5 PST M-F), by fax (626-445-7564) or by e-mail([email protected]). M-AUDIO U.S. M-AUDIO U.K. 45 E. Saint Joseph St. Unit 5, Saracen Industrial Park Arcadia, CA 91006-2861 Mark Rd. U.S.A. Hemel ...

Page 22 - Audiophile USB Warranty

Audiophile USB Warranty M-Audio warrants that this product is free of defects in materials andworkmanship under normal use for a period of One (1) year, so long as theproduct is: owned by the original purchaser; the original purchaser has proof ofpurchase from an authorized M-Audio dealer; and the p...

Page 23 - Appendix A - Technical Specifications

Appendix A - Technical Specifications Analog Audio: Peak Signal, Analog Input: +2dBV Peak Signal, Analog Output: +2dBV Dynamic Range, Inputs: 109dB (A-weighted) Dynamic Range, Outputs: 107dB (A-weighted) THD (at 0dBFS): -92dB (typical) Frequency Response: 22Hz - 22kHz, -0.4,-0.4dB Maximum Converter ...

Page 28 - Open the Windows Control Panel and click on the Audiophile USB

17. Open the Windows Control Panel and click on the Audiophile USB Control Panel. Select "Place Audiophile Icon in the task bar.” TheAudiophile USB will have a small black “M” in the system tray for easyaccess to the control panel. 28

Page 29 - The installer will now check your computer for

Windows 2000: NOTE: Please make sure the Service Pack 3 is installed. To get thisupdate, please visit the download section of Microsoft atwww.microsoft.com Windows 2000 comes installed with DirectX version 7. You must haveDirectX version 8.1 in order to install the Audiophile USB. The AudiophileUSB ...

Page 30 - An M-Audio Setup window will appear next. Make sure both Enable

5. Windows will need to restart your machine to complete the DirectX 8.1 installation. Click "OK," to restart your system. 6. This is the first setup window for installing the Audiophile USB drivers after the installer has confirmed that you have DirectX version 8.1 (orhigher) installed on y...

Page 36 - Open the Windows Control Panel and click on the Audiophile USB

10. When you are completely restarted and at the desktop, power up the USB Audiophile. 11. Open the Windows Control Panel and click on the Audiophile USB Control Panel. Select "Place Audiophile Icon in the task bar.” TheAudiophile USB will have a small black “M” in the system tray for easyaccess...