Page 2 - IN THE VICINITY OT THIS OR ANY OTHER APPLIANCE.
CounterTop - 1300 Series Ops Manual 2 WARNING AND SAFETY INFORMATION IMPORTANT • Minimum clearances must be maintained from all walls and combustible materials. • Keep the oven area free and clear of combustible material. • Adequate clearance for air openings to the control chamber on both sides of ...
Page 3 - IMPINGER; will cause damage to unit.
CounterTop - 1300 Series Ops Manual 3 PURCHASER’S RESPONSIBILITY It is the responsibility of the purchaser to: 1. See that the electric services for the oven are installed on site in accordance with the manufacturers specifications. 2. Unload, uncrate, and install the oven in its proper location in ...
Page 4 - CounterTop - 1300 Series Ops Manual; MODEL NUMBER KEY; NOTE: Date of manufacture is
CounterTop - 1300 Series Ops Manual 4 MODEL NUMBER KEY COUNTRY LANGUAGE CODE NOT USED 1. France French B A 2. Germany German C I 3. Italy Italian D O 4. Spain Spanish E Q 5. United Kingdom English F 6. Luxembourg French B 7. Portugal Portuguese H 8. Denmark Danish J 9. Belgium Dutch / French K 10. N...
Page 5 - EXTERIOR DIMENSIONS IMPINGER
CounterTop - 1300 Series Ops Manual 5 EXTERIOR DIMENSIONS IMPINGER ® OVEN MODELS OVEN ACCESSORIES NOTE: Optional Columnating Plates listed on pages 15-16. #1341 Exit Shelf – 12” Length #1343 Entry Incline Shelf – 12” Length #1342 Exit Shelf – 4” Length #1344 Entry Incline Shelf – 4” Length #1352 Ext...
Page 6 - United States and Canada:; WARNING
CounterTop - 1300 Series Ops Manual 6 ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL CODE REFERENCE IN USA When installed, this appliance must be electrically grounded and its installation must comply with the National Electric Code, ANSI-NFPA 70, latest version, the Manufacturer’s Installation Instru...
Page 7 - INSTAL LEGS AS SHOWN
CounterTop - 1300 Series Ops Manual 7 IMPINGER ® ASSEMBLY INSTRUCTIONS INSTAL LEGS AS SHOWN ! WARNING: Legs MUST be installed to insure proper operation! ! CAUTION: Oven must be operated on approved bases only. Bottom unit must always be mounted on legs provided. ! CAUTION: Before applying power to ...
Page 9 - COUNTERTOP MOUNTING INSTRUCTIONS
CounterTop - 1300 Series Ops Manual 9 COUNTERTOP MOUNTING INSTRUCTIONS Position the oven on the countertop and carefully mark the position of the rear legs. Remove the oven from the countertop and position the mounting rings so that the large (center) hole is where the legs of the oven were marked. ...
Page 10 - caustic
CounterTop - 1300 Series Ops Manual 10 START-UP 1. Push switch to “ON.” The electric oven should come on immediately. 2. Turn oven dial to desired temperature. 3. Preheat oven for 30 minutes. 4. To set belt speed, adjust oven time dial to reach desired time. SHUTDOWN 1. Push switch to “OFF.” Note: O...
Page 12 - CONVEYOR REMOVAL; Pull conveyor out the right end. Place on table or work surface.; CONNECTING; CORRECT
CounterTop - 1300 Series Ops Manual 12 CONVEYOR REMOVAL CONVEYOR DISASSEMBLY FOR CLEANING Pull conveyor out the right end. Place on table or work surface. CONNECTING LINKS IN FOUR PLACES 1. Remove extension shelves (if applicable). 2. Push coupling away from drive lugs. 3. Remove conveyor from oven ...
Page 13 - CONVEYOR REASSEMBLY; CONVEYOR BELT INSTALLATION
CounterTop - 1300 Series Ops Manual 13 CONVEYOR REASSEMBLY CONVEYOR BELT INSTALLATION 1. Put conveyor belt back on by setting the rolled belt to the left of the conveyor and thread approximately 2/3 of the belt over the bottom slider bed. 2. Put the loose end of the belt around the idler shaft and b...
Page 14 - FINGERS – REMOVAL AND DISASSEMBLY FOR CLEANING; DISASSEMBLY; DISASSEMBLE FINGERS FOR CLEANING
CounterTop - 1300 Series Ops Manual 14 FINGERS – REMOVAL AND DISASSEMBLY FOR CLEANING DISASSEMBLY CAUTION: Oven must be cool before proceeding. ! 1. Release ¼-turn fasteners (2 per panel) then pull back the panel. Lift panel off lower retaining tabs. 2. Lift finger assembly to clear hanger on front ...
Page 15 - FINGER ASSEMBLIES MUST BE INSTALLED AS SHOWN
CounterTop - 1300 Series Ops Manual 15 FINGER COVERS ARE MATCHED AND MAY BE INSTALLED IN ANY LOCATION NOTE: Assembly numbers are stamped on the outer edge of the finger cover. FINGER ASSEMBLIES MUST BE INSTALLED AS SHOWN IMPINGER ® FINGER COLUMNATING PLATES MODEL 1301 & 1302 SERIAL #3002168 AND ...
Page 17 - CONCEPTS; The Impinger
CounterTop - 1300 Series Ops Manual 17 CONCEPTS The Impinger ® Conveyor Oven produced by Lincoln Foodservice Products, LLC utilizes a revolutionary cooking concept called “AIR IMPINGEMENT.” It provides exceptional baked food product quality in far less time than conventional devices on the market. T...
Page 18 - APPENDIX A – LABEL DEFINITIONS
CounterTop - 1300 Series Ops Manual 18 APPENDIX A – LABEL DEFINITIONS
Page 20 - Lincoln Foodservice Products, LLC
CounterTop - 1300 Series Ops Manual 20 Lincoln Foodservice Products, LLC has developed a worldwide sales and service network second to none in our industry. It is headed by a sales, service and marketing management staff of more than 60 seasoned foodservice professionals. We manufacture and market I...