Liebherr LGex 910 - Manuals

Page 2 - sheets and bags can cause suffocation!; Safety instructions and warnings; It is essential to use these safety facilities to avoid damage

12 Adjustable-height feet Description of appliance and equipment Type plate Operating and control elements Disposal notes • Keep packaging materials away from children - polythene sheets and bags can cause suffocation! • Please return the packaging to an official collection point.Your old appliance:...

Page 3 - Ambient temperature; Control elements; Temperature display via product sensor is activated; (Hazard Analysis Critical Control Point)

13 Setting up • Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat. • The floor on which the appliance stands should be horizontal and level.Compensate for uneven floors with the adjustable feet. • Always ensure that there is good ventilation an...

Page 4 - Setting the temperature; Adjustable temperature range; Calling up the temperature history; To call up the temperature:; Switching the appliance on and off; To switch the appliance on: Keep the ON/OFF button

14 Setting the temperature • Press button for 1 second. The temperature display flashes. • To increase the temperature (warmer): press button . • To reduce the temperature (colder): press button . • Press button again. The desired temperature setting is saved. Adjustable temperature range LGUex 1500...

Page 5 - LO; Door open alarm

15 Audible warning signal The audible warning signal will sound in certain alarm events. It can be cancelled by pressing button . GB Alarm messages 1. LED flashes If appears in the display, the appliance has a fault. Consult your nearest customer service point. 2. LED flashes, which reads HI or LO T...

Page 6 - to increase or decrease the correction value

16 Example of an alarm query Situation: HACCP flashes in the display. Display = Display = There has not been an alarm status with a too high or too low temperature. You must switch to display . Display = Press this button until appears in the display. Display = 1 power failure has occurred. Display ...

Page 7 - Product sensor; Activating the sensor; Calibrating the product sensor; Switching the temperature display between; to change the network address

17 GB Product sensor (available accessory) The temperature may be measured or recorded at any point in the interior using the product sensor. • Connect sensor (see section entitled External alarm) Activating the sensor Press for 5 seconds. Display = Display = Display = Display = Display = Press for ...

Page 8 - Note; Resetting the parameters to factory settings

18 Cleaning Before cleaning always switch off the appliance. Pull out the mains plug or switch off or unscrew the fuse.• Clean the inside, equipment and outer walls with lukewarm water and a little detergent. Do not use abrasive or acid cleaners or chemical solvents. Do not use steam cleaners becaus...

Page 9 - Floating alarm output

19 GB Shutting your appliance down If your appliance is to be shut down for any length of time, switch it off and disconnect the plug or switch off or unscrew the fuse. Clean the appliance and leave the door open in order to prevent unpleasant smells. Malfunctions You may be able to rectify the foll...

Page 10 - Make sure that no pipes are bent.; Remove upper drawer before beginning work.; Opening for external temperature sensor

20 The condenser must be unscrewed to make the sensor cable opening accessible.1. Unscrew condenser screws (6 pcs.) and fold out condenser at an angle. Important! Make sure that no pipes are bent. Opening for external temperature sensor Model LGex 3410 Remove upper drawer before beginning work. 2. D...

Page 11 - Installation dimensions; Version 1; Important: The door mounting has; Changing over door hinges

21 GB Installation dimensions (mm) LGUex 1500 Version 1 A cross-section of min. 200 cm 2 is re quired in the worktop for ventilation of the rear of the appliance. Version 2 If no ventilation grille is provided in the worktop, the recess must be at least 860 mm high to ensure adequate heat dissipatio...