Liebherr HC1060 - Manuals

Fig. 6 u In the cabinet base, cut out a ventilation opening that is 17-23/32 in. (450 mm) in width and 2-7/32 in. (56 mm) in height. u Insert ventilation grille Fig. 6 (3) into the cabinet base cut- out Fig. 6 (1) . u From the back side, slide the snap-fits Fig. 6 (2) into the grille until the hooks...

u The total opening of the cabinet (i.e. 70-3/8 in. (1788 mm)) plus the thickness of the top as well as the floor board (usually 3/4 in. (19 mm)) minus the height of the freezer door panel (xxx in. (xxx mm)) as calculated above and subtract the width of the gap (approximately 1/8 in. (3 mm)): 70-3/8...

Note u Before assembling the unit door, make sure that the per- mitted weight for the unit doors is not exceeded. u Otherwise damage to the hinges and malfunctions aris- ing from this cannot be ruled out. Maximum weight of unit door Fridge compart- ment door 30.5 lbs (14 kg) Freezer compart- ment do...

u Slightly loosen the screws Fig. 20 (51) . u Secure the bottom mount- ing bracket Fig. 20 (50) to the unit wall with a ø4x19 chipboard screw Fig. 20 (29) . u Break off the protruding end of the cover Fig. 20 (53) . u Tighten the screws Fig. 20 (51) . u Place the cover Fig. 20 (54) into position on ...

u To align the unit door in depth Z: Undo the screws Fig. 25 (36) at the top and the hex head screws Fig. 25 (35) at the bottom using the ring wrench Fig. 25 (37) supplied, then move the door. u Do not allow the knobs and sealing lips to come into contact with the door - im- portant for function! u ...