Liebherr 7084000-01 - Manuals

Fig. 6 u In the cabinet base, cut out a ventilation opening that is 17-23/32 in. (450 mm) in width and 2-7/32 in. (56 mm) in height. u Insert ventilation grille Fig. 6 (3) into the cabinet base cut- out Fig. 6 (1) . u From the back side, slide the snap-fits Fig. 6 (2) into the grille until the hooks...

u The total opening of the cabinet (i.e. 70-3/8 in. (1788 mm)) plus the thickness of the top as well as the floor board (usually 3/4 in. (19 mm)) minus the height of the freezer door panel (xxx in. (xxx mm)) as calculated above and subtract the width of the gap (approximately 1/8 in. (3 mm)): 70-3/8...

Note u Before assembling the unit door, make sure that the permitted weight for the unit doors is not exceeded. u Otherwise damage to the hinges and malfunctions arising from this cannot be ruled out. Maximum weight of unit door Fridge compartment door 30.5 lbs (14 kg) Freezer compartment door 26.5 ...

u Slightly loosen the screws Fig. 20 (55) . u Secure the top mounting bracket Fig. 20 (50) to the unit wall with a ø4x19 chipboard screw Fig. 20 (29) . u Break off the protruding end of the cover Fig. 20 (53) . Fig. 20 u Tighten the screws Fig. 20 (55) . u Place the cover Fig. 20 (53) in position. O...

7 Connecting the appliance WARNING Electrical shock hazard! u Start-up should only take place once the appliance has been installed according to these instructions. u Electrically ground appliance. u Do not ground to a gas pipe. u Check with a qualified electrician if you are not sure the appliance ...