Liebherr 7083 461-00 - Manuals

Page 2 - Content

2 Setting up • Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat. • The floor on which the appliance stands should be horizontal and level. • The ventilation grilles should not be obstructed. Always ensure that there is good ventilation and tha...

Page 3 - Important

3 Appliance dimensions A = 76 mm B = 2027 mm C = 757 mm D = 610 mm E = 1413 mm F = 952 mm Installation dimensions The location of the socket can within a radius of 2000 mm from the appliance top center. The ice maker is fitted in the freezer compartment of the combined refrigerator-freezer. It must ...

Page 4 - Mounting the anti-tipping device; If the floor slopes down sideways, the anti-tipping; Mounting options

4 Mounting the anti-tipping device WARNING! The supplied anti-tipping bracket must be installed in all cases. This prevents the appliance from tipping over when the fully loaded door is opened. Installation: 1. Mark the centre line of the appliance on the floor. Align the anti-tipping bracket centre...

Page 7 - Side view of the freezer drawer; Leveling the appliance; To prevent the appliance from tipping forward the level-

7 Fastening the appliance in the recess Once in the recess, secure the appliance to the body of the unit using the securing plates (4 x 16 screws). Then click the covers sup- plied into place. Adjusting the refrigerator door The lateral tilt of the refrigerator door can be adjusted if required. Undo...

Page 8 - Mounting the ventilation grille

8 5. Insert the locking pins to block the sup- ports. Mounting the ventilation grille Pull out the bottom freezer drawer. 1. Remove the blue protection film from the dust filter provided and insert the filter into its opening in the plinth . Engage the filter at the bottom, press down the button and...

Page 9 - Panel dimensions; Maximum panel weight; Before fitting the door panels; The securing nuts are needed for re-mounting the pre-

9 Panel dimensions Min. panel thickness = 16 mm Max. panel thickness = 19 mm Maximum panel weight Refrigerator panel = 27 kg Freezer drawer panel = 10 kg Before fitting the door panels Remove the cover 1 and unscrew the top and bottom attach- ment brackets 2 from the refrigerator door. These attachm...

Page 10 - Mounting the attachment brackets onto the door panels; Refrigerator door panel

10 Mounting the attachment brackets onto the door panels 1. Draw a line 1041 mm from the bottom side of the door panel.2. Draw a further line 107.5 mm from the bottom side of the door panel.3. Align one of the refrigerator door attachment brackets to the top line, as shown in the illustration below,...

Page 11 - Mounting the refrigerator panel

11 fig. D Mounting the refrigerator panel fig. A fig. B fig. C 1. Screw in the adjusting pins on the underside of the refrigerator door completely (fig. A) . 2. Open the refrigerator door and suspend the refrigerator panel on the top adjusting pins (fig. B) . 3. Screw securing nuts onto the adjustin...

Page 13 - Do not try to change over the door hinges yourself. The

13 Mounting the freezer panels 1. Pull out the top freezer drawer and screw on the pre-assembled panel. The same screws must be used as those used to screw on the attachment brackets (3.5 x 13). 2. Close the freezer drawer and check the position of the panel. Adjust the height of the panel by undoin...