Page 2 - ii; Packing List; The product package should include the following items:
ii Packing List The product package should include the following items: 1. Monitor2. Owner’s Manual3. Power Cord4. Swivel Base5. Diskette 3828TUO032A-1 99.5.31 1:34 PM ˘ ` ii
Page 3 - Table of Contents
iii Table of Contents Precautions Workplace preparation .............................................................................A1Working Practices ....................................................................................A2 Tilt/Swivel Base Installation .................................
Page 4 - Precautions; Danger; grounded power outlet.; Workplace preparation
A1 Precautions Danger To avoid shock hazard:• Do not remove the covers.• Do not operate this product unless the stand is attached.• Do not connect or disconnect this product during an electrical storm.• The power cord plug must be connected to a properly wired and grounded power outlet. • Any equipm...
Page 5 - Working Practices
A2 Working Practices RestTake regular breaks. Vary your posture, and stand up and stretchoccasionally as prolonged use of computer workstations can be tiring. BackYou should sit back in the chair and use the back rest. HandsUse a light touch on the keyboard, keeping your hands and fingersrelaxed. Al...
Page 6 - Notes
A3 Precautions Power Source: 1. Make sure the power cord is the correct type that required in your area. 2. This monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area ( No useradjustment is required. ) 3. Connect the power cord into your monitor...
Page 7 - Installation; the base of the monitor.
A4 Tilt/Swivel Base Turn Off the equipment and all attached options.Carefully set the monitor face-down with the underside facing you. Installation 1. Align the hooks on the tilt/swivel stand with the matching slots in the base of the monitor. 2. Insert the hooks into slots.3. Slide the tilt/swivel ...
Page 8 - Connections
A5 Installation The supply voltage is marked on the ID label located on the rearpanel of the monitor. If your local voltage is different, do not use themonitor and contact your supplier before using the display. Connections To connect your monitor after the video adapter is properly installed: 1. Tu...
Page 9 - Location and Function of Controls; Front View
A6 Location and Function of Controls Contrast Power On/Off Button Power Indicator Front View Rear View AC Power Connector Signal Cable ID Label Brightness Image Control Panel 3828TUO032A-1 99.5.31 1:34 PM ˘ ` A6
Page 10 - Image Control Panel
Power On/Off ButtonThis Button is used to turn the power On or Off. Power IndicatorThe power indicator lights when the power is On, and indicatesthe operating status of the display. ContrastAdjust the display to the contrast desired. Move the thumbwheellocated beneath this indicator to increase or d...
Page 11 - Description
A8 Image Control Icons Listed below are the icons, icon names, and icon descriptions ofthe items. To move picture image left and right. - Moves the screen image left. + Moves the screen image right. To adjust image width. - Decreases the size of the screen image. + Increases the size of the screen i...
Page 12 - Power Management System
A9 Power Management System When used in conjunction with a PC having power saving circuitry, ora PC running screen blanking software this monitor automaticallyreduces its power consumption when the computer is not in use.Themonitor has power-saving states, indicated by the light-emitting diode(LED) ...
Page 13 - General Operation; Turn on the monitor, PC and other peripherals you plan to use.
A10 General Operation After following the installation instructions and getting familiar with thecontrols, you are ready to operate the monitor. 1. Turn on the monitor, PC and other peripherals you plan to use. 2. After the PC has booted (powered up and finished self-testing), enter a software appli...
Page 14 - Video Memory Modes; Factory Preset Timing Signal Chart
Video Memory Modes Factory Preset Timing Signal Chart A11 Video Sync B A C F D E H O R I Z O N T A L V E R T I C A L Mode1 Mode2 Mode3 Mode4 Mode5 Polarity - - - + - Frequency kHz 31.47 37.5 43.3 46.875 48.36 Total Period uS 31.78 26.667 23.111 21.333 20.677 E Data Period uS 25.422 20.317 17.778 16....
Page 15 - Troubleshooting
A12 Troubleshooting Symptom: The power LED is amber. Possible causes: Display power management mode.There is no sync signal.The signal cable is not fastened securely.Check the computer power and graphics adapters configuration.The frequency of the sync input is outside the operating range ofthe moni...
Page 16 - Further help; Type, model and serial number from the label on the back of
A13 Further help If you are unable to correct the problem yourself, you may seekfurther help as follows: Call IBM HELPCENTER.In the US call 1-800-772-2227In Canada call 1-800-565-3344 In other countries, contact your dealer, retailer, or other IBMauthorized servicer. Before calling, please have avai...
Page 17 - Service; service personnel when :
A14 Service 1. Unplug the monitor from the wall outlet and refer servicing to alified service personnel when : The power cord or plug is damaged or frayed.Liquid has been spilled into the monitor.The monitor has been exposed to rain or water.The monitor does not operate normally following the operat...
Page 18 - Specifications; Sync Signal type
A15 Specifications Sync Signal type Type Separate sync H. sync H. sync V. sync V. sync Pin Separate Sync 1 Red 2 Green 3 Blue 4 Ground 5 Self-Test 6 Red Ground 7 Green Ground 8 Blue Ground 9 NC 10 Ground 11 Ground 12 SDA 13 Horiz.Sync 14 Vert.Sync 15 SCL 1 5 6 10 11 15 Signal Connector Pin Assignmen...
Page 19 - 0 degree deflection; Video Bandwidth : 65 MHz
A16 Specifications Picture tube : 14 inch (13.2 inches viewable), Tinted, 90 degree deflection 0.28 mm, Non-Glare screen Horizontal Frequency : 30 ~ 49 kHz Vertical Frequency : 50 ~ 90 Hz Display Area : 260 x 190 mm (H x V) Video Bandwidth : 65 MHz Resolution : 1024 x 768 Non Interlace, 60Hz Refresh...
Page 20 - Compliances; Federal Communications Commission(FCC) Statement; to which the receiver is connected.; Industry Canada Compliance Statement
A17 Compliances Federal Communications Commission(FCC) Statement This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residentia...
Page 22 - Service Information
A19 MPR IIThis product complies with Swedish National Council for Metrology(MPR) standards issued in December 1990 (MPR II) for very lowfrequency (VLF) and extremely low frequency (ELF). European Union (EU) StatementThis product has been tested and found to comply with the limits forClass B Informat...
Page 23 - Warranty; Statement of Limited Warranty
Warranty Statement of Limited Warranty The warranties provided by IBM in this Statement of Limited Warranty apply only toMachines you originally purchase for your use, and not for resale, from IBM or yourreseller. The term “Machine” means an IBM machine, its features, conversions,upgrades, elements,...