KitchenAid KFEG500EWH - Manuals

6 � Nonabrasive scrub sponges or eraser style cleaning pads(without cleaners) can be effective for cleaning the ovencavity walls, oven door and oven bottom for difficult soils.For best results, moisten the pads and sponges beforeuse. � Run an additional Clean cycle for stubborn soils. � Affresh ® Ki...

7 Cabinet Dimensions Cabinet opening dimensions shown are for 25" (64.0 cm)countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwavehood co...

8 If connecting to a 3-wire system: Local codes may permit the use of a UL listed, 3-wire, 250 V, 40 or50 A range power supply cord (pigtail). This cord contains 3copper conductors with ring terminals or open-end spadeterminals with upturned ends, terminating in a NEMA Type 10-50Pplug on the supply ...

9 Install Anti-Tip Bracket WARNING Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installationinstructions. Slide range back so rear range foot is engaged in theslot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved...

10 Level Range Determine if you have AquaLift ® Technology or Steam Clean by referring to the “Range Maintenance and Care” section. For Ranges with AquaLift ® Technology or Steam Clean: 1. Place level on the oven bottom as indicated in one of the twofigures below depending on the size of the level. ...

12 � Tighten strain relief screw against the power supply cord. Style 2: Direct wire strain relief � Remove the knockout as needed for the flexible conduitconnection. � Assemble a UL listed conduit connector in the opening. A. Removable retaining nutB. Conduit � Tighten strain relief screw against t...

13 5. Use 3/8" (9.5 mm) nut driver to connect the neutral (white)wire to the center terminal block post with one of the 10-32hex nuts. A. 10-32 hex nutB. Ground-link screwC. Line 2 (red) D. Green ground wireE. Neutral (center) wireF. Line 1 (black) 6. Connect line 2 (red) and line 1 (black) wire...

W11509613A ©202 1 All rights reserved. Used under license in Canada. 0 1/21 Moving the Range WARNING Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installationinstructions. Slide range back so rear range foot is engaged in theslot of ...

7 COOKTOP USE The control knobs can be set to anywhere between “H” and “L.” Push in and turn to setting. Ceramic Glass The surface cooking area will glow red when an element is on. Some parts of the surface cooking area may not glow red when an element is on. This is normal operation. It will also r...

8 Cooktop On Indicator Light The Cooktop On Indicator Light is located on the console panel. When any control knob on the console panel is turned on, the Cooktop On Indicator Light will glow. Hot Surface Indicator Light On ceramic glass models, the Hot Surface Indicator Light is located on the conso...

9 Check for flatness by placing the straight edge of a ruler across the bottom of the cookware. While you rotate the ruler, no space or light should be visible between it and the cookware. Use the following chart as a guide for cookware material characteristics. Use flat-bottomed cookware for best c...

10 OVEN USE Odors and smoke are normal when the oven is used the first few times, or when it is heavily soiled. IMPORTANT: The health of some birds is extremely sensitive to the fumes given off. Exposure to the fumes may result in death to certain birds. Always move birds to another closed and well-...

11 Languages - Scrolling Display Text Language options are English, Spanish and French. 1. Press OPTIONS until “LANGUAGE” is displayed.2. The current setting will be displayed.3. Press the number keypads to adjust the setting.4. Press OFF to save the setting and display the time of day. Energy Save ...

12 Positioning Racks and Bakeware IMPORTANT: To avoid permanent damage to the porcelain finish, do not place food or bakeware directly on the oven door or bottom. Bakeware To cook food evenly, hot air must be able to circulate. Allow 2" (5 cm) of space around bakeware and oven walls. Make sure t...

13 Temperature Management System The Temperature Management System electronically regulates the oven heat levels during preheat and bake to maintain a precise temperature range for optimal cooking results. The bake and broil elements or burners cycle on and off in intervals. On convection range mode...

14 EasyConvect™ Conversion Convection cooking temperatures and times can differ from those of standard cooking. Depending upon the selected category, EasyConvect™ conversion automatically reduces the standard recipe temperature and/or time you input for convection cooking.Foods are grouped into 4 ge...

15 RANGE CARE Clean Cycle AquaLift ® Technology is an innovative cleaning solution that utilizes heat and water to release baked-on spills from the oven in less than 1 hour. This new cleaning technology is a low-heat, odor-free alternative to traditional self-cleaning options.Allow the oven to cool ...

16 General Cleaning IMPORTANT: Before cleaning, make sure all controls are off and the oven and cooktop are cool. Always follow label instructions on cleaning products. For additional information, you can visit the Frequently Asked Questions (FAQs) section of our website at www.kitchenaid.com.Soap, ...

17 OVEN CAVITY Use AquaLift ® Technology regularly to clean oven spills. Do not use oven cleaners.Food spills should be cleaned when oven cools. At high temperatures, foods react with porcelain and staining, etching, pitting or faint white spots can result.Cleaning Method: ■ Clean cycle: See “Clean ...

18 ACCESSORIES For accessories in the U.S.A., you can visit our website at www.kitchenaid.com or call us at 1-800-422-1230. Clean cycle did not work on all spills Several cooking cycles between Clean cycles or spills on oven walls and doors - Run additional Clean cycles. Use the AquaLift ® Technolog...

5 Electrical Requirements If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. Do not use an extension cord. Be sure that the electrical connection and wire size a...

6 INSTALLATION INSTRUCTIONS Unpack Range 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do not remove the shipping base at this time. 4. On Ranges Equipped with a Storage Drawer: Remove the storage drawer. See the “Storage Drawer” ...

8 Electrical Connection 1. Disconnect power. 2. Remove the terminal block cover screws located on the back of the range. Pull cover down and toward you to remove cover from range. 3. Remove plastic tag holding three 10-32 hex nuts from the middle post of the terminal block. 4. Add strain relief. Sty...

9 Style 2: Direct Wire Strain Relief ■ Remove the knockout as needed for the flexible conduit connection. ■ Assemble a UL listed conduit connector in the opening. ■ Tighten strain relief screw against the flexible conduit. 5. Complete installation following instructions for your type of electrical c...

10 5. Use ³⁄₈ " nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10–32 hex nuts. 6. Connect line 2 (red) and line 1 (black) wires to the outer terminal block posts with 10-32 hex nuts. 7. Securely tighten hex nuts. NOTE: For power supply cord repla...

11 1. Cut out and remove part of metal ground strap, as shown. 2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 3. Pull the wires through the strain relief on bottom of range. Allow en...

14 Style 2: Ranges Equipped with a Warming Drawer or Premium Storage Drawer: Use a wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in the anti-tip bracket. NOTE: Range must be level for satisfactory ...

15 3. Slowly push the drawer into the range. NOTE: When properly installed, the rear slides on the bottom of the drawer will engage the base rails and the drawer will not tip when items are placed in the drawer. Complete Installation 1. Check that all parts are now installed. If there is an extra pa...