Kenwood SPECTRUM 1050 AV- Manuals

Welcome Setting up your system isn't difficult but getting your system up and running will be even easier if you follow the step-by-step directions In this manual. Unpacking Unpack all of the components care­ fully, and examine them for shipping damage. If any are damaged or fail to operate, notify ...

How to get replacement parts for your rack If any of the rack parts are missing or damaged, contact the following company for replacement parts: Tocabi America 755 Otay Valley Road Chula Vista, CA 91911 (619) 661-6136 Use the following parts list to identify missing or damaged parts: Description Qua...

Placing your system Stacking your components in the rack To make sure that they're properly ventilated and stable, stack them according to the following diagram. If you're using a turntable, place it on top of the rack. Assembling the speaker stands ose'i itane le>' irac iiot ¡n ita ipcludeci ai^...

Connecting your antennas < The quality of your FM./AM recep­ tion depends on how well you piace your antennas. So please foliow the instructions carefuily. Connecting the antenna wires to the antenna jacks I Unlock lever 2 Insert wire 3 Lock lever Using the AM indoor loop antenna (supplied) Place...

This diagram will help you connect your or VCR to your system. The cables shown in the diagram are not mciudec with your system. If you need help, refer to the manual that came with each video component. Connecting your video components 4 21 .

Connecting the system control cables Connect the system control cables as shown below. Be sure to push the plugs all the way in. 09

t Connecting other audio components 4 You can connect a graphic equalizer or similar component to your system. Remove the shorting plugs from the ‘Adapter jacks, and connert the component to those jacks. KA-996 Integrated Amplifier (back detail) A few tips: • Read the manual that cam-e with the othe...

# Tumtng ON the power If you've connected all of the power and system control cables as we've shov.'n. you can turn on the power so the entire system from the Integrated amplifier. • Press the oov/er switch on the integrated amplifier (or the POWER Dutton on the remote) to turn the entire systenn. O...

Tiiniiig the speakers Setting the center speaker mode To get the best performance out of your system, you need to set the center speaker mode, even ;f you're not using a center speaker, 1 Turn the power to the system ON. 2 Make sure that the integrated amplifier is in either the DOLBY PRO LOGIC or D...

Setting the subwoofer level II The level control for the subwoofer is located on the rear panel of the power amplifier. 1 Select DOLBY PRO LOGIC mode. 2 Play video matenal with strong bass content that you're familiar with. 3 Adjust the subwoofer level so that it blends well with the other speakers....

Adjusting the delay time Setting the delay time compensates for the way our ears receive sound from' different directions. When you're watching a movie, the surround speakers are typically closer to you than the front speakers. Without using delay, sound from the surround speakers would reach your e...