Kenwood LZ-651W- Manuals

Page 2 - Safety Precaution; Before Use; English

To prevent injury and/or fire, take the following precautions: • Ensure that the unit is securely installed. Otherwise it may fly out of place during collisions and other jolts. • When extending the ignition or ground cables, make sure to use automotive-grade cables or other cables with an area of 0...

Page 3 - English 3; LZ-651W Basic Operation; mode

English 3 LZ-651W Basic Operation 1 Mode Setting switch Selects the target device to control.MON: Monitor control modeNAVI: Navigation system control modeAUD: Kenwood car audio system control mode 2 Volume Control button 3 Power button 4 Cursor button Selects the item when the menu screen isdisplaye...

Page 4 - English; Screen control; Adjusts the black level.; Setting Menu; Setup Menu

4 English 1 Press button. Menu screen is displayed, and the monitor enters tomenu mode. 2 Press or button to select the adjusting item, and press button. "SCREEN CONTROL": Adjust the picture quality (brightness, contrastetc.). "SETUP": Setup the picture input method and the beepsound...

Page 5 - English 5; Setup; It doesn’t switch the navigation picture.

English 5 Setup 1 Press button. 2 Select "SETUP", and press button. 3 Press or button to select the adjusting item. "NAV": Setup input and switch method of the navigationpicture. Item Setting "RGB"* When Kenwood navigation system is connectedby the dedicated cable. "AV-IN...

Page 6 - English; Installation

Installation Procedure Accessories 6 English English 1. To prevent short circuits, remove the key from the ignition and disconnect the · terminal of thebattery. 2. Make the proper input and output cable connections for each unit. 3. Connect the wiring harness cables in the following order: ground, i...

Page 7 - English 7; Connection; Navigation Unit

English 7 Connection +12V ACC MUTE PRK SW NAVI Navigation Unit Monitor Unit Connect TEL mute cable ofthe navigation system. Mute cable (Brown) Fuse (2A) ACC Ignition keyswitch Cable accompanyingthe Navigation System Bundle cables withthe clamper(Accessory A ) AV cable (Commercially available) AV inp...

Page 8 - Installation location and cleaning; Installation for Monitor Unit; English

Installation location and cleaning Select for installation a location where the stand can beplaced completely horizontal or where the front edge ofthe support (petal-shaped part) can be attachedhorizontally as shown in Figure A . Do not install in locations where the entire support is at adiagonal s...

Page 9 - English 9; Troubleshooting; The power does not turn on.; Specifications; Specifications subject to change without notice.; Monitor Unit

English 9 Troubleshooting What might appear to be a malfunction in your unit may just be the result of slightmisoperation or miswiring. Before calling service, first check the following table for possibleproblems. The power does not turn on. • The fuse has blown. • No ACC position on vehicle ignitio...

Page 10 - FCC WARNING

10 English English FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to thisequipment may cause harmful interference unless the modifications are expressly approved in theinstruction manual. The user could lose the authority to operate this equipment if ...