Page 2 - CONTENTS
2 Safety 3 Preparation 4 How to attach/detach the faceplate How to reset your unit How to prepare the remote controller (RC-405) Basic operations 5 Getting started 7 Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings before operations Listening to...
Page 3 - Safety; Maintenance
3 ENGLISH Safety WARNING Stop the car before operating the unit. Important to know... To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. Caution: Adjust the volume so that you can hear sounds outside the car. Driving with the volume to...
Page 4 - Preparation; How to attach/detach the faceplate
4 Preparation How to attach/detach the faceplate 2 1 1 2 Do not expose the faceplate to direct sunlight, excessive heat, or humidity. Also avoid places with too much dust or the possibility of water splashing. Keep the faceplate in its casing while detached. The faceplate is a precision piece of equ...
Page 5 - Basic operations
5 ENGLISH The following indicator lights up when... ST: A stereo broadcast is received (FM). IN: A disc is in the unit. Basic operations Volume knob Loading slot (Not used.) Ejects the disc Detaches the faceplate Display window Auxiliary input jack USB terminal Remote sensor Do not expose to bright ...
Page 7 - Getting started; Canceling the display demonstration
7 ENGLISH Getting started Canceling the display demonstration The display demonstration is always turned on unless you cancel it. When you turn on the power (or after you reset the unit), the display shows: [CANCEL DEMO] \ [PRESS] \ [VOLUME KNOB] 1 Press the volume knob. [YES] is selected as the ini...
Page 8 - Initial settings before operations
8 Initial settings before operations 1 Press SRC to enter [STANDBY] mode. 2 Press the volume knob to enter [FUNCTION] mode. 3 Turn the volume knob to select [INITIAL SET] , then press to enter. 4 Turn the volume knob to make a selection, then press to confirm. See table below for selection. 5 Hold t...
Page 9 - Listening to the radio
9 ENGLISH Hold for about 2 seconds to memorize the current station. Press briefly to recall memorized station. Adjust [SETTINGS] mode settings While listening to the radio... 1 Press the volume knob to enter [FUNCTION] mode. 2 Turn the volume knob to select [SETTINGS] , then press to enter. 3 Turn t...
Page 10 - Start playing a disc; Connecting an iPod
10 Start playing a disc 1 Press SRC to turn on the power. 2 Insert a disc into the loading slot. Playback starts automatically. 3 Press number button 6 ( ) to resume/pause playback (if necessary). Ejects the disc. (“NO DISC” appears and “IN” indicator goes off.) Press to select track/file. Hold to f...
Page 11 - Selecting Repeat Play
11 ENGLISH Direct Music Search (using the remote controller, RC-405) • Not available if Random Play is selected. • Not applicable for iPod, Kenwood Music Editor Light, and Kenwood Music Control. 1 Press DIRECT to enter Direct Music Search Mode. “– – –” appears. 2 Press the number buttons to enter th...
Page 12 - Selecting a song by alphabet
12 About compatible iPod/iPhone Selecting a song by alphabet 1 Press to enter Music Search mode. “SEARCH” appears. 2 Turn the volume knob to select a category, then press to confirm. 3 Press again to enter alphabet search mode. “SRCH <– – –>” appears. 4 Turn the volume knob to select the chara...
Page 13 - Listening to Pandora® internet radio; Station Search mode
13 ENGLISH About Pandora ® internet radio Preparation : Make sure [ON] is selected for [PANDORA SRC] . (page 8) The requirements for listening to Pandora® are as follows: Use an Apple iPhone or iPod touch running under iOS3 or later. Search for “Pandora” in the Apple iTunes App Store to find and ins...
Page 14 - Function settings
14 1 Press the volume knob to enter [FUNCTION] mode. 2 Turn the volume knob to select [AUDIO CTRL] or [SETTINGS] , then press to enter. 3 Turn the volume knob to make a selection, then press to confirm. See the following table for selection. Repeat step 3 until the desired item is selected/activated...
Page 16 - Troubleshooting
16 Troubleshooting Symptom Remedy/Cause Sound cannot be heard. Adjust the volume to the optimum level. / Check the cords and connections. “PROTECT” appears and no operations can be done. Check to be sure the terminals of the speaker leads are covered with insulating tape properly, then reset the uni...
Page 18 - Installation/connection; Basic procedure; Warning
18 Installation/connection Part list: A Faceplate.............................................................. (×1) B Escutcheon ......................................................... (×1) C Mounting sleeve ............................................. (×1) D Wiring harness ........................
Page 19 - Wiring connection
19 ENGLISH R L REAR/SW ANT CONT P. CONT MUTE Purple Wiring connection Fuse (10 A) Antenna terminal Car fuse box Car fuse box Battery Ignition key switch Blue/White(Power control wire) Red (Ignition wire) Yellow (Battery wire) Black (Ground wire) To the metallic body or chassis of the car To the powe...
Page 21 - Specifications
21 ENGLISH FM tuner section Frequency range: 200 kHz space: 87.9 MHz — 107.9 MHz Usable sensitivity (S/N= 26 dB): 11.2 dBf (1.0 μV/75 Ω) Quieting sensitivity (DIN S/N = 46 dB): 19.2 dBf (2.5 μV/75 Ω) Frequency response (±3 dB): 30 Hz — 15 kHz Signal-to-Noise ratio (MONO): 63 dB Stereo separation (1 ...
Page 22 - CONTENIDO
2 Seguridad 3 Preparativos 4 Cómo instalar/desmontar la placa frontal Cómo reposicionar su unidad Cómo preparar el mando a distancia (RC-405) Funciones básicas 5 Procedimientos iniciales 7 Cancelación de las demostraciones en pantalla Ajuste del modo de demostración Ajuste del reloj Ajustes iniciale...
Page 23 - Seguridad; Mantenimiento
3 ESPAÑOL Seguridad ADVERTENCIA Detenga el automóvil antes de operar la unidad. Información importante… Para evitar cortocircuitos, nunca coloque ni deje objetos metálicos (por ejemplo, monedas o herramientas metálicas) dentro de la unidad. Precaución: Ajuste el volumen de forma tal que pueda escuch...
Page 24 - Preparativos; Cómo reposicionar su unidad
4 Preparativos Cómo instalar/desmontar la placa frontal 2 1 1 2 No exponga la placa frontal a la luz directa del sol, calor excesivo ni humedad. Además deberá evitar sitios con mucho polvo o la posibilidad de que se derrame agua sobre ella. Guarde la placa frontal en su estuche cuando se encuentre d...
Page 25 - Funciones básicas
5 ESPAÑOL El siguiente indicador se enciende cuando... ST: se recibe una difusión en estéreo (FM). IN: existe un disco en la unidad. Funciones básicas Rueda de volumen Ranura de carga (Sin utilizar.) Expulsa el disco Desmonte la placa frontal Toma de entrada auxiliar Terminal USB Sensor remoto DO lo...
Page 27 - Procedimientos iniciales; Cancelación de las demostraciones en pantalla
7 ESPAÑOL Procedimientos iniciales Cancelación de las demostraciones en pantalla La demostración en pantalla está siempre activada a menos que la cancele. Cuando enciende la unidad (o después de reposicionarla) la pantalla muestra: [CANCEL DEMO] \ [PRESS] \ [VOLUME KNOB] 1 Pulse la rueda de volumen....
Page 28 - Ajustes iniciales previos a las operaciones
8 Ajustes iniciales previos a las operaciones 1 Pulse SRC para ingresar en el modo [STANDBY] . 2 Pulse la rueda de volumen para ingresar en el modo [FUNCTION] . 3 Gire la rueda de volumen para seleccionar [INITIAL SET] , después púlsela para ingresar. 4 Gire la rueda de volumen para seleccionar, des...
Page 29 - Ajuste de la configuración del modo [SETTINGS]; Para escuchar la radio
9 ESPAÑOL Mantenga pulsado durante aproximadamente 2 segundos para memorizar la emisora actual. Pulse brevemente para recuperar la emisora memorizada. Ajuste de la configuración del modo [SETTINGS] Cuando escucha la radio... 1 Pulse la rueda de volumen para ingresar en el modo [FUNCTION] . 2 Gire la...
Page 30 - Comience a reproducir un disco; Escucha de un disco/ dispositivo USB/ iPod; Conexión de un iPod
10 Comience a reproducir un disco 1 Pulse SRC para encender la unidad. 2 Inserte un disco en la ranura de carga. La reproducción se inicia automáticamente. 3 Pulse el botón numérico 6 ( ) para reanudar/pausar la reproducción (si fuera necesario). Expulsa el disco. (Aparece el mensaje “NO DISC” (sin ...
Page 33 - Para escuchar la radio por Internet Pandora®; Modo de búsqueda de emisora
13 ESPAÑOL Acerca de la radio por Internet Pandora ® Preparativos : Asegúrese de haber seleccionado [ON] para [PANDORA SRC] . (página 8) Los requisitos para escuchar Pandora® son los siguientes: Utilice un Apple iPhone o iPod touch que funcione con el sistema iOS3 o versiones posteriores. Busque “Pa...
Page 34 - Configuraciones de las funciones
14 1 Pulse la rueda de volumen para ingresar en el modo [FUNCTION] . 2 Gire la rueda de volumen para seleccionar [AUDIO CTRL] o [SETTINGS] , después púlsela para ingresar. 3 Gire la rueda de volumen para seleccionar, después púlsela para confirmar. Para realizar la selección, consulte la siguiente t...
Page 36 - Localización de averías
16 Localización de averías Síntoma Soluciones/Causas El sonido no se escucha. Ajuste el volumen al nivel óptimo. / Inspeccione los cables y las conexiones. Aparece “PROTECT” y no se puede realizar ninguna operación. Asegúrese de que los terminales de los conductores de altavoz estén correctamente cu...
Page 38 - Procedimiento básico; Advertencia
18 Instalación/conexión Lista de componentes: A Placa frontal ....................................................... (×1) B Escudete............................................................... (×1) C Manguito de montaje ................................. (×1) D Mazo de conductores ..................
Page 39 - Conexión del cableado
19 ESPAÑOL Conexión del cableado R L REAR/SW ANT CONT P. CONT MUTE Fusible (10 A) Terminal de la antena Caja de fusibles del vehículo Caja de fusibles del vehículo Batería Interruptor de la llave de encendido Azul/blanco(Cable de control de potencia) Rojo (Cable de encendido) Amarillo (Cable de la b...
Page 41 - Especificaciones
21 ESPAÑOL Sección del sintonizador de FM Gama de frecuencias: Espacio de 200 kHz: 87,9 MHz — 107,9 MHz Sensibilidad útil (Relación señal/ruido = 26 dB): 11,2 dBf (1,0 μV/75 Ω) Sensibilidad de silenciamiento (DIN S/N = 46 dB): 19,2 dBf (2,5 μV/75 Ω) Respuesta de frecuencia (± 3 dB): 30 Hz — 15 kHz R...