Page 2 - TABLE OF COIMTEIXITS
TABLE OF COIMTEIXITS Dash Disassembly • Chrysler Aspen 2007 ........ ......................... .1 • Dodge Durango 2004-2006 ............................. ............. 1 ■ Dodge Charger 2005-2006 ........................................... 2 - Dodge Magnum 2005-2006 .................. .................
Page 3 - CHRYSLER ASPEIM gOD7
CHRYSLER ASPEIM gOD7 DODGE DURAIMGO B004-B00G 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Remove (2) 7MM screws from the inside of the pocket facing upward. (Figure A) 3 Unclip and remove the entire trim panei surrounding the radio and climate controls, (Figu...
Page 6 - WITHOUT CEIXITER COI^SOLE
DODGE RAM 8006 WITHOUT CEIXITER COI^SOLE 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Open cup holder and remove (2) Phillips screws facing up on front edge of radio/climate control panel. (Figure A) 3 Unclip and remove entire panel sur rounding radio and cli...
Page 7 - If vehicle has floor shifter, remove shifter
DODGE RAM SOOB WITH IVIIIMI CEIMTER CDIMSDLE 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 If vehicle has floor shifter, remove shifter knob. 3 Remove center console inserts, if present, (Figure A) 4 Remove screws securing the rear center console to the floor p...
Page 8 - Unclip and remove entire panel surrounding
DODGE HAM BOOB WITH FULL CE1\TER COiXiSDLE Disconnect the negative battery terminal to prevent an accidental short circuit. If vehicle has floor shifter, remove shifter knob, I Unsnap and remove console front top cover (closest to the dash}. (Figure A) t Remove two 8 mm screws from under consofe cov...
Page 11 - DIIM RADIO PROVISIOIM WITH POCKET; Slide the DIN cage into the radio
DIIM RADIO PROVISIOIM WITH POCKET 1 Slide the DIN cage into the radio housing and secure by bending the metal locking tabs down. (Figure A) 2 Slide the aftermarket radio into the cage until secure. (Figure 8] 3 Snap the pocket into the radio housing. (Figure C) 4 Continue to final assembly.
Page 12 - ISO RADIO PROVISIOIM WITH POCKET; Mount the ISO Brackets to the radio; Snap the pocket into the radio housing.
ISO RADIO PROVISIOIM WITH POCKET 1 Mount the ISO Brackets to the radio with the screws supplied with the unit. (Figure A) 2 Slide the radio into the radio opening until the side clips engage. (Figure B) 3 Snap the ISO Trim Plate into the radio housing. (Figure C) 4 Snap the pocket into the radio hou...
Page 13 - DOUBLE Olivi RADIO PROVISIOIM
DOUBLE Olivi RADIO PROVISIOIM 1 Cut and remove center divider in radio housing. (Figure A) 2 Snap the DDIN brackets to the inside edge of the radio housing. (Figure B) Slide the DDIN radio unit into the DDIN bracket/radio housing assem bly and secure the radio unit to the kit using the screws suppl...
Page 14 - Snap the ODIN trim-piate onto the
STACKED ISO UIXIITS PROVISIDIM 1 Cut and remove center divider in radio housing. (Figure A} 2 Snap the ODIN brackets to the inside edge of the radio housing. (Figure B) 3 Slide the stacked ISO DIN radio units into the ODIN bracket/radio housing assembly and secure the unit to the kit using the screw...