Kenwood CA-C1AX - Manuals

— 5 — • If you experience problems during installation, consult your Kenwood dealer. • If the unit does not seem to be working right, try pressing the reset button first. Ifthat does not solve the problem, consultyour Kenwood dealer. • Press the reset button if the Disc auto changer fails to operate...

— 6 — English About CDs Handling CDs • Don’t touch the recording surface of the CD. • CD-R and CD-RW are easier to damage than a normal music CD. Use a CD-R or a CD-RWafter reading the caution items on thepackage etc. • Don’t stick tape etc. on the CD. Also, don’t use a CD with tape stuck on it. Whe...

Turning the volume down quickly. Press the [ATT] button. Each time the button is pressed the Attenuator turns ON or OFF.When it’s ON, the "ATT" indicator blinks. Attenuator Increasing Volume Press the [ u ] button. Decreasing Volume Press the [ d ] button. Volume Press the [SRC] button. Sour...

Fine-tuning so that the System Q value is optimal when settingthe speaker type. 1 Enter Standby Press the [SRC] button. Select the "OFF" display. 2 Enter Speaker Setting mode Press the [Q] button. Speaker Setting 1 Select the source for adjustment Press the [SRC] button. 2 Enter Audio Contro...

Function of the KDC-219/KDC-2019V/KDC-2019/KDC-29MR/KDC-217/KDC-217S A red indicator will blink on the unit after the faceplate isremoved, warning potential thieves. 1 Turn the power OFF Press the [SRC] button for at least 1 second. 2 Set the DSI While pressing the [#1] and [#3] button, press the [S...

Tuner features Function of the KDC-219/KDC-2019V/KDC-2019/KDC-29MR/KDC-217/KDC-217S The faceplate of the unit can be detached and taken with you,helping to deter theft. Removing the Faceplate Press the Release button. The faceplate is unlocked, allowing you to detach it. • The faceplate is a precisi...

Calling up the stations in the memory. 1 Select the band Press the [FM] or [AM] button. 2 Call up the station Press the [#1] — [#6] button. Preset Tuning Putting stations with good reception in the memoryautomatically. 1 Select the band for Auto Memory Entry Press the [FM] or [AM] button. 2 Open Aut...

CD/External disc control features Temporarily have reception switched from stereo to mono toreduce multi-path noise when listening to the FM station. Press the [CRSC] button for at least 1 second. Each time the button is pressed CRSC turns ON or OFF.When it's ON, the CRSC indicator is ON. CRSC (Clea...

Replaying the song/disc you're listening to. Press the [REP] button. Each time the button is pressed the Repeat Play switches asshown below. Repeat play Display Track Repeat "REP" indicator & Track No. blink. Album Repeat "REP" indicator & Disc No. blink. (Function of disc ch...

When it's ON, the "RDM" indicator is ON and the track and discnumber blink. When the [ ¢ ] button is pressed, the next song select starts. Function of the KDC-219/KDC-2019V/KDC-2019/KDC-29MR Play the songs on all the discs in the disc changer in randomorder. Press the [M.RDM] button. Each ti...

[VOL.] buttons Adjusting the volume. [SRC] button Each time the button is pressed the source switches.For the source switching order refer to <Selecting the Source>(page 7). [ATT] button Turning the volume down quickly.When it is pressed again it returns to the previous level. Basic operations...

[ 4 ]/ [ ¢ ] buttons Doing track forward and backward. [DISC+]/ [DISC–] buttons Doing album forward and backward. [ 38 ] button Each time the button is pressed the song pauses and plays. In Disc source [FM]/ [AM] buttons Select the band.Each time the [FM] button is pressed it switches between theFM1...

— 17 — The use of any accessories except for those provided might result indamage to the unit. Make sure only to use the accessories shipped withthe unit, as shown above. 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Make the proper input and output...

English — 18 — P.CONT.OUT ANT. CONT. FRONT • L FRONT • R REAR • L REAR • R – + REAR L R FM/AM antenna input 1 Rear left output (White) 23 Rear right output (Red) 28 Fuse (10A) 24 2 KENWOOD disc changer control input (KDC-219/2019V/2019/29MR only) Wiring harness(Accessory 1 ) 25 29 White/Black 32 Gra...

— 19 — Make sure that the unit is installed securely in place. If the unit isunstable, it may malfunction (for example, the sound may skip). Metal mounting strap(commercially available) Self-tapping screw (commercially available) Firewall or metal support Screw (M4X8)(commerciallyavailable) ■ Instal...

English — 20 — ■ Removing the hard rubber frame 2 When the lower level is removed, remove the upper twolocations. The frame can be removed from the top side in the same manner. Catch Lock 1 Engage the catch pins on the removal tool and remove the twolocks on the lower level.Lower the frame and pull ...

— 21 — Troubleshooting Guide What might seem to be a malfunction in your unit mayjust be the result of slight misoperation or miswiring.Before calling service, first check the following tablefor possible problems. General ? The power does not turn ON. 01 ✔ The fuse has blown. ☞ After checking for sh...

English — 22 — Disc source ? "AVin" is displayed without achieving External disc control mode. 50 ✔ O-N switch is set to "O" side. ☞ Set the switch to "N" side. ✔ Unsupported disc changer is connected. 51 ☞ Connect the supported disc changer. (page 4) ? The specified disc doe...

English — 24 — Specifications Specifications subject to change without notice. FM tuner section Frequency range (200 kHz space) ............87.9 MHz – 107.9 MHzUsable sensitivity (S/N = 30dB) .................... 9.3dBf (0.8 µV/75 Ω ) Quieting Sensitivity (S/N = 50dB) ............... 15.2dBf (1.6 µV...