Kawasaki 840116 - Manuals

USE ONLY DRILL BITS, SANDING DRUMS, AND OTHER ACCESSORIES that are designed for the various speeds of this drill press. The drill bits, sandingdrums and other accessories should have a shank size 1/2" OR SMALLER. Unsuitable drill bits can break without warning throwing fragments outward athigh s...

FUNCTIONAL DESCRIPTION CONTROLS AND COMPONENTS: 1. Drill Bit 2. Column Assembly3. Feed Handles 4. Chuck Key5. Drill Chuck5. Head Assembly6. Knob (and mtg Hardware)7. Work Table ASSEMBLY Do not begin assembly of Bench-mounted Drill Press if the AC power cord isplugged into an AC power receptacle. Do ...

Ensure the spindle taper (Q) and the tapered hole in the drill chuck (R) are clean and free of any grease, lacquer, or rust preventativecoatings. These compounds can cause the drill chuck (R ) to seize wheninstalled on the spindle shaft (Q). INSTALLING THE DRILL CHUCK 1. Open the jaws of the drill c...

LASER GUIDE Use of controls or procedures, or performance of proce- dures other then those specified herein may result in hazardous radiation exposure. LASER SAFETY NEVER LOOK INTO THE LASER BEAM. Any contact with the eyes by the beam could cause injury. Do not use the laser when cutting reflective ...

17 18 STORE OUT OF REACH OF CHILDREN. Equipment should be in a high location or locked up to keep out of reach of children. It is not a toy. DO NOT TAMPER WITH THE LASER OUTPUT. Changing the performance of the laser to increase its output is prohibited. Any claim for damages or injuriesresulting fro...

Ensure that the switch toggle, when removed, is kept in a secure place. Once removed, the drill press will not start without it. ADJUSTING THE WORK TABLE 1. The worktable (1) can be raised or low- ered on the drill press column (2) byloosening the table clamp (3). SeeFigure 12. 2. After the table is...

1. Lift up the pulley cover (1). 2. Release the belt tension by loosen- ing the tension lock knob (2) locatedon the side of the drill press head.Loosen the tension lock knob (2) byturning it counterclockwise. 3. Pivot the motor (3) towards the front of the drill press. 4. While holding the motor piv...

3. Turn the spring housing (5) counter- clockwise to increase the spring ten-sion or clockwise to decrease thespring tension. 4. Turn nut (4 - inside) until it contacts the spring housing (5). Back nut (4)out 1/4 turn and tighten it againstnut (3 - outside) to hold the springhousing in place. 5. IMP...

Warranty Performance By purchasing the product, purchaser expressly acknowledges and agrees that theirsole and exclusive remedy under this warranty shall be strictly limited to the repairor replacement of any covered nonconforming items or parts thereof provided thatany such nonconforming item and/o...