Jet DC-1100CK - Manuals - manualsarea.com

Page 2 - Warranty and Service

2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authori zed Service Centers located throughout the Unite d States can give you quick service. In most cases, any of these Walter Meier Authori zed Servic...

Page 3 - Table of Contents

3 Table of Contents Warranty and Ser vice .................................................................................................................................2 Table of Contents ................................................................................................................

Page 6 - Ordering Replacement Parts

6 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for model DC-1100 Series Dust Collectors. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instr uctions...

Page 7 - Unpacking; Shipping Content; Base Unit

7 Unpacking The table below lists the shipping cartons that are included with the models of the DC-1100 Dust Collector. 1. Locate your particular model and verify that you have received the all t he correct cartons. 2. Check contents of each carton against the ship- ping content listings on this and...

Page 8 - Canister Filter Kit

8 Canister Filter Kit (SN 708639B) 1 – Handle (O) 1 – Canister Filter (P) 1 – Snap Ring (Q) 5 – Collector Bags (R) 1 – Canister Filter Hardware Bag (SN DC1100-CHP) Contains: (2) M10 Hex Nuts (S) (2) M10 Flat Washers (T) (1) M10 Lock Washer (U) (4) Knobs (V) Canister Filter Kit Contents Canister Filt...

Page 9 - Base Unit Assembly; Base

9 Base Unit Assembly Base 1. Install four casters to the underside of the base as pictured in Fig. 2. Referring to Figure 1: 2. Thread the hex nut (B) onto the caster shaft. Then slide the lock washer (A) over the caster shaft. Thread t he caster shaft into the t hreaded hole on the underside of the...

Page 11 - Filter Bag Kit Assembly; Filter Bag Installation

11 Filter Bag Kit Assembly If you purchased DC-1100BK Dust Collector, this section describes the assembly and installation of the contents of the Filter Bag Kit (SN 708636F). Filter Bag Installation Referring to Figure 7: 1. Place the hanger (A) on the hanger bracket (B). 2. Slide t he filter bag lo...

Page 12 - Canister Kit Assembly; Canister Filter; Collector Bag

12 Canister Kit Assembly If you purchased Model DC-1100CK Dust Collector, this section describes the assembly and installation of the contents of the Canister Kit (SN 70863 9B ). Canister Filter 1. Mount the handle onto the canister filter with two M10 hex nuts, two M10 flat washers, and a M10 lock ...

Page 13 - Electrical Connections; Turning the Machine On & Off; All Models

13 Electrical Connections All electrical connections must be done by a qualified electri- cian. All adjustments or repairs must be done with the dust collector disconnected from the power source, unplugged. Failure to comply may result in serious injury! The DC-1100 (all models) dust collectors are ...

Page 15 - Maintenance

15 Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause serious injury! Cleaning the Filter Bag – DC-1100BK Wearing a particle mask or respirator for protection against fine dust particles dur ing cleaning is...

Page 16 - Parts; Parts List –; DC

16 Parts Parts List – DC -1100A Dust Collector Index No. Part No. Descript ion Size Qty 1 .............. 411035W ................Impeller Housing............................................................................................. 1 2 .............. 411026W ................Motor Bracket .......

Page 17 - Parts Breakdown –

Page 18 - Canister Filter Assembly

18 Canister Filter Assembly Index No. Part No. Descript ion Size Qty 1 .............. 331050....................Handle ........................................................................................................... 1 2 .............. TS-1540071 ............Hex Nut...........................

Page 19 - Filter Bag Assembly

19 Filter Bag Assembly Index No. Part No. Descript ion Size Qty 1 .............. 708698....................Filter Bag ........................................................30 Micron ............................... 1 2 .............. AB410012 ...............Retainer Strap .............................