Jet DC-1100CK - Manual

7 Unpacking The table below lists the shipping cartons that are included with the models of the DC-1100 Dust Collector. 1. Locate your particular model and verify that you have received the all t he correct cartons. 2. Check contents of each carton against the ship- ping content listings on this and...

8 Canister Filter Kit (SN 708639B) 1 – Handle (O) 1 – Canister Filter (P) 1 – Snap Ring (Q) 5 – Collector Bags (R) 1 – Canister Filter Hardware Bag (SN DC1100-CHP) Contains: (2) M10 Hex Nuts (S) (2) M10 Flat Washers (T) (1) M10 Lock Washer (U) (4) Knobs (V) Canister Filter Kit Contents Canister Filt...

9 Base Unit Assembly Base 1. Install four casters to the underside of the base as pictured in Fig. 2. Referring to Figure 1: 2. Thread the hex nut (B) onto the caster shaft. Then slide the lock washer (A) over the caster shaft. Thread t he caster shaft into the t hreaded hole on the underside of the...

11 Filter Bag Kit Assembly If you purchased DC-1100BK Dust Collector, this section describes the assembly and installation of the contents of the Filter Bag Kit (SN 708636F). Filter Bag Installation Referring to Figure 7: 1. Place the hanger (A) on the hanger bracket (B). 2. Slide t he filter bag lo...

12 Canister Kit Assembly If you purchased Model DC-1100CK Dust Collector, this section describes the assembly and installation of the contents of the Canister Kit (SN 70863 9B ). Canister Filter 1. Mount the handle onto the canister filter with two M10 hex nuts, two M10 flat washers, and a M10 lock ...

13 Electrical Connections All electrical connections must be done by a qualified electri- cian. All adjustments or repairs must be done with the dust collector disconnected from the power source, unplugged. Failure to comply may result in serious injury! The DC-1100 (all models) dust collectors are ...

15 Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause serious injury! Cleaning the Filter Bag – DC-1100BK Wearing a particle mask or respirator for protection against fine dust particles dur ing cleaning is...

16 Parts Parts List – DC -1100A Dust Collector Index No. Part No. Descript ion Size Qty 1 .............. 411035W ................Impeller Housing............................................................................................. 1 2 .............. 411026W ................Motor Bracket .......

18 Canister Filter Assembly Index No. Part No. Descript ion Size Qty 1 .............. 331050....................Handle ........................................................................................................... 1 2 .............. TS-1540071 ............Hex Nut...........................

19 Filter Bag Assembly Index No. Part No. Descript ion Size Qty 1 .............. 708698....................Filter Bag ........................................................30 Micron ............................... 1 2 .............. AB410012 ...............Retainer Strap .............................