Page 2 - Warranty and Service
2 JAT-821 Pneumatic Flux Chipper Warranty and Service JET warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warr...
Page 3 - Safety warnings; General air tool warnings
JET 3 Safety warnings General air tool warnings 1. Read and understand this entire manual bef ore attempting assembly or operation. 2. Read and understand all warnings posted on the tool and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace warning l...
Page 4 - Specific warnings for Flux Chipper
4 JAT-821 Pneumatic Flux Chipper 20. Do not use power tools in damp or wet location, or expose them to rain. Keep work area well lighted. 21. Do not leave a connected tool unattended. W hen not in use, disconnect tool from air source. 22. Shut off air supply and discharge any residual pressure fro...
Page 5 - About this manual
JET 5 About this manual This manual is provided by JET, covering the saf e operation and maintenance procedures f or a JET Model JAT-821 Pneumatic Flux Chipper. This manual contains instructions on saf ety precautions, general operating procedures, maintenance procedures and parts breakdown. Your ...
Page 6 - Tool specifications
6 JAT-821 Pneumatic Flux Chipper Tool specifications Model number JAT-821 Stock number 505821 Stroke length 7/8 in. Chisel included W ide angle type Blows per minute 4600 Average air consumption 3 CFM Air inlet 1/4 in. NPT Air hose inside diameter 3/8 in. Required air pressure 90 psi (621 kPa) Vib...
Page 7 - Maintenance; Lubrication; Storage
JET 7 Setup and Assembly Any missing parts or damage should be reported immediately to your JET ® distributor. Do not use a damaged tool. Read this instruction manual thoroughly for operation, maintenance and saf ety instructions. Box contents: 1 Flux chipper 1 Chisel 1 Operation and parts manual ...
Page 10 - Troubleshooting JAT-821 Flux Chipper
10 JAT-821 Pneumatic Flux Chipper Troubleshooting JAT-821 Flux Chipper Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or ...
Page 12 - Replacement parts
12 JAT-821 Pneumatic Flux Chipper Replacement parts Service parts are listed on the f ollowing pages. T o order parts or reach our service department, call 1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial number of your tool available when y...
