Jasco 45246 - Manuals - manualsarea.com

Page 2 - Table of Contents; Cycle Time Setting (Time Interval between

Table of Contents Product Features .................................................................... 3 Package Contents .................................................................. 4 Before you Install .................................................................... 4 Choosing A Camera ...

Page 4 - PACKAGE CONTENTS

4 PACKAGE CONTENTS Please check and identify all the parts before proceeding with the installation.1. Wireless camera and receiver2. Mounting hardware for camera (3 screws, 3 plastic anchors)3. 2 AC adapters4. AV cable5. Adjustment wrenchBEFORE YOU INSTALL When choosing the best location for the pla...

Page 5 - CHOOSING A CAMERA MOUNTING LOCATION

5 CHOOSING A CAMERA MOUNTING LOCATION The Wireless Color Camera is suitable for indoor or outdoor use. When choosing a mounting location, please be advised: • This camera is designed to be reliable for outdoor use; and its flexible design allows it to be used indoors as well. • If using outdoors, ta...

Page 12 - Channel Selection). Plug the AC adapter for the

12 1. Plug the AC adapter for the Wireless Receiver (labeled ‘Receiver’) into the power jack (marked ‘DC 9V’ on the back of the receiver), then into an AC outlet. Select the desired channel on the back of the receiver (see Receiver Channel Selection). 2. After selecting the channel for the camera (s...

Page 16 - (b) If the cable needs to be ran through a wall or; ceiling, then an additional hole will need to be; Drill the hole in the; before securing the mounting bracket.; Figure A (Running cable on surface of wall); Figure B

16 (b) If the cable needs to be ran through a wall or ceiling, then an additional hole will need to be drilled using the 3/8” drill bit. Drill the hole in the center of the three mounting screw holes (see figure B). Fit connector and cable through hole before securing the mounting bracket. Figure A ...

Page 17 - Step 3. Mounting bracket; Figure C (Mounting bracket using plastic anchors)

17 Step 3. Mounting bracket (a) If mounting to a stud, wood surface or other non-brick material, use the 1/8” drill bit to drill pilot holes; drill holes. Align holes in mounting bracket to drilled holes, insert screws and screw in until plate has secure fit. Do not over tighten screws. (b) If mount...

Page 18 - Proper

18 (d) Take care to position the camera in the correct orientation. To ensure the camera image is not positioned upside down, you may have to rotate the camera housing so the channel slelection switch is positioned above the lens and the light sensor is below the lens. Step 4. Antenna Adjustment Onc...

Page 21 - SPECIFICATIONS; CAMERA

21 2. Make sure the sound is within the microphone range. 3. If the unit emits a loud wailing sound (feed back), try moving the camera away from the receiver or angle the receiver differently. 4. Make sure the audio cable is connected to the TV/ monitor. SPECIFICATIONS (Subject to change without not...

Page 22 - ONE-YEAR LIMITED WARRANTY

22 ONE-YEAR LIMITED WARRANTY Jasco Products Company warrants this product to be free from manufacturing defects for a period of one year from the original date of consumer purchase. This warranty is limited to the repair or replacement of this product only and does not extend to consequential or inc...

Page 23 - FCC STATEMENT; WARNING; ADVERTENCIA

23 FCC STATEMENT This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. FCC NOTE: T...