Jasco 45245 - Manuals - manualsarea.com

Page 2 - Table of Contents

2 Table of Contents Product Features .................................................................... 3 Package Contents .................................................................. 4 Choosing A Camera Mounting Location ..................... 4 Long Range Night Vision .........................

Page 3 - PRODUCT FEATURES

3 Thank you for purchasing the GE Wireless Add-on Color Camera. This product is intended for use as an add-on camera for the GE Home Monitoring Surveillance Systems. Please review these instructions carefully before attempting to operate the camera. PRODUCT FEATURES • Weather resistant metal camera ...

Page 7 - CAMERA CHANNEL SELECTION

7 Wireless Camera Systems - 45234, 45236, 45239, 45246. Each system can accept a maximum of two cameras. CAMERA CHANNEL SELECTION Each wireless camera must be assigned to a specific channel (1 or 2) through the use of a slide switch located on the inside of the camera housing. First slide off the su...

Page 9 - Figure A (Running cable on surface of wall); Figure B

9 Step 2. Cable routing -IMPORTANT (a) If running the cable along the wall surface, position cable through slot at base of mounting bracket before installing mounting bracket (see figure A). (b) If the cable needs to be ran through a wall or ceiling, then an additional hole will need to be drilled u...

Page 10 - Step 3. Mounting bracket; Figure C (Mounting bracket using plastic anchors)

10 Step 3. Mounting bracket (a) If mounting to a stud, wood surface or other non-brick material, use the 1/8” drill bit to drill pilot holes; drill holes. Align holes in mounting bracket to drilled holes, insert screws and screw in until plate has secure fit. Do not over tighten screws. (b) If mount...

Page 11 - Proper

11 (d) Take care to position the camera in the correct orientation. To ensure the camera image is not positioned upside down, you may have to rotate the camera housing so the channel slelection switch is positioned above the lens and the light sensor is below the lens. Step 4. Antenna Adjustment Onc...

Page 13 - Blank monitor; Make sure receiver or monitor is switched ON, and; Interference on camera picture; range, and that no large obstructions are blocking the

13 Blank monitor 1. Make sure receiver or monitor is switched ON, and the correct video input has been selected.2. Ensure AC adapters are completely plugged into the socket and the camera and/or receiver’s power indication light is on. Interference on camera picture 1. Make sure each camera (transmi...

Page 14 - Audio problems; Ensure the volume is turned up sufficiently on the

14 Audio problems 1. Ensure the volume is turned up sufficiently on the Monitor (or TV).2. Make sure the sound is within the microphone range.3. If the unit emits a loud wailing sound (feeds back), try moving the camera away from the receiver or angle the receiver differently.

Page 15 - SPECIFICATIONS; CAMERA

15 SPECIFICATIONS (Subject to change without notice.) CAMERA TV System ..................................................................................................... NTSC Integrated Lens .................................................. 6.0mm, F1.5 fixed focus Resolution .......................

Page 16 - ONE-YEAR LIMITED WARRANTY

16 ONE-YEAR LIMITED WARRANTY Jasco Products Company warrants this product to be free from manufacturing defects for a period of one year from the original date of consumer purchase. This warranty is limited to the repair or replacement of this product only and does not extend to consequential or inc...

Page 17 - FCC STATEMENT; WARNING; ADVERTENCIA

17 FCC STATEMENT This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. FCC NOTE: T...

Page 18 - Notes