Jackson JPX-160 - Manuals

Jackson JPX-160 – Manual in PDF format online.

Manuals:

Manual

Manual Jackson JPX-160

Summary

Page 3 - TABLE OF CONTENTS

SECTION DESCRIPTION PAGE I. INSTRUCTIONS Installation Instructions 1 Chemical Dispensing Equipment 2 Chemical Timer Adjustments 3 Operation Instructions 5 PC Board 7 II. TROUBLESHOOTING 8 III. JPX-140 Specifications of the JPX-140 9 Dimensions JPX-140 10 Front Assembly 11 Electrical Panel 12 Front a...

Page 4 - INSTALLATION INSTRUCTIONS

VISUAL INSPECTION: Before installing the unit, check the container and machine for damage. A damaged container is an indicator thatthere may be some damage to the machine. If there is damage to boththe container and machine, do not throw away the container. The dish-machine has been inspected and pa...

Page 5 - CHEMICAL DISPENSING EQUIPMENT

This page does not apply to the JPX-140 dishmachine. This unit is not supplied with chemical pumps. The JPX-160 and JPX-200 dishmachines are supplied with detergent and rinse additive chemical feeder pumps. TO PREPARE PUMPS FOR OPERATION Locate the open ends of the chemical tubes, insert the end of ...

Page 6 - CHEMICAL TIMER ADJUSTMENTS

This page does not apply to the JPX-140 dishmachine. In general, it should not be necessary to alter the machine settings. The factory settings have been established to give the best results. IMPORTANT : To avoid wasting chemicals, remove tubes from soap and rinse-agent bottles before using the Serv...

Page 7 - CHEMICAL TIMER ADJUSTMENTS CONTINUED

Use the chart below to determine the initial time values for INITIAL RINSE, CYCLE RINSE, INITIAL SOAP, and CYCLE SOAP basedon the desired concentration of the chemical being used. Check the concentration of the chemicals after running a few cycles and read -just as necessary. CHEMICAL TIMER ADJUSTME...

Page 8 - OPERATION INSTRUCTIONS

PREPARATION: Before proceeding with the start-up of the unit, verify the following: 1. Remove all solid wastes in order to avoid obstructing strainers,drain and wash jets. 2. Ware that is encrusted with soil should be presoaked prior tobeing placed in the machine. 3. When placing dishes into the rac...

Page 10 - PC BOARD

PC BOARD 7 Scroll Down Scroll Up Enter Red lights will illuminate when the corresponding output signal is “on”. For use only in the engineering/programming mode only Green LED Display Contrast Adjuster. Turn clockwise to adjust thebrightness of the display. It will not unscrew. When it reach-es the ...

Page 11 - TROUBLESHOOTING SECTION

WARNING: Inspection, testing and repair of electrical equipment should be performed only by qualified service personnel. Certain procedures in this section require electrical tests or measurements while power is applied to the machine. Exercise extreme caution at all times. If test points are not ea...

Page 12 - SPECIFICATIONS of the JPX-140

PERFORMANCE/CAPABILITIES OPERATING CAPACITY (RACKS/HOUR) RACKS PER HOUR 13 DISHES PER HOUR 91 GLASSES PER HOUR 260 OPERATING CYCLE (SECONDS) WASH TIME 226 RINSE TIME 14 TOTAL CYCLE TIME 240 TANK CAPACITY (GALLONS) WASH TANK 2.8 BOOSTER TANK 1.25 TEMPERATURES WASH---°F (MINIMUM) 150 RINSE---°F (MINIM...

Page 13 - DIMENSIONS of the JPX-140

DIMENSIONS of the JPX-140 10 2 1/2” MIN. WALL CLEARANCE A. 1/2” FNPT 140 B F. WATER CONNECTION B. DRAIN HOSE CONNECTION FOR GRAVITY DRAIN FROM THEUNIT. UNIT SUPPLIED WITH 1” I.D. X 1 1/2” O.D. X 6’-0” LONGFLEXIBLE HOSE. C. ELECTRICAL CONNECTION D. DISPENSER CONNECTION 18” 27 7/8” 11 7/16” 29 7/16” 1...

Page 14 - FRONT ASSEMBLY

ITEM Q T Y DESCRIPTION Mfg. No. 01 1 Door Microswitch with Assembly 2020-162-27-23 02 1 ON/OFF Switch 2020-142-27-10 03 1 Mode Switch 2020-142-27-11 04 1 Ready Light 2020-142-27-18 05 1 Metal Facia Plate for Switches 2020-142-67-95 06 1 Black Plastic Top Panel 2020-142-27-34 07 1 Wash Gauge 2020-142...

Page 15 - ELECTRICAL PANEL

ITEM Q T Y DESCRIPTION Mfg. No. 01 1 Contactor, 240V 2020-142-28-54 02 1 Contactor, 240V 2020-142-28-54 03 1 Contactor, 240V 2020-142-28-54 04 1 Relay, 240V, 4 Pin 2020-142-28-50 05 1 Relay, 240V, 5 Pin 2020-142-28-51 06 1 Relay, 240V, 4 Pin 2020-142-28-50 07 1 Timer, 2 Minute 2020-142-27-06 07 1 Ti...

Page 16 - FRONT AND BOTTOM VIEW

FRONT AND BOTTOM VIEW 13 02 03 01 04 0 5 06 0 7 08 09 10 1 2 1 3 1 4 11 15 1 6 1 7 18 19 11 21 20 22 23 25 0 6 26 1 92 40 92 8 2 4 2 7 24 01 07 09 10 JPX 140

Page 18 - WASH ARM/RINSE ARM ASSEMBLIES

WASH ARM/RINSE ARM ASSEMBLIES 15 01 02 0 3 04 0 7 08 09 29 30 31 10 2 6 25 24 14 1 3 06 21 22 23 28 27 05 11 12 15 16 17 18 19 20 14 JPX 140

Page 20 - INSIDE TUB VIEW

ITEM Q T Y DESCRIPTION Mfg. No. 01 1 Elbow Assembly 2020-162-26-46 02 1 Spacer, Bottom Spindle 2020-162-26-69 03 1 Spindle 2020-142-26-68 04 1 Bottom Boss Assembly 2020-202-26-53 05 1 O-Ring 2020-162-27-83 06 1 Base, Wash Filter 2020-142-27-87 07 1 Tube, Transfer 2020-142-26-51 08 1 Air Bell Assembl...

Page 21 - REAR VIEW

ITEM Q T Y DESCRIPTION Mfg. No. 01 2 Conduit Connector 2020-142-68-81 02 1 Hose, 4-6 mm 2020-142-68-82 03 1 Water Inlet Hose 2020-162-27-84 04 1 Hose, 4-6 mm 2020-142-68-82 05 1 Drain Elbow 2020-142-26-96 06 1 Gray Drain Hose 2020-162-28-57 07 1 Waste Hose 2020-142-68-83 08 1 Vacuum Breaker 2020-142...

Page 22 - MISCELLANEOUS

ITEM Q T Y DESCRIPTION Mfg. No. 01 2 Line Stiffener 2020-142-68-09 02 2 Line Weight 2020-142-68-10 03 1 Nut, Cover 2020-142-28-01 04 1 Cover, Rinse Element 2020-142-27-99 05 1 Plate Rack 2020-142-68-11 06 1 Dish Rack 2020-142-68-12 07 1 Catch, Ball Assembly 2020-162-27-31 08 1 Switch, Micro Door Ass...

Page 23 - ELECTRICAL DIAGRAM

JPX-140 ELECTRICAL DIAGRAM 208-240 VOLT, 60 HERTZ, 1 PHASE 20 JPX 140

Page 24 - SPECIFICATIONS of the JPX-160

21 PERFORMANCE/CAPABILITIES OPERATING CAPACITY (RACKS/HOUR) RACKS PER HOUR 24 DISHES PER HOUR 192 GLASSES PER HOUR 600 OPERATING CYCLE (SECONDS) WASH TIME 107 RINSE TIME 14 TOTAL CYCLE TIME 121 TANK CAPACITY (GALLONS) WASH TANK (MINIMUM) 3.4 RINSE TANK 1.4 TEMPERATURES WASH---°F (MINIMUM) 150 RINSE-...

Page 25 - DIMENSIONS of the JPX-160

DIMENSIONS of the JPX-160 22 2 1/2” MIN. WALL CLEARANCE A. 1/2” FNPT 140 B F. WATER CONNECTION B. DRAIN HOSE CONNECTION FOR PUMPED DRAIN FROM THEUNIT. DISCHARGE HEIGHT MUST BE MAINTAINED. UNIT SUP-PLIED WITH 1” I.D. X 1 1/2” O.D. X 6’-0” LONG FLEXIBLE HOSE. C. ELECTRICAL CONNECTION 20” 29 5/8” 13 7/...

Page 37 - COMPONENTS DIAGRAM

Page 38 - SPECIFICATIONS of the JPX-200

35 PERFORMANCE/CAPABILITIES OPERATING CAPACITY (RACKS/HOUR) RACKS PER HOUR 24 DISHES PER HOUR 600 GLASSES PER HOUR 600 OPERATING CYCLE (SECONDS) SHORT CYCLE WASH TIME 105 RINSE TIME 15 TOTAL CYCLE TIME 120 LONG CYCLE WASH TIME 225 RINSE TIME 15 TOTAL CYCLE TIME 240 TANK CAPACITY (GALLONS) WASH TANK ...

Page 39 - DIMENSIONS of the JPX-200

DIMENSIONS of the JPX-200 36 2 1/2” MIN. WALL CLEARANCE A. 1/2” FNPT 140 B F. WATER CONNECTION B. DRAIN HOSE CONNECTION FOR PUMPED DRAIN FROM THEUNIT. DISCHARGE HEIGHT MUST BE MAINTAINED. UNIT SUP-PLIED WITH 1” I.D. X 1 1/2” O.D. X 6’-0” LONG FLEXIBLE HOSE. C. ELECTRICAL CONNECTION 23 3/4” 32 1/4” 1...

Page 40 - MAIN ASSEMBLY

ITEM Q T Y DESCRIPTION Mfg. No. 01 1 Top Panel 2020-202-26-23 02 1 Power Switch 2020-142-27-10 03 1 Mode Switch 2020-162-27-12 04 1 Slow/Fast Switch 2020-202-27-15 05 1 Drain Switch 2020-162-27-14 06 1 Visual Display 2020-162-28-55 07 1 Metal Facia for Switches 2020-202-26-27 08 1 Door Handle 2020-1...