Jackson 999-215 - Manuals

5.2 Locate your throttle cable bracket that is boltedto your standard intake manifold and remove thethrottle cable by loosening the pinch nuts surround-ing the cable end on either side of the bracket.Once the nuts are loose, you can pull the cable outof the bracket - the grommet will deform and let ...

not back towards it. Continue the hose across theengine side of the radiator and under the upperradiator hose. Using the Ty-Wrapp straps provid-ed, attach the rubber hose securely to the fanshroud supports near the fan motor(s). Attach theend of the hose to the Brass Elbow fitting attachedto the bot...

power steering bracket to attach your lower bracketto, you will use special bracketry that we haveincluded with your kit. Turn to figure 3.4 in theinstallation manual and find the note describing thebolt that will be used for the non-power steeringcar’s lower strap bracket anchor. The Mazda idlerpul...

9.1 Locate the rubber sleeves and the front crossover pipe. Check inside the cross over pipe fordebris and clean it out if necessary. Install the crossover tube between the idle air manifold (dummythrottle body now on the intake manifold) and thesupercharger manifold. If you find the outlet rubbersl...

9.7 IDLE ADJUSTMENT: Restart your engine. Using the idle air screw onyour throttle body (now on the back of the super-charger), adjust your idle speed to 950 rpm afterthe engine is warm. This is done by backing theadjustment screw out a half turn at a time until thecorrect speed is achieved (counter...