Ingersoll Rand 2000 - Manuals

Ingersoll Rand 2000 – Manual in PDF format online.

Manuals:

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72

Summary

Page 2 - ADDITIONAL REFERENCES; INSTALLATION; SELECTING A LOCATION; MOUNTING

2 For maintaining the receiver tank or system air pressure withinpredetermined limits, the compressor may be operated with automaticstart & stop control or constant speed control regulation. The type ofregulation used depends upon the application. ADDITIONAL REFERENCES Unless otherwise stated, d...

Page 3 - INSTALLING REMOTE AIR INLET PIPING; INSTALLING DISCHARGE PIPING

3 To mount the unit, use the following procedure: 1. Mark the location of the mounting holes. 2. Drill 2-1/4" deep holes using a concrete drill bit sized per thefollowing table. Tank Size Drill Bit (Gal.) Size 120 1/2" 240 5/8" NOTE: It may be helpful to use a piece of tape on thedrill b...

Page 5 - LOW OIL LEVEL SWITCH; OPERATION; INTERMITTENT DUTY FORMULA; COMPRESSOR CONTROLS

5 LOW OIL LEVEL SWITCH A float activated low oil level switch may be installed to protect yourunit against damage due to insufficient compressor oil level. Low oillevel in the compressor crankcase causes the switch contacts toopen, thus shutting the unit down until the proper oil level has beenresto...

Ingersoll Rand Manuals