Ingersoll Rand 150BMG - Manuals

6 03524832_ed12 150BMG Series Air and Gas Starters Typical Installation T o rq ue (lb -f t) P o w e r (HP) F lo w (SCF M) Series 150BM and 150BMG Performance Curves 0 20 40 60 80 100 120 25 20 15 10 300 600 900 1200 5 0 0 500 1000 1500 Speed (RPM) 2000 2500 3000 Starter 3BM, 5BM 0-30’ # 12 (3/4 “) S...

03524832_ed12 7 150BMG Series Air and Gas Starters Sectional View 8 9 2 2 5 6 7 10 55 40 14 52 A ir Str a iner 53 51 54 55 39 38 37 36 35 56 34 33 32 1 11 30 31 27 24 23 22 21 19 20 15 19A 18 18A 16 13 12 (Dwg. TPA61-7)

8 03524832_ed12 150BMG Series Air and Gas Starters Exploded View 2 5 18A 15 56 16 18 19A 19 34 21 33 22 23 24 27 30 20 32 31 6 2 1 55 7 9 8 10 13 40 11 39 37 36 35 12 14 55 38 (Dwg. TPA683-2)

10 03524832_ed12 Maintenance Section WARNING Always wear eye protection when operating or performing any maintenance on this Starter.Always turn off the air or Gas supply and disconnect the air supply hose before installing, removing or adjusting any accessory on this Starter or before performing an...

03524832_ed12 11 Inspection of Parts 1. Discard all O-rings and gaskets. These should not be reused.2. Check all grease seals. If they appear worn or distorted, remove them from their parent member and discard. NOTICE Discard any grease seal that was removed during disassembly of the starter. 3. Che...

12 03524832_ed12 12. Set the Front End Plate (39), crescent grooved side fi rst, onto the Cylinder so that the Cylinder Dowel passes through the dowel hole in the End Plate. Make sure that all notches and ports are in alignment. 13. Install the Front Rotor Bearing (37) onto the splined shaft of the ...

03524832_ed12 13 Parts and Maintenance NOTICE The use of other than genuine Ingersoll Rand replacement parts may result in safety hazards, decreased starter performance, and increased maintenance, and may invalidate all warranties. Ingersoll Rand is not responsible for customer modifi cation of star...

www.ingersollrandproducts.com © 2011 Ingersoll Rand