InFocus PRJ-WALLKIT-13 - Manuals

Page 2 - Installation Instructions; DISCLAIMER

PRJ-WALLKIT-13 Installation Instructions 2 Visit the InFocus support site at www.infocus.com/support DISCLAIMER InFocus and its affiliated corporations and subsidiaries (collectively "InFocus"), intend to make this manual accurate and complete. However, InFocus makes no claim that the inform...

Page 3 - LEGEND

Installation Instructions PRJ-WALLKIT-13 Visit the InFocus support site at www.infocus.com/support 3 LEGEND Tighten Fastener Apretar elemento de fijación 留め具を締める Befestigungsteil festziehen 上紧紧固件 Serrez les fixations 旋緊扣件 Serrare il fissaggio 패스너 조이기 Apertar fixador ดึงสายรัดให ้แน่น Loosen Fastener...

Page 4 - TOOLS REQUIRED FOR INSTALLATION; Steel Stud Install; OR; Toggler A8/AF8 anchors

PRJ-WALLKIT-13 Installation Instructions 4 Visit the InFocus support site at www.infocus.com/support TOOLS REQUIRED FOR INSTALLATION PARTS 1/2" - steel stud 7/32" - wood stud 3/8" / 5/16" - concrete 5/32" (included) 1/2" Hardware required, NOT INCLUDED: Steel Stud Install • 4...

Page 5 - Site Requirements; Drywall; FRONT

Installation Instructions PRJ-WALLKIT-13 Visit the InFocus support site at www.infocus.com/support 5 Site Requirements WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! The figure below identifies the minimum requirements for install...

Page 6 - ASSEMBLY AND INSTALLATION; Assembling Wall Plate to Brackets; This step must be taken for; BOTH; single; AND; dual stud installations!; Figure 1

PRJ-WALLKIT-13 Installation Instructions 6 Visit the InFocus support site at www.infocus.com/support ASSEMBLY AND INSTALLATION The PRJ-WALLKIT-13 short throw projector mount is designed to be mounted to solid concrete, hollow concrete block, 2" x 4" wood studs (16" on center), or steel s...

Page 7 - Wood Studs; Installing Short Throw Projector Arm to; Steel Studs; Figure 4

Installation Instructions PRJ-WALLKIT-13 Visit the InFocus support site at www.infocus.com/support 7 Wood Studs 1. Using a stud finder and wall plate/bracket assembly, mark four preliminary mounting holes (dual stud) over center of wood studs, or two mounting holes (single stud) in wall plate. (See ...

Page 8 - Figure 6; Adjusting Projector Mount

PRJ-WALLKIT-13 Installation Instructions 8 Visit the InFocus support site at www.infocus.com/support 4. Holding plastic straps on anchor, pull anchor away from wall until channel rests flush behind wall making sure anchor channel is positioned vertically on stud. (See Figure 6) 5. Slide plastic cap ...

Page 9 - Figure 9; Installing Short Throw Projector Arm to Bracket; Projector arm slots

Installation Instructions PRJ-WALLKIT-13 Visit the InFocus support site at www.infocus.com/support 9 Figure 9 Installing Short Throw Projector Arm to Bracket 1. Attach arm adjust plate (C) to wall plate ensuring that adjust plate tabs fit into notches on wall plate. Insert and slightly tighten one 1...

Page 10 - Projector Installation; Exceeding the weight capacity can result in; Leveling the Projector Arm; Projector

PRJ-WALLKIT-13 Installation Instructions 10 Visit the InFocus support site at www.infocus.com/support Projector Installation WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the weight of the projec...

Page 11 - Adjustments; Height Adjustment; Roll Adjustment; Use a level to make this process easier.

Installation Instructions PRJ-WALLKIT-13 Visit the InFocus support site at www.infocus.com/support 11 Adjustments Height Adjustment 1. Loosen two Phillips screws (one on left, one on right). (See Figure 17) 2. Turn the button head cap screw on top of mount clockwise to raise the mount (counterclockw...

Page 12 - Add Plastic Covers

PRJ-WALLKIT-13 Installation Instructions 12 Visit the InFocus support site at www.infocus.com/support Cable Management (Optional) 1. Route cables/cords from projector through opening on projector arm and route to wall. (See Figure 18) 2. Guide cables/cords from wall end of projector arm upward or do...

Page 16 - InFocus Corporation