Infinity TSS-500OM - Manuals

Page 2 - ii; CAUTION; RISK OF ELECTRIC SHOCK; MPORTANT

ii TSS-500 Read First! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructio...

Page 3 - iii; Table of Contents; WNER

iii TSS-500 ii Important Safety Precautions 1 Introduction 1 Unpacking the System 1 Planning Your System 2 Placement 2 Wall-Mounting the Satellites and Center Channel 4 Center and Satellite Speaker Connections 5 Subwoofer Controls 6 Subwoofer Connections 7 Operation 7 Maintenance and Service 8 Speci...

Page 4 - Infinity Total Solutions

Infinity Total Solutions ™ Infinity Total Solutions continues Infinity’s longstanding commitment to accurate sound reproduction. Our high-quality drivers, precisiondividing networks and rigid, well-braced enclosures combine to deliveruncompromised performance in any multichannel home theater system....

Page 5 - Mounting on Floor Stands; ALL; LACEMENT; Left and Right Front Channels

2 TSS-500 Mounting on Floor Stands Optional TSS-STAND500 floor stands are available, should youprefer to place your TSS-500 satellites on the floor; see yourdealer or visit www.infinitysystems.com for more information.In addition, there is a 1/4"-20 insert in each satellite that allowsthe satell...

Page 7 - Turn Off All Power

4 TSS-500 C ENTER AND S ATELLITE S PEAKER C ONNECTIONS Turn Off All Power After placing the speakers, you are ready to connect your system.First, turn off all audio-system power. Use high-quality speakerwire to make your connections. #18-gauge speaker wire withpolarity coding is included. For longer...

Page 8 - Rear Panel

5 TSS-500 S UBWOOFER C ONTROLS Rear Panel A Few Suggestions We recommend that you do not operate your speakers orsubwoofer with the bass, treble and loudness controls set to full boost. This will place undue strain on your electronics andspeakers and could damage them. The volume control setting on ...

Page 9 - If you have a Dolby

6 TSS-500 S UBWOOFER C ONNECTIONS If your receiver/processor does not contain a Dolby Digital or DTS processor but has asubwoofer output: If you have a Dolby ® Digital or DTS ® receiver/ processor with a low-frequency-effects (LFE) or subwoofer output: SUBWOOFER OR LFE OUTPUT TSS-Sub500/230 RECEIVER...

Page 10 - PERATION; Surround Modes; Power On; Final Positioning; AINTENANCE AND

7 TSS-500 O PERATION Surround Modes When using the TSS-500 in a Dolby Digital or DTS home theatersystem, make sure all speakers are set to “Small”. When using thesystem in a Dolby Pro Logic ® home theater system, make sure the receiver’s center channel mode is set to “Normal.” Some Dolby Digital-equ...

Page 11 - PECIFICATIONS

TSS-500 Satellites Center Channel Frequency Range: 150Hz – 25kHz (±3dB) 150Hz – 25kHz (±3dB) RecommendedAmplifier Power Range: 10 – 100 Watts 10 – 100 Watts Sensitivity: 86dB 87dB (2.83V @ 1 meter) Nominal Impedance: 8 Ω 8 Ω Crossover Frequency: 7kHz 7kHz Midrange Driver(s): 2-1/2" (64mm) Magnet...