Infinity NV30 - Manuals

Fig. 3 Press ASSEMBLY INSTRUCTIONS Attaching the Upper Hose Holder WARNING: Always remove the power plug from the electrical outlet before assembling or removing accessories. 1. Place the upper hose holder into the slot in the back of the vacuum. (Fig. 4) 2. Using a Philips screwdriver and the screw...

Fig. 10 Press OPERATING INSTRUCTIONS Attaching the Accessories 5 The accessories can be attached either to the handle or to the telescopic wand. To attach the accessories to the handle : 1. Press the handle locking pin and pull the handle up to remove it from the telescopic wand. (Fig. 8) 2. Push th...

Fig. 15 OPERATING INSTRUCTIONS How to Adjust for Carpet HeightWARNING : To avoid injury, keep loose clothing, hair, fingers and all other parts of body away from any moving parts (such as the beater brush). Turn off the switch and unplug the vacuum before adjusting the vacuum for the carpet height.T...

MAINTENANCE INSTRUCTIONS 7 Separating the Dust Cup from the Cyclonic Chamber 1. Remove the dust cup assembly.2. While holding the dust cup assembly, twist the carrying handle counter clockwise to separate the cyclonic chamber from the dust cup. (Fig. 22, Fig. 23) Fig. 22 Fig. 23 Fig. 24 Fig. 25 Debr...

MAINTENANCE INSTRUCTIONS Note: Occasionally the filter indicator light will flash momentarily if the air path is blocked when using the above floor tools. This is normal. Cleaning Pre-Motor Filters Under normal use, the 2 filters in the filter housing should be cleaned every three (3) to five (5) mo...

Removing & Cleaning the Lifetime Washable HEPA Filter Under normal use, the HEPA filter should be tapped cleaned and rinsed once every three (3) years or as needed depending on usage. This is located underneath the filter housing. To remove the HEPA filter: 1. Remove the filter housing.2. Hold t...

TROUBLESHOOTING Clearing Blockages Occasionally the vacuum may become blocked by a build up of debris which will require cleaning. If the filter indicating light is flashing, but the filters have been cleaned recently, check the air paths for blockages. To reduce the risk of electric shock, the powe...

4. Turn the vacuum over again, still keeping it flat and press the carpet-to-floor selector to the carpet position. (Fig. 48) TROUBLESHOOTING Carpet Position Fig. 48 5. Start to lift the power head cover up first from the front and then slide a little to the back and bring it over the carpet-to-floo...

End Cap Tab Fig. 58 Brush Roll End Cap TROUBLESHOOTING Fig. 54 Short Belt Motor Shaft Idler Pulley Brush Roll Pulley Fig. 55 9. To remove the worn or broken long belt from the idler pulley, lift the brush roll and slide it out. (Fig. 53) 13 Fig. 53 16. Check to make sure that both belts are complete...

PROBLEM SOLVING This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily when the cause is found. Therefore, this checklist is provided for your convenience. P R O B L E M P O S ...

Printed in China TWO (2) YEARS LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of two (2) years from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusio...

INSTRUCCIONES IMPORTANTES DE SEGURIDAD Al usar aparatos eléctricos, siempre debe seguir precauciones básicas de seguridad, incluyendo las siguientes: CONSERVE ESTAS INSTRUCCIONES Para Uso Doméstico Solamente 16 Rev. 06/06A Advertencia : Para reducir el riesgo de una descarga eléctrica, este artefact...

MEDIDAS DE PRECAUCIÓN Importante 1. No use la aspiradora cerca de calefactores o radiadores. 2. Antes de enchufar el cable en un tomacorriente, asegúrese de tener las manos secas. 3. No aspire ningún líquido. 4. Mantenga el cabello, la ropa suelta, los dedos y toda parte del cuerpo alejados de las a...

COMPONENTES DE SU ASPIRADORA VERTICAL CICLÓNICA Especificaciones Técnicas Voltaje: 120V, 60Hz. Potencia: 12 Amperes Nota: El dibujo puede no ser igual al producto real. 18 15. Manguera Súper Extensible16. Cabezal Esquinero17. Cabezal para Tapizados18. Accesorio para Tierra19. Botón para Destrabar el...

Fig. 3 Presione INSTRUCCIONES DE ARMADO Colocación del Soporte Superior de ADVERTENCIA : Siempre desenchufe el cable de alimentación del tomacorriente antes de instalar o quitar accesorios. la Manguera 1. Coloque el soporte superior de la manguera en la ranura de la parte posterior de la aspiradora....

+ = Fig. 7 INSTRUCCIONES DE USO Instalación de Accesorios 20 Los accesorios se pueden instalar en el mango o en el tubo telescópico. Para colocar un accesorio en el mango: 1. Presione la clavija de traba del mango yjale del mango haciaarriba para quitarlo del tubo telescópico. (Fig. 8) 2. Inserte el...

Fig. 15 INSTRUCCIONES DE USO Ajuste de la Altura de la AlfombraADVERTENCIA : Para evitar daños, mantenga el cabello, la ropa suelta, los dedos y toda parte del cuerpo alejados de las partes móviles (como el cepillo giratorio). Apague y desenchufe la aspiradora antes de ajustarle la altura de la alfo...

INSTRUCCIONES DE MANTENIMIENTO Separación del Recipiente para la 22 Tierra de la Cámara Ciclónica 1. Quite el recipiente para la tierra.2. Mientras sostiene el recipiente para la tierra, gire el mango en sentido contra horario para desacoplar la cámara ciclónica. (Fig. 22 y Fig. 23) Fig. 22 Fig. 23 ...