Ice-O-Matic ICE250 through ICE2100 SERIES - Manuals

ICE Series Installation Guidelines Page 2 Installation Guidelines For proper operation of the ICE-O-Matic ice machine, the following installation guidelines must be followed. Failure to do so may result in loss of production capacity, premature part failures, and may void all warranties. Reference t...

ICE Series Installation Guidelines Page 3 Secure the machine on top of the bin or dispenser. Attach the ice machine to the bin with the mounting straps provided with the bin or dispenser. If the ice machine is to be mounted on a bin or dispenser other than an ICE-O-Matic, refer to the manufactures i...

ICE Series Remote Condenser Guidelines Page 4 Remote Condenser Installation For proper operation of the ICE-O-Matic ice machine, the following installation guidelines must be followed. Failure to do so may result in loss of production capacity, premature part failure, and may void all warranties. Re...

ICE Series Remote Condenser Guidelines Page 5 The ICE0500R 3 , ICE0606R 3 , ICE806R 3 , ICE1006R 3 , ICE1606HR 3 and ICE1506R 2 Remote ice makers incorporate the mixing valve in the condenser. This configuration allows up to a 100 foot calculated remote line set run. Reference the diagram below to c...

ICE Series Electrical and Plumbing Requirements Page 6 Electrical and Plumbing Requirements : ICEU150, 220, 225 and 226 Note: The ICEU150, 220, 225 and 226 do not have a splash curtain. These models utilize a thermostatic bin control in place of a mechanical bin switch.

ICE Series Electrical and Plumbing Requirements Page 7 Electrical and Plumbing Requirements : ICEU300 Note: The ICEU300 Series do not have a splash curtain. This models utilize a thermostatic bin control in place of a mechanical bin switch

ICE Series Electrical and Plumbing Requirements Page 8 Electrical and Plumbing Requirements: ICE0250, ICE0400, ICE0500 ICE0600

ICE Series Electrical and Plumbing Requirements Page 9 Electrical and Plumbing Requirements: ICE0806 and ICE1006

ICE Series How the ICE Machine Works Page 14 How the ICE Machine Works A general description of how the ICE Series cubers work is given below. With the ICE/OFF/WASH switch in the ICE position, the compressor, water pump and condenser fan motor (when applicable) will energize starting the freeze cycl...

ICE Series Start-Up Procedure Page 15 Start-Up Procedure Before starting the machine, make sure the machine is level within 1/8 inch in all directions, the bin or dispenser leg height can be adjusted by rotating the leg foot. Check the water level in the water trough. It should be approximately ½ in...

ICE Series Start-Up Procedure Page 16 Bin Control Operation The bin control is used to shut the machine off when the bin fills with ice. The bin control must be checked upon installation or initial start-up and when performing maintenance. Adjustments are not covered under warranty. There is one bin...

ICE Series General Maintenance Page 17 Electrical shock and/or injury from moving parts inside this machine can cause serious injury. Disconnect electrical supply to machine prior to performing any adjustments or repairs. Failure to perform the required maintenance at the frequency specified will vo...

ICE Series Winterizing Procedure Page 20 Winterizing Procedures Important! Whenever the ice machine is taken out of operation during the winter months, the procedure below must be performed. Failure to do so may cause serious damage and will void all warranties. 1. Turn off water to machine. 2. Make...

ICE Series Service History Page 21 Service History Model Number__________________Serial Number__________________Date Installed__________ __________________________________________________________________________________________ ________________________________________________________________________...